Analyzing Z370 for Intel's 8th Generation Coffee Lake: A Quick Look at 50+ Motherboards
by Ian Cutress, Anton Shilov, Joe Shields & Gavin Bonshor on October 20, 2017 2:00 PM ESTMSI Z370M Gaming Pro AC
On the Micro-ATX side of things, MSI is bringing two boards to market. The first is the Z370M Gaming Pro AC from the Performance Gaming series.
The Z370M Gaming Pro AC has a black PCB but does not have any added stenciling design on the board itself. The only initial color comes from the red LEDs (which are not RGB) located on the back of the PCB, although an RGB LED strip can be added via the onboard header. The power delivery heatsinks are designed to match the board aesthetic, but again have only a hint of a design on it. The back panel cover has the Gaming Pro name on it and what looks like vents on the inside portion. The chipset heatsink here is also quite small, has the MSI name on it with white accents, and is attached to the motherboard with screws rather than push-pins.
Memory support for the Z370M goes up to 64 GB capacity, with an on-the-box rated speed up to DDR4-4000. There is no memory slot reinforcement, however it does use a double-sided memory latches to secure the memory. The Z370M Gaming Pro AC is equipped with two full-length PCIe slots, for x16/0 or x8/x8 bandwidth from the processor, supporting 2-way SLI and Crossfire. There are also two additional PCIe x1 slots.
Due to the smaller board size, MSI has only placed four SATA ports from the chipset, and in this case all four ports are together in a typical horizontal location. There are two M.2 slots for additional storage, with both of the slots here supporting PCIe 3.0 x4 and SATA drives - the top slot is good for 110mm drives, while the slot between the PCIe lanes is good for 80mm drives.
The Z370M Gaming Pro AC has a total of five 4-pin headers scattered around the board, three in and around the socket area with the other two on the bottom of the board - all the headers support both PWM and voltage control. Networking connections are handled by the Intel I219-V Gigabit controller, with the AC also having an Intel 802.11ac Wi-Fi module. Audio duties are processed by the latest Realtek ALC1220 codec, and we get some PCB separation for the codec to improve signal quality.
The Z370M Gaming Pro AC uses an ASMedia ASM3142 controller for its two USB 3.1 (10 Gbps) ports: one Type-A and one Type-C on the back panel, plus an additional onboard header. On the rear panel there are another four USB 3.1 (5 Gbps) ports, but no USB 2.0 ports. The remainder of the back panel IO has the Intel AC8265 Wi-Fi adapter, two PS/2 ports, DisplayPort and HDMI video outputs, the Intel I219-V network port, and the audio jacks from the ALC1220 plus SPDIF.
| MSI Z370M Gaming Pro AC | |
| Warranty Period | 3 Years |
| Product Page | Link |
| Price | Amazon US |
| Size | Micro-ATX |
| CPU Interface | LGA1151 |
| Chipset | Intel Z370 Express |
| Memory Slots (DDR4) | Four DDR4 Supporting 64GB Dual Channel Support DDR4 4000+ |
| Network Connectivity | 1 x Intel I219-V 1 x Intel AC8265 Wi-Fi + Bluetooth |
| Onboard Audio | Realtek ALC1220 |
| PCIe from CPU | 2 x PCIe 3.0 x16 slots @ x16 / x8 |
| PCIe from Chipset | 2 x PCIe 3.0 x1 slots |
| Onboard SATA | 4 x Supporting RAID 0/1/5/10 |
| Onboard SATA Express | None |
| Onboard M.2 | 2 x PCIe 3.0 x4 - NVMe or SATA |
| Onboard U.2 | None |
| USB 3.1 (10 Gbps) | 1 x Rear Panel Type-C 1 x Rear Panel Type-A 1 x Onboard Header From ASMedia ASM3142 |
| USB 3.1 (5 Gbps) | 4 x Rear Panel 2 x Headers |
| USB 2.0 | 2 x Headers |
| Power Connectors | 1 x 24-pin EATX 1 x 8-pin ATX 12V |
| Fan Headers | 1 x 4-pin CPU 1 x 4-pin Waterpump 3 x 4-pin System Fan (All PWM or Voltage controlled) |
| IO Panel | 2 x Antenna connectors 1 x PS/2 keyboard 1 x PS/2 /mouse 1 x DisplayPort 1 x HDMI 1 x USB 3.1 Type-A 1 x USB 3.1 Type-C 4 x USB 3.1 Type-A (5 Gbps) 1 x LAN (RJ45) port 5 x Audio Jacks + SPDIF |
Facebook
Twitter
RSS
83 Comments
View All Comments
sor - Friday, October 20, 2017 - link
Damn. At least key it differently and call it LGA1151v2 or something.The changes are so minimal it really does seem like planned obsolescence. Does it really need more power pins to support new chips with the same power envelopes? Really? They couldn’t handle that on the CPU PCB?
KaarlisK - Saturday, October 21, 2017 - link
Actually it is ~1.5 times peak current with the same average power envelope, so yes, they need the change.If they had not brought the launch forward and just launched together with the cheap chipsets, there would be far less complaints.
sor - Saturday, October 21, 2017 - link
Where did you find information indicating current has increased 50%? I just spent about ten minutes trying to find a reference backing that up, perhaps something indicating the 8 series operates at a much lower voltage within same TDP, which would translate to higher current but they seem to operate in the same 1.2-1.3v range.You’re not just assuming they draw more current because they have two more cores, are you?
KaarlisK - Sunday, October 22, 2017 - link
Notice the difference between average and peak.And the information is in publicly available documents. I did not bother to look it up, but others have, for example: https://forum.beyond3d.com/threads/intel-coffee-la...
Crono - Saturday, October 21, 2017 - link
Nice roundup. That's a lot of motherboards to spec and summarize. I especially appreciate the handy chart at the end, it's a good, quick-and-dirty comparison tool.Landcross - Saturday, October 21, 2017 - link
You guys forgot 2 new Z370 boards from Supermicro :)https://motherboarddb.com/motherboards/?chipset=19...
Xpl1c1t - Sunday, October 22, 2017 - link
The mITX board looks incredible.+ Low ESR Tantalum capacitors! (first time seeing them on VRM duty on a mainboard)
+ HDMI 2.0
+ 2x M.2 Slots
+ USB 3.1 Type C
+ Optical SPDIF
- RGB.......
MadAd - Saturday, October 21, 2017 - link
Great write up but for me its just another depressing generation of oversized, overpriced ATX form factor offerings on which the vast majority of users wont even plug a second gpu into, with the smaller and more size appropriate FF represented as a minority afterthought.With all the progress of PCs since the 90s whod have thought that I could still use the same ATX case today while every single other component (from floppy drives to 2d Mattrox cards) have long gone to the recyclers. I find it so annoying how manufacturers have stuck on this prehistoric gargantuan case size with the other sizes being an afterthought. It feels like like stifled innovation while everything else is moving on.
rocky12345 - Saturday, October 21, 2017 - link
Great article and a lot of work put in to get it out for us to read thank you.My only issue is and it is nit your fault is why these companies feel the need to totally blanket the market with basically the same boards just a different model number and basically a few tiny changes and spray paint it a different color and use the word gaming and put something x or x1 or k,k3 etc etc. For crap sakes just release three models not 7-10 models of the same crap it is pretty much just greed I guess.
The whole market is like this now with anything computer related of and if it has the words GAMING or RGB in it's got to be good for sure. My fav is that gaming mouse pad next it will have RGB lighting in it...lol
CitizenZer0 - Wednesday, October 25, 2017 - link
Agreed