Total War: Attila

The second strategy game in our benchmark suite, Total War: Attila is the latest game in the Total War franchise. Total War games have traditionally been a mix of CPU and GPU bottlenecks, so it takes a good system on both ends of the equation to do well here. In this case the game comes with a built-in benchmark that plays out over a large area with a fortress in the middle, making it a good GPU stress test.

Total War: Attila - 3840x2160 - Max Quality + Perf Shadows

Total War: Attila - 3840x2160 - Quality + Perf Shadows

Total War: Attila - 2560x1440 - Max Quality + Perf Shadows

Attila is the third win in a row for AMD at 4K. Here the R9 Fury X beats the GTX 980 Ti by 5% at the Max quality setting. However as this benchmark is very forward looking (read: ridiculously GPU intensive), the actual performance at 4K Max isn’t very good. No single GPU card can average 30fps here, and framerates will easily dip below 20fps. Since this is a strategy game we don’t have the same high bar for performance requirements, but sub-30fps still won’t cut it.

In which case we have to either compromise on quality or resolution, and in either case AMD’s lead dissolves. At 4K Quality and 1440p Max, the R9 Fury X trails the GTX 980 Ti by 8% and 3% respectively. And actually the 1440p results are still a good showing, but given AMD’s push for 4K, to lose to the GTX 980 Ti by more at the resolution they favor is a bit embarrassing.

Meanwhile, Atilla has always seemed to love pushing shaders more than anything else, so it comes as no great surprise that this game is a strong showing for the R9 Fury X relative to its predecessor. The performance gains at 4K are a consistent 52%, right at the top-end of our performance expectation window, and a bit smaller (but still impressive) 43% at 1440p.

Far Cry 4 GRID Autosport
Comments Locked

458 Comments

View All Comments

  • just4U - Saturday, July 4, 2015 - link

    I thought it was great as well.. It had a lot more meat to it then I was expecting. Ryan might have been late to the party but he's getting more feedback than most other sites on his review so that shows that it was highly anticipated.
  • B3an - Saturday, July 4, 2015 - link

    I don't understand why the Fury X doesn't perform better... It's specs are considerably better than a 290X/390X and it's memory bandwidth is far higher than any other card out there... yet it still can't beat the 980 Ti and should also be faster than it already is compared to the 290X. It just doesn't make sense.
  • just4U - Saturday, July 4, 2015 - link

    Early drivers and perhaps the change over into a new form of memory tech has a bit of a tech curve that isn't fully realized yet.
  • Oxford Guy - Saturday, July 4, 2015 - link

    Perhaps DX11 is holding it back. As far as I understand it, Maxwell is more optimized for DX11 than AMD's cards are. AMD really should have sponsored a game engine or something so that there would have been a DX12 title available for benchmarkers with this card's launch.
  • dominopourous - Saturday, July 4, 2015 - link

    Great stuff. Can we get a benchmarks with these cards overclocked? I'm thinking the 980 Ti and the Titan X will scale much better with overclocking compared to Fury X.
  • Mark_gb - Saturday, July 4, 2015 - link

    Great review. With 1 exception.

    Once again, the 400 AMP number is tossed around as how much power the Fury X can handle. But think about that for one second. Even a EVGA SuperNOVA 1600 G2 Power Supply is extreme overkill for a system with a single Fury X in it, and its +12V rail only provides 133.3 amps.

    That 400 AMP number is wrong. Very wrong. It should be 400 watts. Push 400 Amps into a Fury X and it most likely would literally explode. I would not want to be anywhere near that event.
  • AngelOfTheAbyss - Saturday, July 4, 2015 - link

    The operating voltage of the Fury chip is probably around 1V, so 400A sounds correct (1V*400A = 400W).
  • meacupla - Saturday, July 4, 2015 - link

    okay, see, it's not 12V * 400A = 4800W. It's 1V (or around 1V) * 400A = 400W
    4800W would trip most 115VAC circuit breakers, as that would be 41A on 115VAC, before you even start accounting for conversion losses.
  • bugsy1339 - Saturday, July 4, 2015 - link

    Anyone hear about Nvidia lowering thier graphics quality to get a higher frame rate in reviews vs Fury? Reference is semi accurate forum 7/3 (Nvidia reduces IQ to boost performance on 980TI? )
  • sa365 - Sunday, July 5, 2015 - link

    I too would like to know more re:bugsy1939 comment.

    Have Nvidia been caught out with lower IQ levels forced in the driver?

Log in

Don't have an account? Sign up now