Conclusion

Samsung’s Exynos 7420 is a major stepping stone for Samsung LSI. While on a functional and IP basis the chipset hasn’t seen substantial differentiation from its predecessor, it’s on the actual physical implementation and manufacturing process that the new SoC has raised the bar.

On the CPU side of things, we saw some performance improvements due to slightly higher clocks and what seems to be a better cache implementation, especially the big CPU cluster. Equally on the big cluster Samsung has played it safe and has gone for power efficiency rather than aiming for maximum achievable clocks. ARM’s Cortex A57 in the Exynos 5433 was already overshooting performance over its direct competitor, the Snapdragon 805, so there was no need for the Exynos 7420 to push the clocks much higher. And this is a good design decision for the new SoC as both maximum power as well as power efficiency have improved by a lot. With the new part now using 35-45% less power at equal frequencies it now has the required TDP and efficiency to be placed in thin smartphones such as the Galaxy S6.

I think Samsung could have even gotten away in performance benchmarks by keeping the chip at up to only 1.9GHz to keep power consumption below the 1W per core mark. This would have slightly improved efficiency on high loads as the small 10% performance degradation would have been worth the 26% power improvement.

In the review of the Exynos 5433 I was very up front about my disappointment with that SoC’s software and power management as it showed very little optimization and the degradation in real-world use-cases was measurable. This time around, it seems Samsung Electronics did a better job at properly configuring the scaling parameters of the SoC’s power management. Gone are the odd misconfigurations, and with them also most of the inefficient behaviors that we were able to measure on the big.LITTLE SoC’s predecessor. While there’s still plenty of room for improvement such as an eventual upgrade to an energy-aware scheduler, it currently does the job in a satisfactory way.

On the GPU side of things we saw sort of a two-sided story; The good side is that the Exynos 7420’s Mali T760MP8 combined with the 14nm process not only makes this the fastest SoC we’ve seen in a smartphone but also currently the most efficient one that we measured. The bad side of the story is that while it’s the most efficient SoC, the performance and power again overshoots the sustainable TDP of the phone as it will inevitably thermal throttle to lower frequency states during active usage. Over the last few generations this issue grew worse and worse as semiconductor vendors and OEMs tried to boost their competitive position in benchmark scoreboards.

While for the CPU there are real-world uses and performance advantages of having overdrive frequencies above the sustainable TDP, one cannot say the same for the GPU. Samsung is not alone here in this practice as also Qualcomm and many others employ overpowered configurations that make no sense in the devices they ship in. Having a reasonably balanced SoC has become more of the exception than the rule. One can argue that these are high-performance designs that are also meant to also go into tablets and larger form-factors, and SoC vendors should subsequently not be at the ones at receiving end of the blame – it would then be the OEM’s responsibility to properly configure and limit power via software when using the parts in smaller devices. Ultimately, I’d like to see this practice go away as it brings only disadvantages to the end-consumer and leads to an inconsistent gaming experience with reduced battery life.

The Galaxy S6 with the Exynos 7420 is among the first wave of devices to feature LPDDR4 memory. While the performance improvement was nothing ground-breaking, with the boost coming at an average 18-20% in GFXBench, it’s mostly the efficiency that should have the biggest impact on a device’s experience. While I wasn’t able to fully quantize this advantage during measurement due to the complexity of the task, the theoretical gains show that improvements in daily use-cases should be substantial.

Overall, the big question is how good the Exynos 7420 finally is. The verdict on a SoC vastly depends on the competing alternative options available at the time. For the better part of 2015 this will most likely be Qualcomm’s Snapdragon 810 and to a lesser part the Snapdragon 808. In this piece I was already able to show GPU numbers of the S810 and the results unfortunately showed no improvement over the Snapdragon 805, which the Exynos 7420 already beats both in performance and power. While I already have CPU numbers for the 810, we weren’t quite ready to include these in this piece as they’ll warrant a more in-depth look in a separate article. Readers who have already read our review of the HTC M9 will already know what to expect as the SoC just wasn’t able to perform as promised, and I can confirm that the efficiency disadvantage relative to the Exynos 7420 is significant.

Ultimately, this leaves the Exynos 7420 without real competition. Samsung was able to hit it out of the park with the new 14nm design and subsequently leapfrogged competing solutions. For the near future, the Exynos 7420 comfortably stands alone above other Android-targeted designs as it sets the new benchmark for what a 2015 SoC should be.

GPU & LPDDR4 Performance & Power
Comments Locked

114 Comments

View All Comments

  • Someguyperson - Monday, June 29, 2015 - link

    Andrei, your mystery SoC block is most likely a DSP. It makes a lot of sense being next to the audio block in your diagram. DSPs are also used to offload some compute when doing things like music playback and making a call, so it's proximity to the A53 cluster makes sense too.
  • Andrei Frumusanu - Monday, June 29, 2015 - link

    Please do not read too much into where I put the audio block on the diagram, that one was part of the blocks which I couldn't physically locate so I just chose a fitting space where to put it in a logical manner. The top right quadrant and the ISP are *very* abstracted and representative of physical location. All audio is either handled by the A5 itself or by the main CPUs. I'm pretty certain the SoC doesn't have any separate DSP for any task so it most likely is something else.
  • Andrei Frumusanu - Monday, June 29, 2015 - link

    * Non-representative for that matter.
  • tareyza - Monday, June 29, 2015 - link

    Andrei, you mentioned doing some undervolting and modifying some of the GPU frequency states in your article. I found some of the power consumption gains you posted very interesting. Would you recommend that an end user (such as myself) that has a rooted device attempt to do these things? If so, what exactly must be done in order to undervolt? (I'm assuming a custom kernel and/or ROM is required..?)
  • Andrei Frumusanu - Monday, June 29, 2015 - link

    You need to flash a custom kernel on the device. I can't really point out to where you can find such resources due to conflict of interest and myself being active in the modding community, but if you search for it I'm sure you'll be quick to find guides and download links to achieve what you want.
  • Stuka87 - Monday, June 29, 2015 - link

    Top notch article Andrei!
  • syxbit - Monday, June 29, 2015 - link

    Great job. Incredible detail.
    For the SD810 deep dive, I assume you'll be looking at a v2.1.
    I would really like you to cover the important questions of the 810's heat problems, and whether v2.1 really fixes it. It's annoying to see both QCOM's marketing VP pretend that the overheating problems are imaginary, and I don't think anyone really believes that v2.1 completely fixes the problem.
    I'm disappointed that there's just nothing else on the market for OEMs. the OnePlus 2 basically bad no choice. Either a MediaTek, or QCOM. Unfortunately, rumours state that the 2015 Nexus 6 will ship with the now ridiculed SD810 :(
  • Kepe - Monday, June 29, 2015 - link

    At least the SD810 in OnePlus 2 will only be clocked at 1.8GHz max and they use graphene (IIRC) to spread the heat more effectively to the entire back cover of the device. I think I also read the OP2 will have the 2.1 version of SD810. Let's just hope they've done a good job optimizing their firmware and software.
    This article is amazing, I think every smartphone manufacturer should read it, they'd learn a lot. Great job, Andrei. Quite a lot of typos/breaks in thought through a centence unfortunately, you must've stayed up late many a night writing this :p
  • tuxRoller - Monday, June 29, 2015 - link

    All the socs have issues, to varying degrees (hehe), with thermals.
    http://wccftech.com/snapdragon-exynos-atom-a8-benc...

    The 810 is definitely the worst when looking at non-gpu benchmarks.
  • zepi - Monday, June 29, 2015 - link

    I find "overclocking" gpu and cpu both useful for general usage. At least video and picture processing apps that resize/cut/process video and photos can benefit from extra gpu-oomph while actual processing time is still within reasonable times to allow process to complete before thermal limits kick in.

    Ofc, this depends solely on the app and whether it uses GPU processing.

Log in

Don't have an account? Sign up now