The iPhone 6 Review
by Joshua Ho, Brandon Chester, Chris Heinonen & Ryan Smith on September 30, 2014 8:01 AM EST- Posted in
- Smartphones
- Apple
- Mobile
- iPhone 6
Audio Quality
The iPhone 6 is the first non-Android phone to be put onto the Audio Precision APx582 for audio testing. The exact same test tones are used as with Android devices, but they are played back through iTunes at maximum volume. We use the same four static loads as we did with the HTC M8 and Samsung Galaxy S5 for the results you see in the table below.
| 15 Ohm | 33 Ohm | 150 Ohm | 330 Ohm | |
| Dynamic Range | 84.155 dB | 92.281 dB | 92.223 dB | 92.160 dB |
| THD+N | 5.873% | 0.0054% | 0.0032% | 0.0032% |
| Crosstalk (L) | -49.608 dB | -56.239 dB | -71.721 dB | -77.966 dB |
| Crosstalk (R) | -49.831 dB | -56.459 dB | -72.191 dB | -77.983 dB |
| Output Power | 44.04 mW | 26.39 mW | 6.614 mW | 3.072 mW |
| Output Voltage | 812.7 mVrms | 933 mVrms | 997 mVrms | 1,007 mVrms |
| Relative Level (20Hz - 20kHz) | ±0.088 dB | ±0.088 dB | ±0.089 dB | ±0.088 dB |
The first thing to notice is the 15 Ohm load test. At maximum volume, with a -0dBFS signal the amplifier section in the iPhone 6 enters clipping. You can reduce the volume to avoid this, but it does not do as well with really hard loads as the M8 does. You can see the 1kHz sine wave for that below, with the amp clearly clipping at the bottom.
iPhone 6 997 Hz Sine Wave 0dBFS, 15 Ohm Load
For most testing I focus on the 33 Ohm load, as most in-ear headphones have a rated impedance around 32 Ohms. A data comparison to the HTC M8 and the Galaxy S5 is in the chart with the S5 as the clear loser.
| HTC M8 | iPhone 6 | Galaxy S5 | |
| Dynamic Range | 92.074 dB | 92.281 dB | 91.921 dB |
| THD+N | 0.0152% | 0.0054% | 0.0505% |
| Crosstalk (L) | -64.780 dB | -56.239 dB | -44.767 dB |
| Crosstalk (R) | -64.329 dB | -56.459 dB | -44.804 dB |
| Output Power | 47.63 mW | 26.39 mW | 10.63 mW |
| Output Voltage | 1.254 Vrms | 933 mVrms | 592.4 mVrms |
| Relative Level (20Hz - 20kHz) | ±0.664 dB | ±0.088 dB | ±0.081 dB |
Compared to the M8 the iPhone 6 isn’t quite as powerful, but it has lower THD+N and a much better relative level. The relative level isn’t a big deal, as a variation of 0.5dB is unlikely to be heard by most. That the THD+N is 1/3rd the value of that on the HTC M8 is more important, as the FFT below shows a very low noise floor on the iPhone 6 when compared to the one in for the M8.
iPhone 6 997Hz 0dBFS Sine Wave FFT
HTC M8 997Hz 0dBFS Sine Wave FFT
The crosstalk is also lower on the HTC, which is an area the iPhone 6 could certainly improve in. Digging into more depth on the THD+N results provides a bit more context. The HTC M8 has THD+N levels that start at 0.03% but after 2kHz it begins a steady rise up to 0.1% at 10kHz and past 0.2% at 20kHz. In contrast, the iPhone 6 THD+N is 0.03% until 500Hz, rises up to 0.06% at 5kHz, then back down to 0.03% at 9kHz, and peaks at 0.1% by 20kHz. The iPhone 6 will have slightly more midrange distortion but less treble distortion.
iPhone 6 THD+N Ratio Frequency Sweep
HTC M8 THD+N Ratio Frequency Sweep
If we leave noise out of it and look only at distortion then the iPhone 6 does even better. It has a distortion level of -95dB out to 10kHz and then it rises up to -82dB at 20kHz. The HTC M8 begins at -77dB for 20Hz, falls to -95dB until 2kHz, and then rises up to -56dB by 20kHz. The bass and midrange distortion is about equal, but the HTC M8 has far more distortion in the treble.
iPhone 6 Distortion (Noise) Frequency Sweep
HTC M8 Distortion (Noise) Frequency Sweep
Is one phone superior to the other? With the iPhone 6 and M8, I don’t believe so. The M8 is more powerful with lower crosstalk while the iPhone 6 has less distortion and better frequency response. Most notably the iPhone 6 has no results that indicate odd behavior, which we have seen with the Galaxy S5 and other phones. It is a well engineered headphone amplifier provided you do not need to listen to something at maximum volume with a 15 Ohm load.
Can Apple improve this? They could improve crosstalk, though some headphone companies like more crosstalk to help create an image more like a pair of stereo speakers than headphones. They could also support 24-bit audio which can improve on the SNR values here. The test tones are only 16-bit in nature, so the SNR maximum value is around -98dB. The HTC M8 may perform better given 24-bit test tones but would need a retest to verify this. Apple seems to have decided on using Lightning with an external DAC to push beyond 16-bit audio so we will have to wait for devices using that to see.
Audio hardware on phones can still improve a lot to get closer to where the best stand-alone products are. Those are capable of Signal-to-Noise ratios of -120dB or greater, and crosstalk of -110dB or more. How much those would be audible with headphones is uncertain, but when used as a source device with a stereo it may be audible. However, unless high-resolution audio downloads, like Pono or HD Tracks, really start to catch on I don’t see this being a main focus for most of the companies out there. The iPhone 6 is more likely what we will see going forward: good audio quality, but most importantly free of any major issues.
Facebook
Twitter
RSS
531 Comments
View All Comments
bigstrudel - Tuesday, September 30, 2014 - link
Yeah Alpha and Note 4 are frankensteinish. Plastic on the back. Metal on the edge. Glass on the front.No wonder the Note 4 has gaps in the build you can slide a piece of construction paper into.
Samsung needs to go back to what they do best: using leftover "polycarbonate" TV scrap to make their devices.
danbob999 - Tuesday, September 30, 2014 - link
Like I said, I agree completely. I don't see any reason for not using plastic.elajt_1 - Friday, October 3, 2014 - link
Metal + glass = heavier, breaks more easily, blocks signals. I would have to say that I like the iOS more than anything I've seen from Android so far tho.cupholder - Wednesday, October 1, 2014 - link
Protip chuckles: Samsung phones cost more to make than the iPhone. So what point are you trying to make? That you'd prefer a cheap feeling bendable phone?And this is coming from someone with an iPhone 6+. It feels cheap. And it IS cheap.
Kidster3001 - Thursday, October 2, 2014 - link
Plastic is not necessarily crap. I work with all kinds of phones everyday at work, testing them. In our experience iPhones are much more prone to breaking when dropped than are plastic phones. Metal and glass doesn't bounce very well.Wolfpup - Tuesday, September 30, 2014 - link
I think Apple needs to compete in the mid range and low end pricing segments, and they needed to a year or three ago.The lightning connector is defective, these iPhone 6s bend, which is absurd, etc...
I'll defend the resolution though. It's perfectly fine. Android devices just compete on some specs that don't actually matter because there are so many companies directly combating each other.
I think the iWatches LOOK great too for that matter, and they come in 90 billion styles anyway. BUT of course you have to be seriously married to iOS for their to be a point of them...even then, I'm not sure.
Not sure about Google Wear either. I'd really prefer something that can work on it's own. As always, Microsoft was YEARS (a decade?) ahead on this with their spot watches, but everyone acts like Apple invented it LOL.
steven75 - Tuesday, September 30, 2014 - link
I know lots of people with iOS devices and never heard any complaints about the lightning connector. That thing was an incredible improvement over the old 30 pin connector and is head and shoulders above micro USB as well.mrochester - Tuesday, September 30, 2014 - link
Yeah, I love the lighting connector. Micro USB is just horrible in comparison, I can't believe its not even reversible. Come on manufacturers, it's 2014, not 2011!Parhel - Tuesday, September 30, 2014 - link
Me too. I wish the cables were cheaper, but that's about it. Don't see how anyone could call it 'defective'. I've never had a cable or port break. I'm sure it happens, but I've never heard of it happening.Omega215D - Tuesday, September 30, 2014 - link
That's my only issue with the Lightning cable is the price. Though I can find some good ones for a decent price from a reputable manufacturer and is sold in big brick&mortar stores like Best Buy.After using it for the iPod Nano 7th gen I can't go back to the old iPod cables.