Cellular

I stated before that AT&T’s HTC One X is really a One XL, and that the L connotes LTE inside. The reason is that the phone is based around Qualcomm’s MSM8960 which includes the company’s latest and greatest baseband. It’s the same block as what’s in MDM9615 (which we await with bated breath), and again gets 28nm goodness. MSM8960 supports virtually every air interface - CDMA2000 1x/EVDO up to Rev. B (multicarrier), GSM/EDGE, WCDMA (up to DC-HSPA+ Cat.24), TD-SCDMA for China, and of course LTE up to category 3 with 3GPP Release 9. A couple specifications pages erroneously list the One X AT&T as supporting AWS for WCDMA, however the device does not work with T-Mobile WCDMA and the One XL page lists the correct air interface support.

HTC One X AT&T- Network Support
GSM/EDGE Support 850 / 900 / 1800 / 1900 MHz
WCDMA Support 850 / 1900 / 2100 MHz
LTE support 700 MHz (Band 17), AWS (Band 4) - UE Category 3
Baseband Hardware MSM8960 Baseband
HSPA Speeds HSDPA 21.1 (Cat 14) / HSUPA 5.76 (Cat.6)

In the case of the AT&T One X, we’re talking about 5 or 10 MHz FDD-LTE and HSPA+ up to 21.1. Even though the baseband can do multicarrier HSPA+ with ease, AT&T still is only running 16QAM (HSDPA 14.4) in most markets, and 64QAM in some (HSDPA 21.1), though I’ve never ever seen it. The device is limited using some parameters set in build.prop like I’ve seen before:

ro.ril.hsdpa.category=14
ro.ril.hsupa.category=6
ro.ril.hsxpa=4

HSDPA Category 14 corresponds to 21.1 Mbps, and category 6 on the uplink is what everyone is running at maximum right now, at 5.76 Mbps. The FCC filing for the AT&T One X includes note that this is indeed LTE Category 3, and the expected LTE Band 4 and 17 compliance with both 5 and 10 MHz channels.

 

The AT&T One X uses circuit switched fallback (CSFB) to deliver WCDMA 3G voice when in an LTE market, the switch to IMS voice will come later, but for now know that there’s no simultaneous voice and LTE, you hard handover to WCDMA, do the call, then hand back up.


HTC One X AT&T Antenna Locations

One of the first things I usually do on any smartphone that's handed to me is look for Field Test, and on WCDMA/UMTS HTC phones that's usually found through dialing *#*#7262626#*#*. I know that at least one prototype HTC One X (AT&T) model was verified to have field test which launched with that well known dialer code. Unfortunately, all of the HTC Ones have no such field test/engineering menus - I've searched using all the tricks I know and found nothing. That said you can still get LTE RSRP and RSCP under About -> Networks, or from alogcat on the One X AT&T. I would still prefer proper FieldTest with RRC state information, it's unfortunate to see HTC sanitizing release images prior to launch, and I'm not sure what the motivations possibly could be for removing this even on the international variants.

 

To test AT&T LTE on the HTC One X, I drove a total of over 350 miles up to and around Phoenix, AZ, an AT&T 10 MHz FDD market, and ran over 180 tests using the speedtest.net app, which I then exported and made some pretty histograms from. The results are pretty positive, with a few spikes over 60 Mbps - as a reminder the theoretical maximum for 10 MHz FDD-LTE on a UE Category 3 device is 73 Mbps.

Downstream LTE Upstream LTE Latency LTE

AT&T LTE is quite fast, although it is admittedly still nascent and thus not quite as loaded with as many devices as Verizon’s. That said 60+ Mbps tests are always good fun to see without much effort at all. I drove around and spotted a number of LTE base stations in Phoenix, AZ with remote radio heads, which means vastly reduced cable losses.


One of my best AT&T LTE tests

On HSPA+ in my home market, I was able to hit impressive speeds thanks to the combination of both the default LTE “pta” APN for AT&T data, and Rx diversity on the One X.

Downstream HSPA Upstream HSPA Latency HSPA

On HSPA+ I’m able to hit right up near the 14.4 theoretical maximum for single carrier WCDMA with 16 QAM in my market. This is very impressive considering other devices I have routinely get 10–11 Mbps maximum in the same conditions.

GNSS

Like many other Qualcomm based devices, the HTC One X uses the gpsOneGen 8A with GLONASS GNSS system for location. It locks almost instantaneously indoors, and performs great.

The GLONASS behavior of this system is like other QCT systems I’ve seen, wherein it only looks for the GLONASS constellation when GPS SNR is low. You can see these with GPS Test and satellites numbered 65–68.

WiFi

WLAN and BT 4.0 on the HTC One X is courtesy onboard “wcnss_wlan” which I take it means the WiFi baseband onboard MSM8960 with some external RF (WCN3660). What’s interesting to me is that this is the first device I’ve seen that will tune 40 MHz channels on 5 GHz. The full breakdown is as follows - single spatial stream 802.11a/b/g/n with 20 MHz channels on 2.4 GHz, 40 MHz channels on 5 GHz, with all modes supporting the short guard interval rates. That means up to a 72 Mbps rate for 2.4 GHz, and 150 Mbps on 5 GHz. Note that the internal WiFi information screens erroneously report 65 Mbps in all conditions even when the MCS negotiated with an AP is higher.

WiFi Performance

HTC includes the proper band preference tab inside the advanced settings for WiFi, alongside an interesting high performance / higher power checkbox.

I’m not entirely sure what the checkbox does, but the band preference tab (which mirrors that from Galaxy Nexus) works properly. Unsurprisingly the One X posts the highest WLAN throughput I’ve seen from a smartphone to date.

NFC

The One X includes NFC tag and beaming support courtesy the ubiquitous NXP PN544. It works as expected and is exposed in the right way as far as I can tell. I tested both beaming with a Galaxy Nexus and my trusty NFC tag from the Nexus S review.

 

Calls and Speakerphone

Noise suppression on the HTC One X is courtesy an Audience A1028 voice processor, a part we’ve seen a lot of in recent years. The One X again locates a primary microphone at the very bottom, and a secondary microphone at the very top of the device. With these two, the Audience chip can do some DSP and isolate out noise very effectively. I’ve recorded a demonstration the way we normally do just so illustrate, and unsurprisingly it works very well.

HTC One X AT&T - Noise Rejection by AnandTech

Next up, I tested speakerphone volume the same way we always do, using an Extech digital sound data logger placed 3 inches from the device while calling the same ASOS weather station.

Speakerphone Volume - 3 inches Away

The speakerphone on the One X is on the backside and unfortunately lies nearly planar with the surface. Speakerphone volume on the HTC One X is loud enough to be good, but not chart topping.

Display - Infinity Screen Conclusions and Final Thoughts
Comments Locked

137 Comments

View All Comments

  • Stormkroe - Wednesday, May 2, 2012 - link

    The confusion comes from the fact that doubling power to a speaker gains you roughly 3 dB, so a speaker at 600 watts is only around 3 dB louder than the same speaker at 300 watts. Those darned sine waves :)
  • ssddaydream - Saturday, May 5, 2012 - link

    True, but the brain tends to perceive 10dB as twice as loud, even though it is 10X the power.
    I agree that any graphs should be on the dB scale, so that it is easier to judge differences.
  • EarthsDM - Wednesday, May 2, 2012 - link

    Hi Brian, thanks for the review. What pages do you use for the mobile battery life test? Are they mobile formatted? Do they have Flash?
  • Peanutsrevenge - Wednesday, May 2, 2012 - link

    If it wasn't for the lack of removable battery/storage, I would be all over this like a fanboy to Apple, but I would much prefer even a 5mm thicker phone to have those options.

    I need to change batteries roughly once a week around 2-3pm and I'm not sure the added battery life over my Sensation would always see me through.

    The removable storage... I just prefer to have it even though I only occasionally use it.

    Nice review as always though chappies!
  • dcollins - Wednesday, May 2, 2012 - link

    I want this phone so badly. Would an unlocked version work on Verizon's network?
  • Impulses - Wednesday, May 2, 2012 - link

    Absolutely not.
  • ssddaydream - Saturday, May 5, 2012 - link

    ?
    It should be possible with proper hacking. The Rezound can essentially be modified into a world phone, since it has GSM hardware.
    The One X does have the required basebands. It will likely not work at all on T-mobile though.
    Never say never, it is technically possible. I suspect the probability isn't too high, but where would we be today if everybody thought everything was impossible?
  • icrf - Wednesday, May 2, 2012 - link

    "high-end smartphones (I refuse to call them superphones)"

    thank you
  • georgekn3mp - Wednesday, May 2, 2012 - link

    Im still loving my HTC Rezound 6 months later...and wondering why they backpedaled in some ways.
    Rezound has 16GB internal and 16 GB secondary SD and can expand to 80GB with a 64GB card...

    Rezound has true LCD 1280x720, vs. One X SAMOLED...guess that one could be a toss-up to user preferences as both screens are rated top in reviews...especially compared to Pentiles. So it didnt oversaturate colors..thats a good thing.

    Rezound has removable battery and can be upgraded to 2750 extended battery or higher.

    Of course I'd love to know why Anand never published a Rezound review when I know they had said they had one!

    The camera on One X "may" be better but Rezound has an awesome lens too, even if it had issues with white-balance on default settings sometimes. Replacement camera apps seem to resolve that.

    I cant wait to see what ICS does on a OTA upgrade from Verizon...even if it's only Sense 3.5 for Rezound vs Sense 4 on One X it should still have better performance on Rezound on ICS over Rezound on Gingerbread. Alternate ROMS have shown that power...

    On Gingerbread with extended battery I easily get 24 hours battery life, I can only hope ICS isn't worse.

    PLUS HTC has boot unlocker now...
  • dagamer34 - Thursday, May 3, 2012 - link

    The One X has a Super LCD 2 display. The One S has the PenTile screen. Also, I don't think you can get the same structural integrity with a removable battery because that means the back needs to come completely off. The device cannot be made from one piece and needs latches to hold the battery cover.

Log in

Don't have an account? Sign up now