Enermax Liberty Eco 400W


Enermax has refurbished its older but very successful Liberty series and is now calling it the Liberty Eco. There has also been a bit of cost cutting on the components, but according to Enermax the performance is still the same. We had the Liberty in our labs already a little while back and it performed well. The appearance is still the same as Enermax tries to keep the gunmetal finish (the Liberty Eco is rather black) together with the golden fan grille as their corporate identity. The power supply comes with cable management, though note that the pictures are taken from the 500W version.


The inside doesn't really show anything new since it's a typical Enermax layout. The input filtering stage is as in most cases on a small sister PCB located at the AC jack. The primary side carries a Hitachi cap with 330µF and 400V. The heatsinks are rather small but still big enough to handle the heat for such a lower wattage unit.

Enermax brings the only power supply in this roundup with two 6/8-pin PEG connectors, which is great news for low and medium SLI/CrossFire setups. There are five SATA and five Molex connectors on three cable harnesses. Enermax likes to mix the connectors on each harness so that some people need only one harness to power up hard drives and optical drives. The 12V connector comes with 8-pins but splits in half if you only need four of them.

Corsair VX450W - Performance Enermax Liberty Eco 400W - Performance
Comments Locked

39 Comments

View All Comments

  • Martin84a - Monday, January 5, 2009 - link

    I think it says the german and the english site, run things pretty seperately.

    250watt, 16a on the 12v rail that results in a ~300mV ripple. That's a lot. We are not even talking 80% or 100% of its max rated capacity.

    I know that are "allowed" to vary 10% on the 12V rail, but i still think it is a testament to the quality of the PSU. Look at the competetion next to it, nearly straight line.

    I recently had an Antec Truepower 480 watt dying on me. I had it for a little more than 3-4 years. Prior to buying it i did a tons of research. Anandtech also gave it a very good score. Today it is clear that a lot of these has failed, because of some very shitty caps being used. You don't see this in most of the reviews, because they only test if for a day or a week or so. Warranty is a big deal for a lot of people, including myself. I won't buy western digital or maxtor anymore, because i have had too many dying on me, granted they have been running for 3-4 years. Seagate give a 5 year warranty as the only HDD manufactor, so of course i pick them.
    The same with PSU's, I still consider the Seasonic S12II a good PSU, but i would rather pick a PSU with a better warranty.
  • kenyee - Friday, January 2, 2009 - link

    They just don't make them as well as they used to. I bought one of the expensive ones a year ago because it was the quietest around at the time...croaked after a month. Didn't bother sending it back under warranty because I didn't think it was worth it. It also doesn't support older 2.0 systems which I did send it back to them for but they could have told me via email :-P
  • Finraziel - Thursday, January 1, 2009 - link

    Although I understand what you're saying about the 10% load and how no PSU comes close to 80% efficiency there, would it be possible to still post the actual results of the different psus rather than only the rather blunt comparison in the graph? Many systems may not go far below 20% load with these psus, but if you're intent on setting up a very efficient pc it's not that hard to approach or even duck onder 30 watt idle. So in those cases, even though it's not close to 80, it'd still make a big difference wether the efficiency is 50, 60 or 70%...
  • Christoph Katzer - Thursday, January 1, 2009 - link

    Did a small update to the efficiency page. Thanks for the suggestion.
  • sonci - Thursday, January 1, 2009 - link

    So, best PSU regarding efficiency should be ENERMAX Liberty ECO, cause for 24/7 use, you hardly need 50% load..?
  • Christoph Katzer - Thursday, January 1, 2009 - link

    Depends on your system power requirements. There is a difference if you just need 50 watts or 150. Check the power consumption first, then check in which state you are running most of the time and then check which PSU would fit best. From some of the tested units we have separated reviews already where you can check the exact efficiency at a specific load.
  • JonnyDough - Wednesday, December 31, 2008 - link

    You really DO listen to your readers! KUDOS. You're one of the few companies that does.
  • sonci - Wednesday, December 31, 2008 - link

    AnandTech
    Thankyou for your honest work..
    Happy new year!!
  • JeBarr - Wednesday, December 31, 2008 - link

    I can vouch for the S12II 330W and it's ability to run an hd 4850. Originally I had installed the FSP group ZEN 400W fanless, but due to orientation of PSU inside of htpc case did not allow the heatsink to function as designed, so I gave the seasonic a try and have no regrets. It also helps that the rest of my components are low-power, of course.
  • marc1000 - Wednesday, December 31, 2008 - link

    why does akasa products never show on Anandtech?? well, I have one Akasa AK-P300PG (or something like that), it's a 300W unit. I used to power a Pentium-D 945 with a radeon 3850 (now i have a C2D e7200) and it works just fine. silent and stable power. It's a great product that could be included in future reviews.

    by the way: HAPPY NEW YEAR!!! :D

Log in

Don't have an account? Sign up now