Antec TruePower Quattro 1200W
by Jarred Walton on July 7, 2010 6:50 PM ESTRipple and Noise
Up next we want to show you some ripple and noise results for each important rail and load. +3.3V and +5V shouldn’t have more than 50 mV (the same level, because +3.3V is often derived from +5V); +12V should be less than 120 mV. So 1% is the maximum limit. The graphics show peak measurements in the bottom left corner as well as the quantity of conspicuous spikes. We have chosen 20 mV per division. We'll put these on separate pages just to avoid overloading one page.
Ripple and Noise +3.3V
10%
20%
50%
80%
100%
110%
+3.3V is very clean and starts with only 7.9 mV. Even with overload there is not more than 30 mV.
Facebook
Twitter
RSS
29 Comments
View All Comments
Alchemy69 - Wednesday, July 7, 2010 - link
Very silent? Isn't that like a little bit pregnant?computergeek485 - Wednesday, July 7, 2010 - link
haha yea pretty muchshin0bi272 - Wednesday, July 7, 2010 - link
My case has a dual power supply setup... Even running triple or quad SLI I wonder how long it would be before I would need 2 of these. he he heJarredWalton - Thursday, July 8, 2010 - link
Inexpensive Antec PSUs are the same as any other inexpensive PSU: they have to cut some corners. The high-end stuff is generally in a different league.atmartens - Thursday, July 8, 2010 - link
SPCR gives good power supply reviews. The CP-850 and CP-1000 in particular seem to be high quality. The catch is they only fit several Antec cases. In any case, don't just go by brand name.michal1980 - Thursday, July 8, 2010 - link
into a 20amp circuit. Or dont bother having anything else turned on in that room.1200watts, 110% load = 1320 Watts / 84.04% efficent = 1570.68Watts / 120V = 13 amps. Most outlets really only see ~115 volts. Which puts you at 13.65 amps.
Most room circuits are wired at 15amps. Which means with this psu maxed out you have about 230 Watts left over for everything else.
Why?
HOOfan 1 - Thursday, July 8, 2010 - link
Why would you be loading it to 110%?michal1980 - Thursday, July 8, 2010 - link
ok, at 100% your at nealry 12amps.Still darn close to the limit of most circuits at home
Simple put, a 15amp circuit can put out 1800watts.
HOOfan 1 - Thursday, July 8, 2010 - link
But why are you assuming that people would be running the PSU at 110%.That would be the fault of the owner, not the fault of Antec for building a 1200W PSU.
A triple SLi GTX 480 setup would need about a 1200W PSU, although it wouldn't be pulling that much power.
Not a good idea to even run a PSU at 100% for extended time.
Besides, just put the PSU on its own 15A circuit.
Moricon - Friday, July 9, 2010 - link
Ha,here in UK we have 240v Yay us :) 3000w at our disposal.