550W Roundup: Three PSUs at Different Prices
by Martin Kaffei on October 28, 2010 4:00 PM ESTOCZ Voltage Regulation and Quality
| +3.3V regulation | |
| Load | Voltage |
| 10% | 3.39V (+2.72%) |
| 20% | 3.38V (+2.42%) |
| 50% | 3.34V (+1.2%) |
| 80% | 3.30V (0%) |
| 100% | 3.28V (-0.61%) |
| 110% | 3.24V (-0.91%) |
| +5V regulation | |
| Load | Voltage |
| 10% | 5.03V (+0.6%) |
| 20% | 5.02V (+0.4%) |
| 50% | 4.98V (-0.4%) |
| 80% | 4.94V (-1.2%) |
| 100% | 4.91V (-1.8%) |
| 110% | 4.90V (-2%) |
| +12V regulation | |
| Load | Voltage |
| 10% | 12.37V (+3.08%) |
| 20% | 12.34V (+2.83%) |
| 50% | 12.29V (+2.42%) |
| 80% | 12.25V (+2.08%) |
| 100% | 12.21V (+1.75%) |
| 110% | 12.15V (+1.25%) |
+3.3V as well as +12V start very high with +2.7% and +3.1% over the desired value, though this isn't necessarily "bad". +5V starts lower, but there is not much room for the typical drop. Even at 110% overload all rails are still within specification, and +12V never drops below 12.15V, which is nice (particularly if you're pushing an overclock).
Ripple and Noise
| +3.3V ripple quality | |
| Load | Ripple and noise |
| 10% | 14.10mV |
| 20% | 14.40mV |
| 50% | 20.80mV |
| 80% | 21.30mV |
| 100% | 27.90mV |
| 110% | 30.60mV |
| +5V ripple quality | |
| Load | Ripple and noise |
| 10% | 10.60mV |
| 20% | 16.10mV |
| 50% | 19.70mV |
| 80% | 27.10mV |
| 100% | 34.80mV |
| 110% | 40.90mV |
| +12V ripple quality | |
| Load | Ripple and noise |
| 10% | 23.30mV |
| 20% | 31.60mV |
| 50% | 34.40mV |
| 80% | 40.20mV |
| 100% | 55.80mV |
| 110% | 76.10mV |
While the voltage regulation was good, the ripple and noise doesn't fare as well. 40.60mV is close to the 50mV limit on +5V; 76.10mV at +12V is okay but still worse than many other power supplies. The 30mV result on 3.3V is also near the limit. All are still within specification, but there's nothing particularly exceptional here; this is just average performance from any decent PSU.
Facebook
Twitter
RSS
82 Comments
View All Comments
Gonemad - Wednesday, November 3, 2010 - link
I had a Thermaltake ThoughPower (can't remember exact model) that performed fairly for 5 years. It operated non-stop for 1 year in-between that time. I bought it separately from a Thermaltake Case, that had several fans. Worth every dime, both of them.But...
I had to replace an original case fan, so I decided "what t'e hell' and slapped a cheap-o-dozen fan in its place. VERY. BAD. IDEA.
The whole thing worked fine for 6 months, then the ASUS metering software showed steady voltage dropping, curiously on the 3.3V rail as I later found out. Then it alarmed in an intermittent fashion, for no apparent reason, as it got to 10% Low Voltage on that rail.
Guess what? The fan LOCKED, and effectively pushed the PSU to 110% or above (who knows?), FOR FREAKING 6 MONTHS.
THE PSU DIDN´T QUIT ON ME.
As I opened it for regular maintenance (hey, 6 months, remember?) I found the locked fan, and a funny smell that could be felt only very near the PSU vent. You know the smell, don't you? That's the smell of a dying PSU. The fan almost burned my hand when I touched it, proving that the PSU was not at fault; in fact, it performed above and beyond any expectation, and possibly avoided a fire hazard. It was still operational when I removed it, but the smell was ever greater each time it was turned on, even for a few minutes, proving the whole thing had collapsed after all that operating time. The fan didn't short out, which would have triggered any safety (fuse, probably?) on the PSU, it just didn't rotate anymore on its bearings, and became a power drainer on the circuit, eating away the average life-time of the component.
The good PSU purchase decision not only proved a wise decision, it avoided me lots of hassle and grief. The cheap fan, on the other hand, destroyed a perfectly good piece of equipment.
"Caveat Emptor" indeed.
gurboura - Saturday, November 6, 2010 - link
It seems right from the start that you have something against TechSolo, you also talk about how it was loud at almost 30dbA, but yet, the Antec is at 32 and the OCZ tops at 26, still close to that 30dbA level."If you want to have a silent computer, please buy another power supply and protect your ears." Couldn't this have been said the same for the Antec since it was actually louder than the TechSolo?
When doing doing these type of articles your supposed to have an unbiased opinion and its pretty obvious from the start that that wasn't true.