Understanding Spare Area (or Why My 80GB Drive Appears as 74.5GB)

Intel's 80GB X25-M has 80GB of NAND flash on it. That's 85,899,345,920 bytes or 80 x 1024^3 bytes (1024 bytes in a kilobyte x 1024 kilobytes in a megabyte x 1024 megabytes in a gigabyte x 80 gigabytes).

Hard drive makers however assume that 80GB means 80,000,000,000 bytes, since they use the definition of 1GB = 1,000,000,000 bytes. SSD vendors thus use the same definition. Now 80,000,000,000 bytes actually equals 74.5GB, so that's all the space you get to use on the drive.

How much space is there really on the drive? 80GB. How much space does Windows let you use? 74.5GB. What happens to the remaining 5.5GB? It's used by the drive's controller as spare area.

Intel’s controller is dynamic, it uses the entire drive as spare area until you’ve written every LBA once. Then it relies on the remaining 7.5% of non-user-space as its scratch pad. That’s why its new, out of box, performance is so good.

Other controllers may not be quite as dynamic, but they may also take a smaller performance hit when fully used. Why would Intel work so hard to make its out of box performance so high, even when it’ll be short lived? Because of TRIM.

A Wear Leveling Refresher: How Long Will My SSD Last? The Instruction That Changes (almost) Everything: TRIM
POST A COMMENT

295 Comments

View All Comments

  • zodiacfml - Wednesday, September 02, 2009 - link

    Very informative, answered more than anything in my mind. Hope to see this again in the future with these drive capacities around $100. Reply
  • mgrmgr - Wednesday, September 02, 2009 - link

    Any idea if the (mid-Sept release?) OCZ Colossus's internal RAID setup will handle the problem of RAID controllers not being able to pass Windows 7's TRIM command to the SSD array. I'm intent on getting a new Photoshop machine with two SSDs in Raid-0 as soon as Win7 releases, but the word here and elsewhere so far is that RAID will block the TRIM function. Reply
  • kunedog - Wednesday, September 02, 2009 - link

    All the Gen2 X-25M 80GB drives are apparently gone from Newegg . . . so they've marked up the Gen1 drives to $360 (from $230):
    http://www.newegg.com/Product/Product.aspx?Item=N8...">http://www.newegg.com/Product/Product.aspx?Item=N8...

    Unbelievable.
    Reply
  • gfody - Wednesday, September 02, 2009 - link

    What happened to the gen2 160gb on Newegg? For a month the ETA was 9/2 (today) and now it's as if they never had it in the first place. The product page has been removed.

    It's like Newegg are holding the gen2 drives hostage until we buy out their remaining stock of gen1 drives.
    Reply
  • iwodo - Tuesday, September 01, 2009 - link

    I think it acts as a good summary. However someone wrote last time about Intel drive handling Random Read / Write extremely poorly during Sequential Read / Write.

    Has Aanand investigate yet?

    I am hoping next Gen Intel SSD coming in Q2 10 will bring some substantial improvement.
    Reply
  • statik213 - Tuesday, September 01, 2009 - link

    Does the RAID controller propagate TRIM commands to the SSD? Or will having RAID negate TRIM? Reply
  • justaviking - Tuesday, September 01, 2009 - link

    Another great article, Anand! Thanks, and keep them coming.

    If this has already been discussed, I apologize. I'm still exhausted from reading the wonderful article, and have not read all 17 pages of comments.

    On PAGE 3, it talks about the trade-off of larger vs. smaller pages.

    I wonder if it would be feasible to make a hybrid drive, with a portion of the drive using small pages for faster performance when writing small files, and the majority of it being larger pages to keep the management of the drive reasonable.

    Any file could be written anywhere, but the controller would bias small writes to the small pages, and large writes to large files.

    Externally it would appear as a single drive, of course, but deep down in the internals, it would essentially be two drives. Each of the two portions would be tuned for maximum performance in different areas, but able to serve as backup or overflow if the other portion became full or ever got written to too many times.

    Interesting concept? Or a hair brained idea buy an ignorant amateur?
    Reply
  • CList - Tuesday, September 01, 2009 - link

    Great article, wonderful to see insightful, in depth analysis.

    I'd be curious to hear anyone's thoughts on the implications are of running virtual hard disk files on SSD's. I do a lot of work these days on virtual machines, and I'd love to get them feeling more snappy - especially on my laptop which is limited to 4GB of ram.

    For example;
    What would the constant updates of those vmdk (or "vhd") files do to the disk's lifespan?

    If the OS hosting the VM is windows 7, but the virtual machine is WinServer2003 will the TRIM command be used properly?

    Cheers,
    CList
    Reply
  • pcfxer - Tuesday, September 01, 2009 - link

    Great article!

    "It seems that building Pidgin is more CPU than IO bound.."

    Obviously, Mr. Anand doesnt' understand how compilers work ;). Compilers will always be CPU and memory bound, reduce your memory in the computer to say 256MB (or lower) and you'll see what I mean. The levels of recursion necessary to follow the production (grammars that define the language) use up memory but would rarely use the drive unless the OS had terrible resource management. :0.
    Reply
  • CMGuy - Wednesday, September 02, 2009 - link

    While I can't comment on the specifics of software compilers I know that faster disk IO makes a big difference when your performing a full build (compilation and packaging) of software.
    IDEs these days spend a lot their time reading/writing small files (thats a lot of small, random, disk IO) and a good SSD can make a huge difference to this.
    Reply

Log in

Don't have an account? Sign up now