Overclocking/Power Load/Noise

Overclocking these cards was somewhat difficult, as the usual tool that we use (Powerstrip) didn't support the X1900 yet. Instead, we used a program called ATITool to get our overclocks. Unfortunately, we found that ATITool's listed speeds didn't quite indicate actual performance speeds perfectly, so the clock speeds that we were able to achieve yield slightly lower performance on the card. We were, however, able to get a good idea of the overclocking abilities of these cards with this tool. Here are the clock speeds that we achieved:

Overclock speeds
Graphics Card Core (in MHz) Memory (in MHz)
PowerColor X1900 XT 650.7 742.5
Sapphire X1900 XT 664.2 774.0
Sapphire X1900 XTX 688.5 841.5
GeCube X1900 XTX 679.5 801.0
HIS X1900 XTX 697.5 819.0

Splinter Cell Chaos Theory Performance

Splinter Cell Chaos Theory Performance

Splinter Cell Chaos Theory Performance

Splinter Cell Chaos Theory Performance

Splinter Cell Chaos Theory Performance

*Keep in mind that the performance of these overclocked cards was actually a little higher than what these numbers represent.

The first thing we can point out here is that the Sapphire X1900 XT did in fact achieve clock speeds slightly higher than a stock X1900 XTX. This is an important discovery, as it may give pause to those who would be quick to choose an X1900 XTX over the less expensive XT. The fairly large difference in price between the two cards is enough to justify buying the X1900 XT and attempting to clock it up to XTX speeds. It's true that the PowerColor X1900 XT didn't quite get up to XTX speeds (650/775), which indicates that not everyone will have this kind of success overclocking their X1900 XT. However, as the graphs show, the performance of the PowerColor X1900 XT and the reference X1900 XTX are close enough to each other. So, the fact that the PowerColor has a slightly lower clock is unimportant.

Overall, the overclocks varied quite a bit with the different cards. The XTXs in particular all achieved memory clocks very different from one another, with the GeCube X1900 XTX doing the worst. The Sapphire cards seemed to overclock the best, something that isn't very surprising given our experiences with their cards in the past. The GeCube and PowerColor X1900s achieved the lowest overclocks, with our GeCube being particularly finicky (crashing, artifacts, etc.). Bear in mind, however, that many cards of the exact type can overclock very differently from one another, so this might not be the case for all GeCube X1900 XTXs.

Power Load

To test the power load of the card, we measure the total watt usage of our test computer at the wall outlet, recording the power usage of our system in two different states. The first state is with the card installed and the computer at idle, and the second is during intensive performance tests (looped Splinter Cell benchmarks). This doesn't give us an exact power measurement of the card, but it helps us get an idea of the kind of power the card pulls.

Graphics Card Idle Load
PowerColor X1900 XT 146 315
Sapphire X1900 XT 148 316
Sapphire X1900 XTX 151 336
GeCube X1900 XTX 154 337
HIS X1900 XTX 152 330

Interestingly, the X1900 XTs and XTXs drew very similar loads. Of the XTXs, the HIS X1900 XTX drew the smallest amount of power under load, which isn't that surprising given its unique HSF. The Sapphire and GeCube XTXs drew nearly the same amount of power under load. We can see that the X1900 XT does pull a slightly lower load than the XTX, but these are both incredibly power-hungry cards.

Noise

Graphics Card dbl level
PowerColor X1900 XT 52.0
Sapphire X1900 XT 49.6
Sapphire X1900 XTX 50.2
GeCube X1900 XTX 51.4
HIS X1900 XTX 49.5

Again, we see that the HIS X1900 XTX stands out somewhat as being slightly more quiet than the other cards, likely due to the different HSF. All of these cards are a bit noisier than most, but this isn't very surprising given their enormous power. For reference, the noise level of the room with the system off was 40.6 dbl.

PowerColor X1900 XT Test Setup/Performance Tests
Comments Locked

25 Comments

View All Comments

  • yacoub - Wednesday, February 15, 2006 - link

    Sadly I don't think Gigabyte is an ATI partner, but I do hope Sapphire is working on better cooling for the X1900 series. Asus is NVidia but might also make ATI cards? I don't remember. If they try to passively cool it like with their 7800GT they just better do it well enough that it's not roasting itself to death at 70+ degrees Celsius. =/
  • Clauzii - Wednesday, February 15, 2006 - link

    In pro music applications 0.1db is considdered inaudioble but 0.7db - everyone can hear that change - Unless there is a louder component overall in the system.
  • yacoub - Wednesday, February 15, 2006 - link

    49.x db is still ridiculously loud, no matter how much an exponential change it is from 50.x.

    The loudest part in my current rig is around 37db. Claiming 49anything is quiet is RUBBISH and it most certainly is NOT a significant improvement over 50.x db. A slight improvement would be 47db instead of 52 db. A significant improvement would be 42db instead of 52db. A worthwhile improvement would be replacing those terrible fan designs with a Zalman/AC style cooler and offering that stock like Sapphire has in the past.

    Come talk to me when it's at 45-47db at 100% fan speed and I'll be interested in buying it (because I'll drop it to ~20% fanspeed with ATITool like I do my current stock-Zalman-cooled Sapphire X800XL and that'll be close enough to this curent level of quiet to be acceptable.
  • Bull Dog - Wednesday, February 15, 2006 - link

    <^ Broke owner of a Sapphire X1900XT

    "The X1900 is one of those cards that is on just about everyone's wish-list. Those who are lucky enough to own one are probably the envy of their friends and also perhaps became broke from the purchase."
    :)
  • Bull Dog - Wednesday, February 15, 2006 - link

    yo konw we really need an edit function.....Decent not dedcent.

Log in

Don't have an account? Sign up now