Random Read Performance

Our first test of random read performance uses very short bursts of operations issued one at a time with no queuing. The drives are given enough idle time between bursts to yield an overall duty cycle of 20%, so thermal throttling is impossible. Each burst consists of a total of 32MB of 4kB random reads, from a 16GB span of the disk. The total data read is 1GB.

Burst 4kB Random Read (Queue Depth 1)

The burst random read performance from the 8TB Samsung 870 QVO is even worse than the smaller 870s; even though these drives have the full amount of DRAM necessary to hold the logical to physical address mapping tables, there are other significant sources of overhead affecting the higher capacity models.

The Sabrent Rocket Q's burst random read performance doesn't quite fall at the opposite end of the spectrum, but it does clearly offer decent random read latency that is comparable to other drives using the Phison E12(S) controller and not too far behind the NVMe drives using Silicon Motion controllers.

Our sustained random read performance is similar to the random read test from our 2015 test suite: queue depths from 1 to 32 are tested, and the average performance and power efficiency across QD1, QD2 and QD4 are reported as the primary scores. Each queue depth is tested for one minute or 32GB of data transferred, whichever is shorter. After each queue depth is tested, the drive is given up to one minute to cool off so that the higher queue depths are unlikely to be affected by accumulated heat build-up. The individual read operations are again 4kB, and cover a 64GB span of the drive.

Sustained 4kB Random Read

The QLC drives almost all fare poorly on the longer random read test. The Sabrent Rocket Q falls to be the second-slowest NVMe drive in this batch, and a bit slower than Samsung's TLC SATA drives. The 8TB Samsung 870 QVO is no longer the slowest capacity; while it is again a bit slower than the 4TB model, the 1TB 870 QVO takes last place in this test.

Sustained 4kB Random Read (Power Efficiency)
Power Efficiency in MB/s/W Average Power in W

The power efficiency scores are mostly in line with the performance scores, with the slower drives tending to also be less efficient. The QLC drives follow this pattern quite well. The outliers are the particularly efficient Mushkin Helix DRAMless TLC drive, and the enterprise NVMe SSDs that show poor efficiency because they are underutilized by the low queue depths tested here.

The Sabrent Rocket Q shows good performance scaling as queue depths increase during the random read test. The Samsung 870 QVO seems to be approaching saturation past QD16, even though the SATA interface is capable of delivering higher performance.

Random Reads - All Drives
Sabrent Rocket Q 8TB Samsung 870 QVO 8TB

Comparing the 8TB drives against everything else we've tested, neither is breaking new ground. Both drives have power consumption that's on the high side but not at all unprecedented, and random read performance that doesn't push the limits of their respective interfaces.

Random Write Performance

Our test of random write burst performance is structured similarly to the random read burst test, but each burst is only 4MB and the total test length is 128MB. The 4kB random write operations are distributed over a 16GB span of the drive, and the operations are issued one at a time with no queuing.

Burst 4kB Random Write (Queue Depth 1)

The two 8TB drives have opposite results for the burst random write performance test. The 8TB Sabrent Rocket Q it at the top of the chart with excellent SLC cache write latency, while the 8TB Samsung 870 QVO is a bit slower than the smaller capacities and turns in the worst score in this bunch.

As with the sustained random read test, our sustained 4kB random write test runs for up to one minute or 32GB per queue depth, covering a 64GB span of the drive and giving the drive up to 1 minute of idle time between queue depths to allow for write caches to be flushed and for the drive to cool down.

Sustained 4kB Random Write

On the longer random write test, the 8TB Rocket Q is still relying mostly on its SLC cache and continues to hang with the high-end NVMe drives. The 8TB 870 QVO is only slightly slower than the other SATA SSDs, and faster than some of the low-end DRAMless TLC NVMe drives.

Sustained 4kB Random Write (Power Efficiency)
Power Efficiency in MB/s/W Average Power in W

Despite their dramatically different random write performance, the two 8TB QLC drives end up with similar power efficiency that's fairly middle of the road: better than the enterprise drives and the slow DRAMless TLC drives, but clearly worse than the better TLC NVMe drives.

The random write performance of the Rocket Q scales a bit unevenly, but seems to saturate around QD8. Power consumption actually drops after QD4, possibly because the drive is busy enough at that point with random writes that it cuts back on background cleanup work. The Samsung 870 QVO reaches full random write performance at QD4 and steadily maintains that performance through the rest of the test.

Random Writes - All Drives
Sabrent Rocket Q 8TB Samsung 870 QVO 8TB

Unlike on the random read test, the Samsung 870 QVO comes across as having reasonably low power consumption on the random write test, especially at higher queue depths. The Sabrent Rocket Q's power consumption is still clearly on the high side, especially the spike at QD4 where it seemed to be doing a lot of background work instead of just directing writes to the SLC cache.

PCMark 10 Storage Sequential I/O Performance
Comments Locked

150 Comments

View All Comments

  • Kevin G - Friday, December 4, 2020 - link

    At 1 Gbit easily sure, but 2.5 Gbit is taking off in the consumer space and 10 Gbit has been here for awhile but at a price premium. There is also NIC bonding which can increase throughput further if the NAS has multiple active users.
  • TheinsanegamerN - Saturday, December 5, 2020 - link

    A single seagate ironwolf can push over 200MB/s read speeds. 2.5 Gbit will still bottleneck even the most basic raid 5 arrays.
  • heffeque - Friday, December 4, 2020 - link

    I want a silent NAS.
    Also SSD last longer than HDD.
    I'm hoping for a Synology DS620Slim but with AMD Zen inside (like the DS1621+), and I'll fill it up with 4TB QVO drives on SHD1 with BTRFS.
  • david87600 - Friday, December 4, 2020 - link

    Re: SSD lasts longer than HDD:

    Not necessarily. Especially with high volumes of writes. We've had more problems with our SSDs dying than our HDDs. We have several servers but the main application runs on an HDD. We replace our servers every four years but the old servers go into use as backup servers or as client machines. Some of those have been running their HDDs for 15 years now. None of our SSDs have lasted more than 2 years under load.
  • heffeque - Saturday, December 5, 2020 - link

    The Synology DS620Slim is not even near an enterprise server. Trust me, the SSDs won't die from high volume writes on a home user.
  • TheinsanegamerN - Saturday, December 5, 2020 - link

    Completely different use case. Home users fall under more of the WORM style of usage, they are not writing large data sets constantly.

    I also have no clue what you are doing to your poor SSDs. We have our SQL databases serving thousands of users reading and writing daily on SSDs for 3 years now without a single failure. Of course we have enterprise SSDs instead of consumer, so that makes a huge difference.
  • Deicidium369 - Saturday, December 5, 2020 - link

    I have far more dead HDDs than dead SSDs. The 1st SSD I bought was an OCZ midrange, 120GB - that drives has been used continuously for several years - about a year ago, wiped it and checked it - only a few worn cells. On the other hand - I had had terrible luck with anything over 8TB mechanical - out of the close to 300 14TB Seagates - over 10% failure rate - about half of those died during the 48 hour burn in - and the rest soon after.

    The Intel Optane U.2 we used in the Flash array have had no issues at all over the 3 year period - we had one that developed a power connector failure - but no issues with the actual media.

    as with most things tech YMMV
  • GeoffreyA - Sunday, December 6, 2020 - link

    Just a question. Between Seagate and WD, who would you say is worse when it comes to failures? Or are they about the same?
  • Deicidium369 - Sunday, December 6, 2020 - link

    I have not used WD in some time - so I can't comment I tend to use Backblaze failure rates - https://www.backblaze.com/blog/backblaze-hard-driv...
  • GeoffreyA - Monday, December 7, 2020 - link

    Thanks

Log in

Don't have an account? Sign up now