Aspire X-Navigator: A High End Gaming Chassis
by Purav Sanghani on October 26, 2004 12:05 AM EST- Posted in
- Cases/Cooling/PSUs
Cooling
With so much room for adding as many HDDs as current hardware standards will allow, requirements for temperature regulation become even more vital then they have been in the past. It is obvious that a single HDD running at regular operating temperatures along with even hotter-running hardware, like the CPU and VGA card, may require some cooling, like a few case fans, to keep the system running stable. But when adding up to 9 HDDs to a mid-tower case, an extreme amount of cooling hardware is required.Aspire has done a great job of planning the design of the X-Navigator. They considered thermal conditions within an extreme situation like one where more than just a few HDDs would be installed to coexist with today's highest of high end VGA cards and the most powerful CPUs. They have included plenty of case fans to help circulate air in and out of the case, which help cool these components so that they can continue to operate at stable temperatures.
With a total of three 80mm intake fans, a side mounted 120mm and top mounted 80mm exhaust, and the option to add a sixth 80mm fan to the front of the chassis, the X-Navigator is ready for any hardware that we can possibly throw at it.
The front 80mm fan is mounted at the bottom of the case in front of the third drive cage as an intake. It can be seen through the ventilation on the front bezel by its bright LED glow.
Two more intake fans are mounted at the back between the expansion slots and the power supply mounting area.
Click to enlarge.
There are a total of two stock exhaust fans mounted. The first is a 120mm exhaust, which is mounted on the left side panel near the expansion card area on an ATX motherboard. This fan helps alleviate the area as well as the CPU area of warm air.
Click to enlarge.
The second exhaust fan is mounted at the top of the X-Navigator where it would make the most sense. Since heat rises, a top mounted exhaust fan would help warm air escape to the top of the case instead of shutting it in, as many cases without top mounted vents do.
Click to enlarge.
Aspire also generously includes a hefty 500W aluminum power supply, which features a see-through acrylic design to its internal components that are multi-colored for a custom look. We cannot downplay this power supply, since it has such a robust set of features such as a fan speed adjuster, UV sensitive sleeves and connectors on its wiring, as well as blue LED fans to match the other case fans. The unit retails for around $55 at various online stores, which makes up over 1/3 of the X-Navigator's total price!
 Click to enlarge. |
 Click to enlarge. |
Facebook
Twitter
RSS
23 Comments
View All Comments
IcculusBone - Saturday, October 30, 2004 - link
Been reading this site for ages but not big on posting. Wanted to add my input here though since I recently had some experience with this case.My roommate wanted this case for his first custom computer (that I built of course). He got the steel version, without the faceplates and powered by a 450w PSU instead of the upgraded 500w clear one. Also, the fans are a bit different in that the 120mm is on the rear and the window has an 80mm set for intake instead of exhaust. Aside from those points the case is the same as its big brother but can be had for a mere $92 on Newegg.
I have to say, I agree with a lot of what you all have been saying about the "bling" factor, but I was still left with a better impression from the case than I expected. It is under his desk (but still very visible) and from down there you can't hear it at all - even with the fans cranked up. Adding an 80mm in the second drive bay was a good idea as he has 5 drives in the case.
I think this is a really good match for budding enthusiasts because it can be found for fairly cheap on the net, has a decent PSU for a beginner and has lots of the cool things fledgling geeks look for - a full sized window, lots of LED love and tons of room for expansion. One thing though, I need to install a switch for those 4 lights on the front. They are BRIGHT.
- b0n3
TrogdorJW - Wednesday, October 27, 2004 - link
What some case manufacturers really need to do is include a switch to shut off all the extra lighting. It can't be that difficult, and while it might be cool at times to have all the case lights, I would much rather have them off 99% of the time. You could turn them on at a LAN party or to woo a girl (*cough*), but otherwise leave them off.Seems like they should have included some lower RPM fans instead of going for outright cooling, though, and I'm not at all convinced about having the side panel as an exhaust fan. Put intake on the front and the side and exhaust on the rear and top. Fresh, *cool* air blowing directly at the CPU (instead of in opposition to the CPU fan) would make more sense, wouldn't it?
AnnoyedGrunt - Tuesday, October 26, 2004 - link
You guys mentioned in the review that the case has a fan controller, but did you use it at all? Perhpas plugging the 120mm fan into the controller would have reduced the noise quite a bit.In any event, this case looks pretty short on features compared to many other cases (except for the temp display and maybe the fan controller), and seems to try and get by on looks (which is always tough since looks are very subjective).
Also, you guys didn't mention how the firewire and USB connect to the Mobo. Pass thru, or header?
While the review is OK, I think you need to make a more detailed review with less "filler" (the transitional sentences that are somewhat explanatory, but don't really explain anything useful, like "Today we have a chance to look @ one of the most innovative designs in the case industry. Made of all aluminum with room for expandability and much more....."
But really, this case brings nothing new to the case industry, except the interchangeable colow swatches which really don't add much to the value anyway.
Also, on "The Bad" you don't mentione anything about the lack of removable Mobo tray or lack of tooless features, which you mention on many other case reviews.
Overall you guys have the potential to do some great reviews, but I'd like to see a more standard review template and more consistency in the summary.
With that said, thanks and keep the reviews coming.
-D'oh!
Sabresiberian - Tuesday, October 26, 2004 - link
Looks like a nice case :)Biggest thing I would like to see in new cases is support for water (liquid) cooling. I know this is more problematic than adding fans since mainboard and cpu choices make a difference, as well as other choices; but that option is so much more effective and quieter than air cooling!
Aluminum - I don't care about aluminum, I don't need to save a couple of lb. Quality of function is the importance.
I don't care about buying a 'modded-style' case; defeats the purpose! But it wouldn't stop me from buying a case cause its got some blue lights or whatever, either.
I am NOT interested in buying a power supply from a case manufacturer! Especially now, when so many power supplies are coming out with innovations as well as higher power capabilities :)
quanta - Tuesday, October 26, 2004 - link
#1, you can get a version of X-Navigator without PS from Xoxide.com for $100.Not a bad design by itself, but the overall design quality drops comared to X-Superalien, which has tray and extra channel for fans. Too bad neither case has fan filters.
I would buy this case if it were introduced a few months ago, but for around 100 dollars, you can get Thermaltake Xaser V WinGo or Damier. But I would wait for MGE XG Quantum, a clone for Casetek CK-1020-2, which features a 7-channel fan controller.
ciwell - Tuesday, October 26, 2004 - link
Once again people can not get it through their heads that looks are subjective and depend upon the user/purchaser. While one person may think it looks "fugly," another might think it is "stylish."slashbinslashbash - Tuesday, October 26, 2004 - link
#14's right! This is a Dragon case with a different front. The front door lock, power and reset buttons, side panel latch, fan mounts, and drive bays are *identical* to the Dragon tower I bought 2 years ago. Purav, you should at least recognize that all of these cases are the same, and not treat the features like they're something new (e.g., "The door itself has a key lock, which seems like an excellent feature. When we took a look at the locking mechanism on the backside, though, we noticed it was made of plastic, which could easily be broken with some force. Using metal would have definitely improved this design." This very same lock has been on countless previous cases! We've all seen it before! Is AT's case reviewer the only one who hasn't?). Better yet, buy yourself a Dragon, and then you'll know what to look for and be able to recognize "This is a Dragon with an ugly front panel and an extra fan in the top." That would make these reviews a lot easier for you.CitizenKain - Tuesday, October 26, 2004 - link
Wow, another Antex SX1000 series case, but now with added ugly!Tarumam - Tuesday, October 26, 2004 - link
Goodness! Yet another arse-ugly-blinking-lookin´ case. Taste has left the building. Well at least is silent. No? Well, one could use its blue leds to... Oh, well why bother? It is a bad, ugly, noisy, bulky case.EddNog - Tuesday, October 26, 2004 - link
HOW many more Chieftech Dragons with a different front bezel are we going to see, huh?!@#