Gaming Benchmarks

Metro2033

Our first analysis is with the perennial reviewers’ favorite, Metro2033.  It occurs in a lot of reviews for a couple of reasons – it has a very easy to use benchmark GUI that anyone can use, and it is often very GPU limited, at least in single GPU mode.  Metro2033 is a strenuous DX11 benchmark that can challenge most systems that try to run it at any high-end settings.  Developed by 4A Games and released in March 2010, we use the inbuilt DirectX 11 Frontline benchmark to test the hardware at 1440p with full graphical settings.  Results are given as the average frame rate from a second batch of 4 runs, as Metro has a tendency to inflate the scores for the first batch by up to 5%.

Metro 2033 - One 7970, 1440p, Max SettingsMetro 2033 - One 580, 1440p, Max Settings

Dirt 3

Dirt 3 is a rallying video game and the third in the Dirt series of the Colin McRae Rally series, developed and published by Codemasters.  Dirt 3 also falls under the list of ‘games with a handy benchmark mode’.  In previous testing, Dirt 3 has always seemed to love cores, memory, GPUs, PCIe lane bandwidth, everything.  The small issue with Dirt 3 is that depending on the benchmark mode tested, the benchmark launcher is not indicative of game play per se, citing numbers higher than actually observed.  Despite this, the benchmark mode also includes an element of uncertainty, by actually driving a race, rather than a predetermined sequence of events such as Metro 2033.  This in essence should make the benchmark more variable, but we take repeated in order to smooth this out.  Using the benchmark mode, Dirt 3 is run at 1440p with Ultra graphical settings.  Results are reported as the average frame rate across four runs.

Dirt 3 - One 7970, 1440p, Max SettingsDirt 3 - One 580, 1440p, Max Settings

Civilization V

A game that has plagued my testing over the past twelve months is Civilization V.  Being on the older 12.3 Catalyst drivers were somewhat of a nightmare, giving no scaling, and as a result I dropped it from my test suite after only a couple of reviews.  With the later drivers used for this review, the situation has improved but only slightly, as you will see below.  Civilization V seems to run into a scaling bottleneck very early on, and any additional GPU allocation only causes worse performance.

Our Civilization V testing uses Ryan’s GPU benchmark test all wrapped up in a neat batch file.  We test at 1080p, and report the average frame rate of a 5 minute test.

Civilization V - One 7970, 1440p, Max SettingsCivilization V - One 580, 1440p, Max Settings

Sleeping Dogs

While not necessarily a game on everybody’s lips, Sleeping Dogs is a strenuous game with a pretty hardcore benchmark that scales well with additional GPU power due to its SSAA implementation.  The team over at Adrenaline.com.br is supreme for making an easy to use benchmark GUI, allowing a numpty like me to charge ahead with a set of four 1440p runs with maximum graphical settings.

Sleeping Dogs - One 7970, 1440p, Max SettingsSleeping Dogs - One 580, 1440p, Max Settings

Conclusion

Despite the lack of MCT, the Z87E-ITX does hold its own in the gaming tests, more often than not coming in the top half (if not nearer the top) when compared to the other Z87 motherboards tested.

Computational Benchmarks ASRock Z87E-ITX Conclusion: Recommended
Comments Locked

43 Comments

View All Comments

  • IanCutress - Wednesday, November 6, 2013 - link

    I've already covered the Z87M OC Formula, and I have the Gryphon in for review, as well as a gaming mATX. I hope to get to them by the end of the year :) You have two options for WiFi: USB device, or PCIe x1 card.
  • althaz - Wednesday, November 6, 2013 - link

    Also, I can assure you that the 290 is not quiet enough. It almost doens't matter what for, if you have to ask about the noise, it'll probably bother you, IMO.
  • Aikouka - Wednesday, November 6, 2013 - link

    I've been looking at this board for a while, so it was a nice treat to see the review pop up this morning. The main use that I have for this board is for HTPCs. I like using the Streacom cases (Ganesh reviewed one for Anandtech), and the cases require very little obstruction from the top of the motherboard to the CPU. Unfortunately, a lot of Mini-ITX boards put the memory or 24-pin power connector up there. Also, most boards don't have mSATA ports on them, which is nice because forgoing a 2.5" drive helps to reduce the cable clutter in a really small case.

    All that said, it's good to see that the board received some praise! I just need to wait for Perfect Home Theater to get the short Streacom heat pipes in stock first since the CPU socket is a lot closer to the top than on most motherboards.
  • vykos - Wednesday, November 6, 2013 - link

    Actually, the cheapest board with 802.11ac is Gigabyte's FM2+ mITX board for $110 on Newegg: GA-F2A88XN-WIFI

    http://www.newegg.com/Product/Product.aspx?Item=N8...
  • IanCutress - Wednesday, November 6, 2013 - link

    I just got wind of this via email. It seems fairly new - it doesn't show up on various searches either. So that makes it Gigabyte cheapest on AMD, ASRock on Intel. This means good things: 802.11ac should be ubiquitous up and down the product stack and single band 2.4 GHz should not see the light of day.

    Ian
  • popej - Wednesday, November 6, 2013 - link

    Quote from review: "the dynamic range is low for an ALC1150".

    For typical codec a loop-back test actually measures line-in performance, since AD converters are usually worst then DAC. And results are in perfect accord with ALC1150 data sheet, which states typical ADC dynamic range -104dB and THD+N -80dB.

    Line-in performance is maybe not the most interesting parameters for a motherboard, but at least measurement have proved, that codec implementation is correct.
  • lekzero - Wednesday, November 6, 2013 - link

    I believe this mb is used in "Steam Box prototype", I believe I also saw a power supply Silverstone's ST45SF-G also in SBox.
  • Hrel - Wednesday, November 6, 2013 - link

    I just built a new computer using this board, in a Fractal Design Node 304 case. Core i5 4570S, 8GB of DDR3 1866 and my old GTX460 768MB GPU. Pretty happy with it. Put some velcro stickies on a slim external DVD burner and put it on top of the case, looks good, is quiet, and is fully functional. Pretty happy I can finally build a small form factor computer without having to give up anything.

    The newegg video on the case says long graphics cards could conflict with modular PSU's. This wasn't the case for the Seasonic G...something. 550W hybrid fan PSU I put in it. Just fyi. The modular ports sit below the GPU, so it is tight, but a GTX780 should fit in there just fine.
  • BernardP - Wednesday, November 6, 2013 - link

    Could someone explain what are the uses for the onboard WiFi? This has been puzzling me for some time.

    I already have a wireless router at home. What could this onboard WiFi add?
  • DanNeely - Wednesday, November 6, 2013 - link

    The same thing as the wifi on your laptop, tablet, and phone; it lets you connect to the router without running an ethernet cable.

Log in

Don't have an account? Sign up now