Ripple and Noise

Up next we want to show you some ripple and noise results for each important rail and load. +3.3V and +5V shouldn’t have more than 50 mV (the same level, because +3.3V is often derived from +5V); +12V should be less than 120 mV. So 1% is the maximum limit. The graphics show peak measurements in the bottom left corner as well as the quantity of conspicuous spikes. We have chosen 20 mV per division. We'll put these on separate pages just to avoid overloading one page.

Ripple and Noise +3.3V


10%

20%

50%

80%

100%

110%

+3.3V is very clean and starts with only 7.9 mV. Even with overload there is not more than 30 mV.

Efficiency and PFC Ripple and Noise +5V
Comments Locked

29 Comments

View All Comments

  • bigboxes - Thursday, July 8, 2010 - link

    If it's a pricey model that you've had for only 6 months why didn't you return it for RMA instead of opening it up? Doesn't Antec have a three year warranty?

    Don't get me wrong. I too opened up my failed Antec PSU... my ten year old PSU. Replaced it with an Antec 380W Green PSU. Can't beat $30 Fry's special. I also had another Antec PSU fail after 4 years (a TP 430w during their bad years). I still have a TP 550 that is humming along in my wife's machine going on 5+ years. I'd say more often than not that Antec makes quality power supplies. Of course I have switched to using Seasonic PSUs, but they are not cheap.
  • HOOfan 1 - Thursday, July 8, 2010 - link

    NeoPower is not exactly a Halo product. It is about a high medium level product.

    The point is that sometimes you have electronics that are built on a solid design, but fail early. Maybe 1 in 100 NeoPowers would do that.

    The NeoPowers had at least average to above average build quality...so I still don't understand your claim that it was cheaply built.
  • Black Jacque - Friday, July 9, 2010 - link

    " particularly if you are a gamer with Triple-SLI or Quad-Crossfire systems."

    The nine fanbois' in the USA that have rigs like that don't read AnandTech. Its likely they don't even read above a 5th grade level, "D00d!"

    I wish AnandTech would stop pimping cr*p like this. Only about 1% of the readers need a Kilowatt powersupply. There needs to be more reviews on 400W and lower, highly efficient power supplies that cost less than US$50. These are the PSUs that 99% of the readers need and own.

    If Anand wanted to do us all a favor, he would bend the ear of representatives at Seasonic, Enermax, and Corsair, and tell them that is what is needed, not powersupplies that dim the house lights when you boot your computer.
  • Perisphetic - Friday, July 9, 2010 - link

    95 Amps on the 12V rail?! Finally. I found a replacement unit for my spot welder. Just kidding, I'm sure this will make a fine plasma cutter power source...
  • Perisphetic - Friday, July 9, 2010 - link

    PC tuning enthusiast rejoice. Finally a 2 in 1 solution PSU arrives that can easily weld the sheet metal on the modded case and power the build computer as well. No expense has been spared in making the unit a 80 PLUS uncertified device.
  • HOOfan 1 - Sunday, July 11, 2010 - link

    How much exactly do you know about internal PSU design?

    Maybe you think the generic looked neat and clean because it hard hardly any components in there, while the Antec looked junky because it was crammed full of components.
  • VIDYA - Monday, July 12, 2010 - link

    ok this is so shocking for me, to just see the sight of psu above 1 kilowatt........i mean why do you THINK we SHRINK the chips and simplify the programs(browsers, video drivers) ....this range of products is an OXYMORON for technology and reviewers should not encourage them.
  • molecriket - Wednesday, July 14, 2010 - link

    99.9% of readers don't care about this overkill. a complete waste of effort.
  • JimDDuncan - Saturday, December 18, 2010 - link

    Almost bought this one till I read a review where they tested with cables that did not have built in capacitors. Basically to get performance from this psu you need those specific cables. Also the capicitors are relatively bulky and could get in the way of a tight multi gpu build. Spent the additional 30 dollars on corsair AX 1200.

Log in

Don't have an account? Sign up now