Twisted Pear Audio Opus

The second of our picks comes from Twisted Pear Audio's Opus DAC. Twisted Pear Audio is the collaborative effort of Russ White and Brian Donegan, who are both capable engineers and audio enthusiasts. The benefit of this teaming is that we find a number of kits ranging from volume control, selection controllers, DACs, voltage regulators, and even amplifier modules based upon some of the latest technology and at prices that blow the world of high-end audio wide open.

The Opus is based on Wolfson's WM8741, a differential voltage output DAC that supports up to 24-bit 192KHz resolution (source permitting). Dedicated output stages and power supply kits are available from Twisted Pear, designed from the ground up to compliment the Opus DAC. For those of you wishing to drive into single ended inputs on your preamps or amplifiers, the Ballsie converter/buffer module is the way to go. Total price including the Ballsie modules will range from $200~$350, on par with the price range of Doede's kits mentioned earlier. The Opus is available in a variety of configurations, from a bare PCB to a fully soldered and ready to go kit. There are no components to solder in any of the full kit format options, apart from the input/output terminal blocks depending upon individual configuration requirements.

USB to I2S input modules are also available, although Twisted Pear's design powers the PCM2707 from the USB bus. An asynchronous clock module is available that allows the I2S stream to be re-clocked, thus lowering jitter to aid high fidelity audio reproduction. Another option, rather than using the USB to I2S converter, is to opt for the MUX receiver module. Up to four S/PDIF inputs can be connected while a control switch allows you to select the preferred input. The MUX module is capable of outputting 24-bit PCM in I2S format for those who wish to playback recordings of this resolution.

I decided to use the Doede USB converter and go with a dual differential Opus DAC configuration requiring two PCBs both switched to mono mode supporting stereo left and right respectively. In my case, audio output feeds into a 3A5 dual triode per channel, followed by a Sowter 8650a balanced to a single ended 9:1 ratio output transformer. This is probably not a setup that will appeal to those immersed in the merits of signal to noise ratios and accurate square waves, but it's a solution that sounds very appealing to my less than golden ears.

Outboard DAC solutions Wrapping up the Test System
Comments Locked

114 Comments

View All Comments

  • goinginstyle - Wednesday, December 3, 2008 - link

    I agree, while I might argue about some of the conclusions or have a different opinion, the author knows what the hell he is talking about. It is obvious from a lot of the comments that people stopped reading on page two and brought out the guns. It is fine to agree to disagree but some the comments here apparently came from five year olds and not adults. Sound quality is subjective, get over it. I appreciate a different opinion than my own and found the article to be thought provoking at times. Something an article should do when covering a hot topic like audio quality. Being an old hippie myself, I still love the tubes but digital has its place now. I vote that he does another article on this subject and lets see where AnandTech takes this in the future.
  • strikeback03 - Tuesday, December 2, 2008 - link

    How do you live in a rural area and not own a car?
  • royboy66 - Tuesday, December 2, 2008 - link

    hi I have been into audio and music for many years it is my hobby, computers are my business and hobby. I commend you guys for covering this topic -i will download the software you have used and give it a try.
  • Wastral - Tuesday, December 2, 2008 - link

    Well at least he talked about SOMETHING to do with the PC!

    DAC talk was good if really really wordy. Nothing like breaking points down into something someone can read.

    Not one review of sound cards of sending analog output out from the computer and its actual quality... You know the main component needed in a PC... What a stooge.

    Most People can't even hear over 16khz and the very rare person can hear around 20khz. I tested out at 18.3khz with a wave generator when I was 16. Now? Probably no more than 14khz at the age of 30. Not to mention the dB sensitivity of the ear over 16khz is next to nothing. On top of that, as I pointed out with a little thing called age your hearing decreases to 10khz by age 60 or so.

    Of course If we really want this right, it has to be decoded at the amp, which won't happen, due to there being a million and 1 codecs around. Thus, we are stuck with analog.

    Its all about your speakers and amp. That part of his article I won't complain about too loudly.

    Just his BS about tube amplifiers. 10 years ago that was true. Now its only because old Hippies are retiring and tube amps were top of the line then and they have too much money and time on their hands to burn, with nostalgia hot in their blood.

    Try recording something and then play it back with a tube amp or a Digital amp and compare the sound. No one uses Tube amps in studios. Why? Because it CHANGES THE MUSIC and is not as PURE as one can get with Digital amplifiers. They say they like it... wonderful, its not as true of a sound though, the HYPOCRITS!!!

    Everything else was typical Audiophile BS ignorance. Hell, I have even installed an outlet for an "audiophile" pointed North-South for better "power" to his amp. No joke, he whipped out a compass.

    Comments like, "I only use silver 24 guage wire." DUMB shit!! Go another guage larger in copper is a hell of a lot cheeper and gets better results.... IDIOT. Not to mention its your CONNECTORS THAT COUNT.

  • Rajinder Gill - Tuesday, December 2, 2008 - link

    Where did I sue the word 'only' in that statement about wire?

    Seems you've done the typical thing and read what you want to read.

    My entire cable setup costs less than $40, including the interconnects and mains cables. No north-south compass in my house either.

    Connections are direct soldered where they can be and if it's practical enough. No expensive connectors used.

    I'll aslo refrain from using the derogatory language you seem so comfortable with.
  • Rajinder Gill - Tuesday, December 2, 2008 - link

    correction meant 'use'..
  • Geraldo8022 - Tuesday, December 2, 2008 - link


    Mr Gill is trying to do some of you a favor by cluing you in, but some of the denser posters come back with talk about receivers, headphones, soundcards, measurements, double blind testing, Class D, etc.
    Someone once asked Satchmo what jazz was and his reply was, "if you gotta ask you don't get to know." I guess some of you here aren't gonna get to know. Just keep your head in the sand, or elsewhere.
    I have been into HiFi for almost forty years and it is about things like sitting in the dark at one o'clock in the morning with Sarah Vaughn. If that doesn't make any sense to you, then you don't get to know.
    Mr Gill, I thank you for this article. You keep on keepin' on.
  • Beefmeister - Tuesday, December 2, 2008 - link

    Great choice on the Opus DAC; the Twisted Pear Audio guys do great work. I've built myself a Buffalo DAC.

    That being said, I would strongly suggest you look at replacing your Ballsie with IVY modules. IVY is capable of zeroing the DC offset from the DAC, thus allowing you to jumper the output coupling caps on the Opus. It also gets rid of the dual and quad OPAMPs of the Ballsie, which apparently don't measure as good as the single and dual variants.
  • draak13 - Monday, December 1, 2008 - link

    Starting off with reading the article, I was getting quite pissed about how much this was going into the usual audiophile BS, where their 'prowess' of electronics goes so far as, "the resistor says 1000 ohms, but really, it TASTES like 992 ohms. There's such a huge difference." I was half expecting there to be talk of putting sandbags around the room to 'enhance the musical quality of the room setting.'

    Reading further, I found that this article was quite good, and was even moderately scientific as I have come to expect from Anandtech. The choice of the recording microphone was EXCELLENT; I looked up the spec sheet for that, and the response on that mic is absolutely incredible, and is a total steal for the price you pay. Kudos to anandtech for finding and using it. The very objective comparisons of two different dacs was quite excellent, as were the multiple recordings.

    I absolutely loved your analysis of an addition of a subwoofer into the system to compensate for the range of the main speakers. I have always been curious about how well that would actually work. Lastly, I was blown away by your DRC analysis. That's an INCREDIBLE algorithm that you have there; I love it.

    There are a few things that I could say about the choice of components, and the squabbling going on about what components "perform better", but there is an end-all test that you could do to prove what is and isn't BS. First, I can flat out GUARANTEE you that your microphone is as sensitive or more sensitive than the human ear AT LISTENING VOLUME. That is, anything that you can hear, that microphone should be able to hear as well. So, if you wanted to turn your subjective listening tests into objective listening tests, then play back those songs you were testing your setup with, but record those songs at listening position with your microphone using all of your different setups. Record them multiple times, as you have been doing in your tests. Next, using MATLAB or whatever other software, overlay the recorded waveforms and determine the differences between the two. If there truly is a difference between the different hardware setups that you were using, I guarantee that this will be sensitive enough to detect that difference, and will do so quantitatively.
  • DeepThought86 - Monday, December 1, 2008 - link

    At the end of the day, is all this expensive tomfoolery just to listen to music? Why pay extra and turn your brain to jelly to boot?

Log in

Don't have an account? Sign up now