Gigabyte K8NXP-SLI: Overclocking and Stress Testing

FSB Overclocking Results

Front Side Bus Overclocking Testbed
Gigabyte K8NXP-SLI
Processor: Athlon 64 4000+
(2.4GHz, 1MB Cache)
CPU Voltage: 1.55V (default 1.50V)
Cooling: Thermaltake Silent Boost K8 Heat sink/Fan
Power Supply: OCZ Power Stream 520W
Memory: OCZ PC3200 EL Platinum Rev. 2
(Samsung TCCD Memory Chips)
Hard Drive: Seagate 120GB 7200RPM SATA 8MB Cache
Maximum OC:
(Standard Ratio)
230x12 (4X HT, 2.5-3-2-7, 1T, 2.8V)
2760MHz (+15%)
Maximum FSB:
(Lower Ratio)
230x12 (2760MHz) (4X HT, 2.5-3-2-7, 2.8V)
(1:1 Memory, 1T, 2 DIMMs in DC mode)
(+15% Bus Overclock)

After the excellent overclocking results that we found in our pre-production review of the K8NXP-SLI, we really expected the Gigabyte SLI to be near the top of our overclocking charts. However, something has happened along the way from pre-production to production because our production board could only reach a very disappointing 230 CPU speed regardless of the multiplier selected. This is in stark contrast to the 284 that we easily reached on the pre-production board.

We recently met with Gigabyte to discuss this issue and Gigabyte has assured us that they will make updates to get overclocking back to the levels which we saw in our earlier review. For now, we can only say that we have no idea what you will actually find in the overclocking capabilities of a K8NXP-SLI that you might buy. It could be stellar, like the pre-production board that we tested, or mediocre, like the last board that we tested. We have evidence to support either conclusion.

Memory Stress Test Results:

Our memory stress tests measure the ability of the K8NXP-SLI to operate at its officially supported memory frequency (400MHz DDR), at the lowest memory timings that OCZ PC3200 Platinum Rev. 2 modules will support. All DIMMs used for stress testing were 512MB double-sided (or double-bank) memory. To make sure that memory performed properly in Dual-Channel mode, memory was only tested using either one dual-channel (2 DIMMs) or 2 dual-channels (4 DIMMs).

Stable DDR400 Timings - One Dual-Channel
(2/4 DIMMs populated)
Clock Speed: 200MHz
CAS Latency: 2.0
RAS to CAS Delay: 2T
RAS Precharge: 7T
Precharge Delay: 2T
Command Rate: 1T

Using two DIMMs in Dual-Channel 128-bit mode, the memory performed in all benchmarks at the fastest 2-2-2-7 timings, at default 2.6 voltage.

Tests with 4 DS DIMMs on an AMD Athlon 64 system are more demanding, since AMD specifies DDR333 for this combination. However, most AMD Athlon 64 motherboards combined with recent AMD processors (the memory controller is on the AMD CPU) have been able to handle 4 DIMMs at DDR400.

Stable DDR400 Timings - 4 DIMMs
(4/4 DIMMs populated)
Clock Speed: 200MHz
CAS Latency: 2.0
RAS to CAS Delay: 2T
RAS Precharge: 7T
Precharge Delay: 2T
Command Rate: 2T

Tests with all four DIMM slots populated on the Gigabyte required a 2T Command Rate with 4 DIMMs in two dual channels. This is the pattern seen on other top-performing Socket 939 boards. There was no problem running 4 DS DIMMs at DDR400 at the same aggressive 2-2-2-7 settings, which worked well with 2 DIMMs.

Gigabyte K8NXP-SLI: Features and Layout MSI K8N Neo4/SLI Platinum: Features and Layout
Comments Locked

108 Comments

View All Comments

  • ajmiles - Wednesday, March 2, 2005 - link

    If i was a doubting type I would suggest that Nvidia spent as much time tuning their drivers for benchmarks as they do games.

    Nice to see support for some unreleased games such as Battlefield 2 on the list though.

    Wesley, you get my email btw? (sorry for bugging you)?
  • Wesley Fink - Wednesday, March 2, 2005 - link

    nVidia has just advised the release of Beta 71.84 drivers now supporting 70 games in SLI. The drivers can be downloaded at http://www.nzone.com/object/nzone_downloads_rel70b... Below is a list of suypported games and benchmarks.

    Age of Mythology
    AquaNox 2: Revelation
    Armed & Dangerous
    Battlefield 1942
    Battlefield 2
    Battlefield Vietnam
    Breed
    City of Heroes
    Colin McRae Rally 2005
    Colin McRae Rally 4
    Conan
    Dark Age of Camelot: Atlantis
    Desert Rats vs. Afrika Korps
    Dirt Track Racing 2
    Doom 3
    EverQuest
    EverQuest II
    Far Cry
    Flat Out
    Ground Control II : Operation Exodus
    Half-Life 2
    Halo
    Hitman 2
    IL-2 Sturmovik: Forgotten Battles
    Joint Operations: Typhoon Rising
    Kohan II: Kings of War
    Leisure Suit Larry
    Lineage II
    Lock On
    Lord of the Rings, Battle for Middle-earth
    Madden NFL 2005
    Max Payne 2
    Medal of Honor
    NBA Live 2005
    Need for Speed: Underground 2
    Painkiller
    Perimeter
    Prince of Persia: The Sands of Time
    Quake III
    Return to Castle Wolfenstein: Enemy Territory
    Return to Castle Wolfenstien
    Rome: Total War
    Serious Sam: The Second Encounter
    Sid Meier's Pirates!
    Silent Storm
    Sims 2
    SpellForce
    Splinter Cell
    Splinter Cell: Chaos Theory
    Star Wars Battlefront
    Star Wars Jedi Knight: Jedi Academy
    Star Wars Jedi Knight II: Jedi Outcast
    Star Wars: Knight of the Old Republic
    SWAT 4
    The Chronicles of Riddick
    Thief: Deadly Shadows
    Tiger Woods PGA Tour 2005
    ToCA Race Driver 2
    Tomb Raider: The Angel of Darkness
    Tony Hawk's Underground
    Tribes Vengeance
    Tron 2.0
    Unreal
    Unreal 2
    Unreal Tournament 2003
    Unreal Tournament 2004
    Vampire: Bloodlines
    Warhammer 40,000: Dawn of War
    World of Warcraft
    X2: the Threat
    Xpand Rally


    In addition to these top games, NVIDIA SLI supports the following applications:

    3DMark01
    3DMark03
    3DMark05
    AquaMark 3
    Code Creatures
    D3DRightMark
    HDRLighting
    NVIDIA Clear Sailing Demo
    NVIDIA Dawn Demo
    NVIDIA Nalu Demo
    NVIDIA Timbury Demo
    PCMark04
    Shadermark 2.1
    Trees of Pangaea

  • giz02 - Wednesday, March 2, 2005 - link

    I've done some further testing, and still no luck. The PCStats review also indicated 192Khz output, but I can't find that either. I'm still hoping for something, and will let you guys know if anything comes up.

    Other points:
    + The onboard Creative can attenuate the digital outputs just like a regular live could. Most onboard solutions that i have used could not

    - Cannot have Analog and Digital outs enabled at the same time (at least I haven't found that yet). All other onboard solutions that I have tried were able to do this. An example of what I'd like to do (ideally) is have my Zalman Real Surround headphones plugged in to the analog ports, and the z5500's plugged into the digital (coax/optical). When the GF complains, I could turn the z5500's off, and put on the headphones. With creative you do this BUT you also have to uncheck the digital out only box. If they can bot h be enabled at the same time, let me know (Y)

    - Either the Z5500's can't accept 96/24 on the optical in, or the creative isn't outputting 96/24 on the optical out.

    - Only Coax or Optical work at one time (with the Z5500's)

    - DD and DTS passthroughs work with Videolan and DVD's/.ts's.

    I'll try this board for a while longer, but if encode will not work, I'll be heading to DFI. It's a bit more expensive, but you get the Lan Tote (woohhoo!) and the extra PCIx slots. Anyone have any comments on DFI's onboard sound?


  • EODetroit - Wednesday, March 2, 2005 - link

    Thanks giz02. One of these days some manufacturer is going to realize there's demand for this and meet it... I just hope that day comes sooner than later.
  • SLK75 - Tuesday, March 1, 2005 - link

    I bought the GA-K8NXP-9 because fo the rave reviews on its OC abilities which Anandtech also proved in their pre-production sample reviewed towards the end of last year...All of a sudden now Gigabyte's production version of the board does not seem to clock high as was expected and proved previously WHYYYY ???? and Anandtech make it really clear to Gigabyte that people went and bought their board not only first its great features but also for its OC capabilities...I hope Gigabyte can address this with a new BIOS
  • giz02 - Tuesday, March 1, 2005 - link

    I feel DUPED by that PCSTATS review. I've asked the reviewer for why he indicated that the board can DICE (either how to do it, or who told him it was possible).

    The board is .... OK...

    I'da rather had the DFI (if DICE is not possible!)
  • Aquila76 - Tuesday, March 1, 2005 - link

    #89 - looks like we'll both still wait for the next SoundStorm. Maybe the next gen of PCI-E sound cards will have DDL?
  • bob661 - Tuesday, March 1, 2005 - link

    #89
    Thanks for the test.
  • giz02 - Tuesday, March 1, 2005 - link

    So far, It's a negative on the DICE :(

    I have a single coax cable connected from the onboard card to my Z-5500's and they are not recieving Dolby on the speaker tests. Left and Right channels come through but that is is... 96-24 is working as well, but zilch on the 5.1 :(
  • 1955mm - Tuesday, March 1, 2005 - link

    #87: AMD has NOT made it clear that ECC is an Opteron only feature. Read the document from the link I posted. As for ASUS not supporting ECC, download the manual and look at pages 4-21 and 4-22. In the screenshot for DRAM configuration there is an item for ECC enablement. The ASUS K8N-E deluxe (socket 754) also supports ECC. If you still have doubts that the Athlon 64 supports ECC, go to crucial.com and see what memory is supported by the ASUS K8N-E deluxe and A8N-SLI deluxe. I think that you might be confusing registered memory with ECC. If you write code work with critical data ECC is worth having. I have had bad memory in the past that corrupted data without crashing the machine. Considering misinformation that is sometimes provided by motherboard manufacturers and your obvious confusion about the Athlon 64, I think that ECC deserves some mention by motherboard reviewers. I myself would like to understand why the A8N-SLI apparently supports 4 256MB ECC memory modules but not 2 512MB ECC memory modules (page 2-12 in manual), Wesley?

Log in

Don't have an account? Sign up now