Mixed Random Read/Write Performance

The mixed random I/O benchmark starts with a pure read test and gradually increases the proportion of writes, finishing with pure writes. The queue depth is 3 for the entire test and each subtest lasts for 3 minutes, for a total test duration of 18 minutes. As with the pure random write test, this test is restricted to a 16GB span of the drive, which is empty save for the 16GB test file.

Iometer - Mixed 4KB Random Read/Write

Like the SanDisk X400, the WD Blue performs better on the mixed random I/O test than competing planar TLC drives and about the same as the slowest MLC drives.

Iometer - Mixed 4KB Random Read/Write (Power)

The WD Blue once again slightly raises the efficiency standards for planar TLC, but is still nowhere near as efficient as 3D TLC or MLC.

The WD Blue starts the mixed random I/O test with a pretty good random read speed, but performance declines as writes are added to the mix until near the end of the test, where the jump in the last segment of the test is not as large as what most drives experience.

Mixed Sequential Read/Write Performance

The mixed sequential access test covers the entire span of the drive and uses a queue depth of one. It starts with a pure read test and gradually increases the proportion of writes, finishing with pure writes. Each subtest lasts for 3 minutes, for a total test duration of 18 minutes. The drive is filled before the test starts.

Iometer - Mixed 128KB Sequential Read/Write

The WD Blue performs above average for a planar TLC SSD on the mixed sequential I/O test, but is not competitive with MLC or 3D TLC.

Iometer - Mixed 128KB Sequential Read/Write (Power)

In absolute terms the WD Blue has pretty low power draw on this test, but the efficiency is not close to setting a record.

The WD Blue's U-shaped performance curve across this test is fairly typical, but the dropoff at the beginning is relatively steep and the minimum is a bit on the low side.

Sequential Performance ATTO, AS-SSD & Idle Power Consumption
Comments Locked

75 Comments

View All Comments

  • Arbie - Tuesday, October 11, 2016 - link

    I agree with another comment. Why is the Mushkin Reactor 1TB not in the charts for recent SSD reviews? At $230 it's cheaper than many, is MLC, and overall seems like a great buy. You reviewed it but then seem to have forgotten it.
  • DanNeely - Tuesday, October 11, 2016 - link

    I'm a bit puzzled by the performance consistency numbers here. In them the WD Blue 1TB seems to be consistently faster than the Sandisk X400 1TB before reaching steady state and about the same speed once it hits that point; but in almost all the other benches the Sandisk scores higher.
  • Billy Tallis - Tuesday, October 11, 2016 - link

    The drive is completely filled once before the random write consistency test, which runs at QD32. Most of the other IOmeter scores are averages of low queue depths, and the random write test on page 6 is limited to a 16GB test file on an otherwise empty drive. Whatever effect caused the WD Blue to have lower peak performance is more significant for the shorter test, while for the consistency test the fact that the WD Blue has more spare area to start with than the X400 is a bigger factor.
  • kmmatney - Tuesday, October 11, 2016 - link

    I bought a SanDisk Ultra II 960GB drive about a year ago for around $200, and it's still close to that price ($219 at the moment). It's the one with SLC cache - I use it in my everyday work computer, as my OS drive, and I typically run 1-2 virtual machines as well. So I push it fairly hard for a consumer SSD, and it still runs great - no complaints at all, and I'd recommend it for the price.
  • Michael Bay - Thursday, October 13, 2016 - link

    Same experience here. In a few weeks it will be a year of use for me, and if Sandisk utility is to be trusted, it`s only 1% worn.
  • mapesdhs - Friday, October 14, 2016 - link

    It's a pity the X300 is not available anymore, it had very good consistency and at one point was cheaper than many budget models.
  • Shadowmaster625 - Tuesday, October 11, 2016 - link

    It is amazing that they fit all that on one side of the board without so much as a capacitor on the back...
  • LordConrad - Tuesday, October 11, 2016 - link

    Sorry, I refuse to buy a SSD that uses TLC planar NAND.
  • TheinsanegamerN - Tuesday, October 11, 2016 - link

    why? these have higher write endurance then some MLC drives.
  • MrCommunistGen - Tuesday, October 11, 2016 - link

    That was quick - WD releasing an SSD under their own name. Sure it is a warmed over X400, but as the performance numbers indicate they didn't just slap a sticker on it... which leads to my next comment.

    When I read the opening of the article I was pretty excited. X400 with a bit more overprovisioning. I was expecting to see extra performance (even if only a little) along with the endurance. I guess not. Oh well.

Log in

Don't have an account? Sign up now