Performance vs. Transfer Size

ATTO is a useful tool for quickly benchmarking performance across various transfer sizes. You can get the complete data set in Bench. Read performance scaling is actually better than in the reference design JMF667H we tested, although the SSD340 is still outperformed by the 840 EVO and SP610. Write performance seems to be similar to the reference design and the maximum throughout is definitely a bit disappointing. 

Click for full size

 

Random & Sequential Performance Power Consumption
Comments Locked

57 Comments

View All Comments

  • hojnikb - Monday, August 4, 2014 - link

    Could it be possible to flash newer refrence firmware to it ?

    I know this have been done in the past, because i've flashed my Crucial V4 with newer firmware that crucial offered. I wonder if its the same with Jmicron
  • solnyshok - Monday, August 4, 2014 - link

    Whenever I read about slow ssd, I wonder if "the one" that I need is going to happen. If manufacturers read this - here is the niche for HTPC. I need a silent movie/torrent storage. 1TB at $200-250 would be a good start. Performance/power saving aren't that important, as long as it can sustatin 130MB/s sequential read/write (bottleneck of home gigabit network) and 10,000+ iops (to avoid jerkiness of video playback during concurrent torrent seeding)
  • ddriver - Monday, August 4, 2014 - link

    Most HDDs do 130 MB already. You can avoid "jerkiness" by tweaking buffering/caching for playback and torrents respectively.
  • leexgx - Tuesday, August 5, 2014 - link

    can you fix the Crucial MX100 OP results and lower the IOPS to to 30k

    as the Crucial MX100 is doing some very odd results on the 25% OP 32QD 4K Write (the last one seems an error doing 60k IOPS as its way past 50K on that last test) 412GB is making the charts go to 50k when most do not pass 25k
  • leexgx - Tuesday, August 5, 2014 - link

    4K random Write 32Q 25% OP Crucial MX100
  • solnyshok - Tuesday, August 5, 2014 - link

    Thanks for all replies, I already have SSD (256GB 840EVO+2TB 2.5"HDD) combo in my htpc. I just wanted to go totally silent. My point was that somebody needs to pack 1TB of the cheapest flash on the cheapest controller for the lowest $/GB ratio. I appreciate replies about price-o-nomics of ssd making. If it is not feasible, oh, well, I can wait couple of years.
  • MrSpadge - Monday, August 4, 2014 - link

    You hardly gain any cost benefit by making SSDs slow. That's why you don't see the value drives you're looking for. Sounds like a 5x00 rpm HDD together with some small to medium sized SSD for the torrents is your best solution. Assuming you don't offer your entire movie collection for torrenting, of course.
  • hojnikb - Monday, August 4, 2014 - link

    If you tune your torrent client right, ANY 5400rpm hdd will be just fine. I know, because i'm using an old 2.5" drive in my nas and can do multiple torrents AND streaming with ease. Its just the right tuning.
  • wolrah - Monday, August 4, 2014 - link

    It's not even tuning, just keeping preallocation on and keeping fragmentation down is enough.
  • solnyshok - Tuesday, August 5, 2014 - link

    Thanks, if that's the case, I just need to wait a bit (3 years?), until 1TB becomes cheap

Log in

Don't have an account? Sign up now