FOXCONN NF4SK8AA-8KRS: Overclocking

FSB Overclocking Results

Front Side Bus Overclocking Testbed
Processor: Athlon 64, 4000+, San Diego Core
CPU Voltage: 1.5125V (1.4000V default)
Memory: OCZ PC4800 Platinum Edition
Memory Voltage: 2.85
Cooling: AMD Stock Heat sink and Fan
Power Supply: OCZ Power Stream 520
Maximum CPU Overclock
Standard Ratio (12)
248fsb x 12, 4x HT, (2.5-4-4-10, 1T)
2976MHz (+24%)
Maximum FSB Overclock
Lowered Ratio (9)
250fsb x 9, 4x HT, (2.5-3-3-7, 1T)
2250MHz (+25% Bus Overclock)

This board is a decent overclocker at standard ratios, considering its limitations in running our memory at 2.85V, but it was unable to reach higher than 250fsb at the lowered ratios. In fact, we were unable to get this board to post in any form past a 255fsb setting regardless of memory, HT, or voltage settings. At the settings listed, our test system was able to complete the entire benchmark suite three times without any reported issues.

Memory Stress Testing

Memory stress tests look at the ability of the Foxconn NF4SK8AA-8KRS to operate at the officially supported memory frequencies of 400MHz DDR, at the best performing memory timings that the OCZ Technology PC4800 Elite Platinum could support.

Foxconn NF4SK8AA-8KRS
Stable DDR400 Timings - 2 DIMMs
(2/4 slots populated - 1 Dual-Channel Bank)
Clock Speed: 200MHz
CAS Latency: 2
RAS to CAS Delay: 2
RAS Precharge: 2
RAS Cycle Time: 5
Voltage: 2.8V
Command Rate: 1T

The Foxconn NF4SK8AA-8KRS was completely stable with 2 DDR modules in Dual-Channel at the settings of 2-2-2-5 at the default 2.8V.

Tests with 4 double-sided DIMMs on an AMD Athlon 64 system are very demanding, since AMD specifies DDR333 for this combination. However, most AMD Athlon 64 motherboards combined with recent AMD processors have been able to handle 4 DIMMs at DDR400 settings.

Foxconn NF4SK8AA-8KRS
Stable DDR400 Timings - 4 DIMMs
(4/4 slots populated - 2 Dual-Channel Banks)
Clock Speed: 200MHz
CAS Latency: 2
RAS to CAS Delay: 2
RAS Precharge: 2
RAS Cycle Time: 10
Voltage: 2.8V
Command Rate: 2T

The Foxconn NF4SK8AA-8KRS was completely stable with 4 DDR modules in Dual-Channel at the settings of 2-2-2-10 at the default 2.8V.

FOXCONN NF4SK8AA-8KRS: Features Test Setup
Comments Locked

37 Comments

View All Comments

  • Gary Key - Tuesday, January 3, 2006 - link

    quote:

    On the second page, in the table, all the boards have slots for DDR2 memory. It should be DDR, I think


    Corrected. I apologize for that error and the previous mention of DDR2 in the Asus memory section. My right side brain was thinking DDR but the Intel side of the brain was typing DDR2. ;->
  • JarredWalton - Tuesday, January 3, 2006 - link

    Nah, these are M2! Seriously, though, thanks - busted Gary on the copy/paste, eh? Although he did get the memory speeds right, so you can't go too hard on him. :)
  • Martrox - Tuesday, January 3, 2006 - link

    I've got a K8SLi that I picked up for $80. I'm currently running a 3000+ Venice at 2610(9x290) memory set to 166fsb(TCCD 2x512)2.5,3,3,7. Running 7800GT's SLi'ed with absolutely no problems.......Wish the voltage options were better, but it does work pretty well.
  • lopri - Tuesday, January 3, 2006 - link

    The title says, and the article begins with "Premium performance at bargain price" then it ended up praising (and recommending) ASUS board. The ASUS board doesn't belong to same ground as that of the other two boards, and the price of the board certainly proves it. In the first page how affordable NF4-SLI boards have become is mentioned ($70), then compare 2 value boards with a premium board($170)? What's the point of this review? Did ASUS ask to boost the "A8N-SLI Premium" board since they can't meet the demand of "A8N32-SLI"?

    I'm sorry but as an avid AT reader/forumer, I should say this review is totally off. It's nothing but an ASUS PR presentation. Also, it's been pointed out many times lately, but according to AT reviews, every single board on the market is a "great overclocker," "dark-horse," "keeper," "enthusiast-targeted". Everytime AT reviews a motherboard they miraculously find something to compliment and that becomes the main point of the article.

    It's almost up to the point that I no longer completely trust AT motherboard reviews. I'm sorry to say this, especially the author of this specific article, but my comment is more general towards the whole AT motherboard team. (Wesley, Jared, et. al)

    Is this going to continue? (Sigh..)
  • JarredWalton - Tuesday, January 3, 2006 - link

    Just curious, Lopri, but you did notice that the Foxconn and Albatron received a recommendation based on price, right? There are people that want all the features of something like the ASUS Premium, and they're willing to pay for it. All three motherboards here are pretty decent, though, and while I didn't write the article I'm a little confused as to how this is seen as a PR piece.

    To a certain extent, all reviews are a form of PR. Companies send us a product and we review it. We review other products sometimes, but generally speaking we review the products that we get sent. The only things that really separates these boards from each other are features and overclocking capability. In most of the benchmarks, scores are close enough that you needn't lose sleep over the difference.
  • Wesley Fink - Tuesday, January 3, 2006 - link

    We've complained plenty about the ATI SB450 southbrudge (poor USB 2.0 performance) even though we like the ATI chipset in general. We've also complained loudly about nVidia's mediocre AC'97 audio on their top boards when ATI and ULi are delivering hooks for HD Azalia in their AMD chipsets.

    Frankly, until very recently Asus had not had a really great AMD board since the Socket A days - they hadn't won a single AMD roundup in quite a while. Asus rested on really great Intel boards. Recently Asus got very serious about the AMD market and the A8N32-SLI Deluxe is a great board. So is the A8R-MVP at the price point of around $100. However, as another recent review clearly showed, the Asus 6150 is pretty pedestrian and not a great choice for a multimedia PC with all the important multimedia stuff an extra cost option.

    A lot of the real crap boards we see get pulled from the market before release and our review never sees the light of day. An example is the original Asus Premium reviewed here, which was a terrible overclocker due to the switches that replaced the paddle for SLI switching. When we complained to Asus they decided to hold off release of the board and rework the switching. The result is the board reviewed here which is a huge improvement. Oddly, it overclocks FSB very well but really does not do a great job in overclocking memory. The A8N32-SLI Deluxe is still the better board for the Enthusiast.

    The motherboard team really cares about the products, and they aren't looking for a sensational story like some other sites. We could write Inquirer-like exposes on plenty of the early BIOS' we receive, but we prefer to work with the manufacturer to try to resolve the issues on production boards. If we can't get things to work we ask lots of questions before we assume we are Gods and the board is junk. But if it's junk or just all hype in the end, we'll tell you that.

    We began testing features more in-depth because the memory controller on the AMD CPU greatly reduced the performance variations we used to see in motherboards. Also most manufacturers have gotten more serious about going after the Enthusiast who is our basic reader. That's the reason you're seeing so many really good overclockers these days. Just when we think it can't get any better another board sets some new record. However there are lots of boards out there below these standards, and we do tell you that when we review them.




  • mindless1 - Tuesday, January 3, 2006 - link

    I see nothing wrong with this concept, makes plenty of sense.

    I would not however consider this to be "Premium Performance at a Bargain Price". Back in the socket A days an AMD platform at a bargin price was $50-70 for your basic nForce2, of course a little higher when first deputed. It's very hard to make an argument that any board over $100 is bargain in this age with so many of the features chipset-integral.

    If anything, the typical trends of motherboard features and performance are still holding true but at a far worse bargain than ever before. SLI should not cost much more except for the smaller market segment.

    On a side note- Cooling the Asus board by moving the heat from the southbridge to the hottest zone on the board just to save a fan is a really bad idea. Almost seems like an afterthought for marketing purposes. Given the space that thing takes up they should've just use a giant low-profile passive 'sink if they really needed to stay fanless.

  • mindless1 - Tuesday, January 3, 2006 - link

    "... by moving the heat from the southbridge"

    I too would like an edit function. ;-)
  • Beenthere - Tuesday, January 3, 2006 - link

    ...Mobo for the vast majority of PC users as the article states. Most people have no need or use for SLI and have no interest in paying a premium price for SLI when they will never use it. SLI is a gimmick for gamers and nothing more. If you want it, buy it, but I highly doubt mainstream PC users will cough up $170 bucks or more for SLI when you can have Asus's A8R-MVP Crossfire Mobo for $101. from Mwave.

    The $70. you save could go toward a nice Vid card and the A8R-MVP overclocks every bit as good as the SLI boards and performs better than all of the SLI Mobos per Wesley Finks recent review.

    http://www.anandtech.com/mb/showdoc.aspx?i=2617">http://www.anandtech.com/mb/showdoc.aspx?i=2617

    At $101. mainstream PC users can have the best performance, overclocking and not even worry about paying a premium for Crossfire or dual graphics cards. If in the future they really desire to blow more dough on a second video card, they could, but there would not be a price penalty for purchasing the superior A8R-MVP Mobo like there is with any of the SLI rigs.
  • Some1ne - Wednesday, January 4, 2006 - link

    I agree, I feel that the article makes some unfounded and moreover highly irresponsible statements, such as "in fact, the current price structure almost ensures that your nForce4 purchase should be an SLI-capable motherboard." SLI is not worth it in any way, shape, or form from any cost/performance standpoint, unless you happen to be the enthusiast user who wants the highest possible performance available today no matter the cost. For everyone else SLI is worthess...and yet how many new users are going to go out and waste their cash on an SLI board because of statements made in the article like the one above?

    Irresponsible, and not backed up by any solid evidence. It's like the author started off with the assumption that SLI = good, so therefore any affordable SLI board is also good. It doesn't work like that though.

Log in

Don't have an account? Sign up now