Asus A8N-SLI Deluxe: Overclocking and Stress Testing

Front Side Bus Overclocking Testbed
Asus A8N-SLI Deluxe
Processor: Athlon 64 4000+
(2.4GHz, 1MB Cache)
CPU Voltage: 1.5375V (default 1.50V)
Cooling: Thermaltake Silent Boost K8 Heat sink/Fan
Power Supply: OCZ Power Stream 520W
Memory: OCZ PC3200 EL Platinum Rev. 2
(Samsung TCCD Memory Chips)
Hard Drive: Seagate 120GB 7200RPM SATA 8MB Cache
Maximum OC:
(Standard Ratio)
234x12 (Auto HT, 2-3-3-7, 1T, 2.8V)
2808MHz (+17%)
Maximum FSB:
(Lower Ratio)
255x11 (2805MHz) (4X HT, 2.5-3-3-7, 2.7V)
(1:1 Memory, 1T, 2 DIMMs in DC mode)
(+28% Bus Overclock)

Asus has been the overclocking leader in many of our recent Intel processor roundups, so it was certainly a disappointment that the Asus turned out to be a below-average overclocker in the SLI roundup. The highest CPU speed that we could reach with stability was 255, but performance at the stock 12 multiplier of our 4000+ was a respectable 234. With two of the boards in the SLI roundup going well above 300 in the same configuration, this was hardly impressive overclocking.

Memory Stress Test Results:

Memory stress tests look at the ability of the Asus A8N-SLI to operate at the officially supported memory frequency at the best performing memory timings that our standard OCZ PC3200 Platinum Rev. 2 will support. Memory stress testing was conducted by running 1:1 at DDR400 with 2 DIMM slots operating in Dual-Channel mode.

Stable DDR400 Timings - One Dual-Channel
(2/4 DIMMs populated)
Clock Speed: 200MHz
CAS Latency: 2.0
RAS to CAS Delay: 2T
RAS Precharge: 7T
Precharge Delay: 2T
Command Rate: 1T

The Asus SLI was completely stable with 2 DDR modules in Dual-Channel at the settings of 2-2-2-7 at default voltage. This matches the best timings that all of the SLI motherboards in this roundup were able to achieve.

Filling all four available memory slots is more strenuous on the memory subsystem than testing 2 DDR modules on a motherboard.

Stable DDR400 Timings - 4 DIMMs
(4/4 DIMMs populated)
Clock Speed: 200MHz
CAS Latency: 2.0
RAS to CAS Delay: 2T
RAS Precharge: 7T
Precharge Delay: 2T
Command Rate: 2T

The Asus K8N-SLI was completely stable at 2-2-2-7 memory timings. We did have to lower the Command Rate to 2T, but this is a function of the on-chip Athlon 64 memory controller. It is rumored that upcoming Rev. E chips will have an updated memory controller capable of driving 4 DIMMs at 1T command rate, which would definitely improve memory performance when running 4 DIMMs.

Asus A8N-SLI Deluxe: Features and Layout DFI LANParty nF4 SLI-DR: Features and Layout
Comments Locked

108 Comments

View All Comments

  • Rike - Monday, February 28, 2005 - link

    And then he double posts and can't spell "graphs." (not "graphes!") *bangs head on wall* Oh well. To err is human. Happy Monday! :)
  • Wesley Fink - Monday, February 28, 2005 - link

    #33 - That is correct, but to implement PCIe Ethernet the mfg must use a PHY gigabit ethernet controller. In fact, as I state in the review, all 4 SLI boards implement PCIe on Gigabit #1, but all 4 boards have dual gigabit ethernet. Most implement PCI on Gigabit #2 with the results you can see in the ethernet performance charts.

    #30 - It IS a significant point and I thought we were clear that the 3132 is PCIe. I will add that to the chart to removee any confusion. However, there is another side to MSI using PCIe on all the on-board features. With both PCIe LAN's and PCIe SATA2 add-on there are no channels left from the 20 lanes available for PCIe slots.
  • Rike - Monday, February 28, 2005 - link

  • Rike - Monday, February 28, 2005 - link

    Minor typo: HL2 resolutions on the graphes are listed as 16,000 x 1200 instead of 1600 x 1200. Either that or you're using a seriously wide screen! ;)
  • mechBgon - Monday, February 28, 2005 - link

    Wes, an academic point: unless something's changed with nVidia southbridges, the nForce3/4 gigabit Ethernet controller isn't a PCI-based device, it's native to the southbridge and rides the Hypertransport bus. If you're getting >900Mbit/sec in your test, it's pretty obvious it's not on a 32-bit PCI bus ;)
  • AlanStephens - Monday, February 28, 2005 - link

    #28 - I know for a fact that Creative doesn't support Dolby Digital Encoding. I wish they did though. Here is a quote from Creative's Knowledge Basse on this:

    "Computer games written with support for 3D audio do not require a Dolby Digital Interactive Content Encoder (DICE) to output multichannel sound, with no exceptions. Sound devices that support the real time encoder technology from Dolby will simply receive the multichannel wave file output and encode it in real time to a somewhat modified Dolby Digital bitstream. Creative does not support the Dolby Digital Interactive Content Encoder on any of its sound cards.

    The only difference between a Sound Blaster card and an audio card that has a real time encoder, is that you can make a one-wire, digital connection from your audio card to your home theater receiver and enjoy discrete multichannel sound from the game. However there will be a continuous, slight delay, known as "latency", as the encoder is creating and transmitting the bitstream, and of course the compression scheme being used is "lossy" (i.e. not bit-accurate).

    If you want to enjoy 3D audio in 3D enabled PC games in multichannel surround sound with a Sound Blaster card, it is recommended that you connect the analog outputs of the sound card directly to the analog inputs of the receiver."
  • EODetroit - Monday, February 28, 2005 - link

    I wanna know the answer to #28's question. I've been looking for the next Soundstorm... ie I want to output a dolby digital 5.1 (or better) signal through a spdif connection from a non-pre-encoded source, like only Soundstorm can.

    Can the MSI do this now too??
  • RyanVM - Monday, February 28, 2005 - link

    Why didn't you guys bother to note that the Si3132 SATA controller is PCIe? I think that's a fairly significant point in comparison to the PCI Si3114 controller and it likely explains why the Si3132 was faster.
  • Lakku - Monday, February 28, 2005 - link

    I wish you would have discussed 6600GTs in more detail. I am perturbed at a number of sites saying the 6600GT is not worth it for SLI. Specifically from X-Bit (though many have echoed it) "We guess it is the 6600GT SLI configuration that's not very appropriate". The only fact for this statement is the lack of a 256MB 6600GT card. This means its high resolution on some games and FSAA capabilites are limited. But so what? Noone has discussed REAL WORLD prices of 6800GT and Ultra cards. They range from 430 to 800 dollars, for ONE card. Yet sites claim it's better to just get a 6800GT rather then two 6600GTs. I picked up my 6600GT for 170 bucks, brand new retail. It overclocked to 550/1100 easily and I kept it at that, even though it went quite a bit higher with air cooling. I put that in because it gave me another 5%-10% or so increase over stock speed. I could get two for just over 350, almost $100 cheaper, and in a majority of tests, it equals or BEATS a 6800GT. It only suffers when you get to 1600x1200 with FSAA, as its smaller frame buffer and 128-bit interface is a hinderance. But for such a HUGE price difference, is it not worth it? If I had bought two outright (my plan was to get a start on a PCIe based system to bring me up to date for the future, and then buy the next generation cards for SLI), I could use that extra 100 for the GF7600GT (I am assuming this name, and the fact that if the next generations are 24 pipes, then the mainstream will be 12) that when SLId, will be up there in terms of todays speed on 700 to 1000 dollar video combinations, all for under 400. The point is that I wish someone would actually take an IT type approach to this situation instead of badmouthing SLI or the price for running an SLI setup. You get SLI now, be cost effective and get 6600GTs, and you have a great platform for the next generation (if it still exists, but nVidia seems to have put its eggs in this basket so I assume it will be around for awhile) of cards that you can SLI and get great performance. Is SLI worth it? I say the answer SHOULD be a resounding yes if the same performance holds true for the future. It means you can always get two mainstream cards to equal ONE high end card, for a much cheaper price.
  • chup - Monday, February 28, 2005 - link

    Is the SB Live! 24 really capable of encoding audio stream into Dolby Digital stream?

Log in

Don't have an account? Sign up now