Kioxia (formerly Toshiba Memory) has launched their sixth generation enterprise SAS SSD, the PM6 series. This is the first SSD available to support the latest 24G SAS interface, doubling performance over the existing 12Gb/s SAS standard. Using 96-layer 3D TLC NAND flash memory, the PM6 offers capacities up to 30.72 TB and performance up to 4300 MB/s.

Serial-Attached SCSI (SAS) originated from the simple idea of running the enterprise-grade SCSI protocol over the Serial ATA physical layer, obsoleting parallel SCSI connections in the same way that SATA displaced parallel ATA/IDE in the consumer storage world. The first version of SAS corresponded to the second generation of SATA, with each running at 3 Gbit/s. SATA became a dead-end technology after one more speed increase to 6 Gbit/s, but SAS development has continued to higher speeds: 12Gbit SAS-3 was standardized in 2013 and "24G" SAS-4 was standardized in 2017. The "24G" is in quotes because SAS-4 actually runs at a raw rate of 22.5Gbit/s but delivers a true doubling of usable data rate by switching to lower-overhead error correction: 8b/10b encoding replaced with 128b/150b (actually 128/130 plus 20 bits of extra forward error correction), similar to how PCIe 3.0 switched from 8b/10b to 128b/130b to deliver 96% higher transfer rates with only a 60% increase in raw bit rate. Also similar to PCIe, it takes quite a while to go from release of the interface standard to availability of real products, which is why a 24G SAS SSD is only just now arriving.

Kioxia's enterprise SAS SSDs and their enterprise NVMe SSDs share the same bilingual controller ASIC and consequently the PM6 has a very similar feature set to the previously-announced CM6 PCIe 4.0 SSDs. This includes dual-port interface support for higher performance or for fault tolerance, and enough ECC and parity protection for the drive to survive the failure of two entire flash dies. The SAS-based PM6 series is limited to lower maximum throughput than the CM6, but a dual-lane 24G SAS link is still slightly faster than PCIe 3.0 x4. The higher performance enabled by 24G SAS means the PM6 can require more power than its predecessors—now up to 18W, though the drive can be configured to throttle to lower power levels ranging from 9W to 14W.

Kioxia Enterprise SSD Specifications
Model PM6 SAS CM6 NVMe
Form Factor 2.5" 15mm U.3
Interface, Protocol Dual-port 24G SAS PCIe 4.0 x4, NVMe 1.4
NAND Flash Kioxia 96L 3D TLC
Capacities (TB) 960GB,
1.92TB,
3.84TB,
7.68TB,
15.36TB,
30.72TB
800GB,
1.6TB,
3.2TB,
6.4TB,
12.8TB
400GB,
800GB,
1.6TB,
3.2TB
960GB,
1.92TB,
3.84TB,
7.68TB,
15.36TB,
30.72TB
800GB,
1.6TB,
3.2TB,
6.4TB,
12.8TB
Write Endurance 1 DWPD 3 DWPD 10 DWPD 1 DWPD 3 DWPD
Sequential Read 4.3 GB/s 6.9 GB/s

The PM6 SAS family is available in three endurance tiers: the 1 DWPD and 3 DWPD models closely correspond to CM6 NVMe models, but only the SAS product line gets a 10 DWPD tier. Maximum capacities are 30.72 TB in the 1 DWPD series, 12.8 TB in the 3 DWPD series and 3.2 TB in the 10 DWPD series. Kioxia said that 4 TB class drives are still the most popular, but this will probably be shifting toward the 8 TB models over the next year or so. The 30.72 TB models will remain more of a niche product in the near future, but they expect demand for those capacities to start picking up in 2021 or 2022. Detailed performance specifications for each model are not yet available.

SAS in general is still a growing market both in terms of number of units and bits shipped and is projected to continue growing for at least a few more years, even though NVMe is gradually taking over the enterprise SSD market. Kioxia's customer base for SAS SSDs has been divided between storage array vendors and the traditional enterprise server market. The storage array market has been quicker about migrating to NVMe so this may be the last generation of SAS SSDs to see significant adoption in that market segment. SAS will be hanging around in the enterprise server market for a lot longer, helped in part by the backwards-compatibility with SATA hard drives for cheap high-capacity storage, and the straightforward traditional RAID solutions as compared to the challenges with NVMe RAID. The server market typically doesn't make as much use of the dual-port capability of SAS drives, so the speed boost from 24G SAS will be particularly welcome there, allowing drives to now reach about 2.3GB/s each rather than about 1.1GB/s on 12Gb SAS.

The Kioxia PM6 SAS SSDs are now available for customer qualification and evaluation. The drives have already been validated with 24G SAS host controllers from both Broadcom and Microchip (Microsemi/Adaptec).

Source: Kioxia

Comments Locked

31 Comments

View All Comments

  • romrunning - Tuesday, June 16, 2020 - link

    Note: the chart needs an update -the PM6 is missing the 30TB size under the 1 DWPD model.
  • Billy Tallis - Tuesday, June 16, 2020 - link

    Thanks. Copy and paste error on my part.
  • danbob999 - Tuesday, June 16, 2020 - link

    What's the point of SAS 12 and 24 G over NVMe?
  • DanNeely - Tuesday, June 16, 2020 - link

    1 link vs multiple PCIe lanes. It's why big storage vendors are pushing so hard for PCIe5 (and then 6); because a single 5.0 lane will have as much bandwidth as a 3.0x4 letting them cram a lot more drives onto a single mobo without needing PLXes to expand the nominal PCIe lane count.
  • schujj07 - Tuesday, June 16, 2020 - link

    The need for PLX is only if you use Xeon hosts. Using 2nd Gen Epyc a dual socket host can fully address 24x PCIe 4.0 x4 NVMe SSDs and still have 4x PCIe 4.0 x16 slots for dual port 100Gbps NICs. A single socket 2nd Gen Epyc can do the same just with 2x x16 slots.
  • DigitalFreak - Tuesday, June 16, 2020 - link

    Some companies want to stick with Intel, so...
  • Deicidium369 - Tuesday, June 16, 2020 - link

    Ice Lake SP offers 128 x PCIe4 lanes in a dual socket config - launching soon... and PCIe4 will become main stream
  • AnarchoPrimitiv - Friday, June 19, 2020 - link

    It's still only half the lanes of a single Epyc CPU which has x128 PCIe 4.0 lanes
  • amnesia0287 - Saturday, June 20, 2020 - link

    A dual socket Epyc will also still have 128 lanes...
  • Deicidium369 - Tuesday, June 16, 2020 - link

    PLX is used in large arrays (EMC) and are host independent. Intel Dual Ice Lake SP will also support 128 PCIe4 lanes - and will finally kick off the PCIe4 storage era.

Log in

Don't have an account? Sign up now