In many of the examples you have seen so far, you notice that the Nexus 5 has a large issue with the left channel at peak volume levels. As Brian mentions in his Nexus 5 review, it is based on a similar platform to the LG G2 but it isn't identical. Because there are similarities I want to test it out and see if it has the same issue that I see on the Nexus 5.

The test that is causing the large issue on the Nexus 5 is a 1 kHz sine wave, at -0dBFS, at maximum volume. This is the loudest sound that any device will be asked to produce. If you're familiar with the trends in music mixing the past two decades you'll know that a peak of -0dBFS is not all that uncommon now. This chart at NPR shows the average and peak levels for the most popular songs over the past thirty years. Two decades ago testing for -0dBFS might not have been important but it is now. So lets look at this image from the Nexus 5 again.

Now for comparison, we will look at the LG G2.

This looks much better. However the LG G2 is still putting out 0.546528% THD+N into the left channel while only outputting 0.003338% into the right channel. So there is still some imbalance going on here. So why is the issue so much less on the G2 than on the Nexus 5?

The key to this is looking at the scale on the graphs here. While the Nexus 5 peaks are up close to 1.3-1.4V, the G2 has peaks that don't even reach 700mV. Looking at the actual numbers the G2 has a Vrms level of 475.3 mVrms while the Nexus 5 checks in at 843.6 mVrms for the left channel and 982 mVrms for the right channel. The G2 is placing far less stress on its headphone amplifier and keeping it from the output levels that cause this excessive clipping in the Nexus 5.

To look in more detail, we have THD+N Ratio charts for the stepped level sweep that we looked at earlier. First, lets look at the Nexus 5.

We see that the first three volume levels, 15-13, have THD+N distortion over 0.3% for the left ear, while they are below 0.01% for the right ear. From level 12 and below the THD+N levels are practically equal. Now to see how this data on the G2 looks.

We see the first volume step has 0.55% THD+N or so for the left ear, but the right ear is down at a similar level to level 14 on the Nexus 5. The next step drops it to 0.03% which is way, way below where it is on the Nexus 5 at that point. By step 13 they are equal.

The conclusion I pull from this is that both the G2 and the Nexus 5 have the exact same flaw right now. However, the G2 has attempted to hide it by reducing the maximum output level of their headphone amplifier. The Nexus 5 can play louder, but only with far more distortion. Given this I would expect there to be an update to the Nexus 5 at some point that lowers the maximum headphone level to something closer to the G2.

However this doesn't mean that the Nexus 5 is certainly worse to use with headphones. The top 3 settings are ones I would avoid due to the left channel issue, but I might avoid the top 1-2 settings on the G2 as well. If we consider 1% THD+N to be the maximum allowable level, that leaves 8 volume steps on the Nexus 5 that are usable. The G2 has 9 steps that are available to you, and 10 if you consider 0.03% THD+N in one ear to be OK (it probably is).

In the end, the G2 won't play as loud as the Nexus 5 will, but you don't want to play that loud anyway. It has more usable volume steps than the Nexus 5, and otherwise very similar numbers. I'll be interested to see if either of them make further changes to their maximum output levels to remove this issue.

Dynamic Range, Crosstalk, and Stepped Response Additional Data
Comments Locked

188 Comments

View All Comments

  • Impulses - Monday, December 9, 2013 - link

    All great suggestions IMO.
  • haukionkannel - Tuesday, December 10, 2013 - link

    I allso agree. Maximum volume level is not the same as guality, you have to find measures that are relevant in normal listening volumes. They vary yeas and depends a lot of used headphones. So I would allso recommended of using headphones with different impedanses! One pair of high impedance hifi headphones. One pair of low impedance hifi headphones and one pair of high guality (but commonly used) low impedance headphones.
    Otherwise it would be like testing 780 triple sli setup using 320p resolution mini monitor...
    (Well actually not likely because phones have not been very high guality sound sourses, but I think that you got the point.) Good sound qaulity is important factor to me, so I am very eager to hear more (pun inteded ;-) about these test and allso the results!
  • DaveSimmons - Monday, December 9, 2013 - link

    Thanks for doing this. When my 120 GB iPod dies I'll probably replace it with a smartphone or tablet, so this will help me choose which one to use.
  • estarkey7 - Monday, December 9, 2013 - link

    As others have stated, and I will reiterate, Only Anandtech! Bravo!

    I would love to see a similar article comparing HD Voice for the carriers. I know that test may be more difficult to conduct, but ever since Sprint hyped their HD Voice and didn't deliver, I'd like to see some real engineers do the topic justice.
  • hlovatt - Monday, December 9, 2013 - link

    Congratulations AnandTech, yet again you show the rest of the review industry what they should be doing. Keep up the good work and it should be fascinating to see the full set of results. Thanks.
  • willis936 - Monday, December 9, 2013 - link

    Is there any comment on the practical issue of noise at low volumes? Noise floor testing is uncommon but phones are noisy and are typically listened to with sensitive buds. Who cares it'd the dynamic range is 100dB if you never turn the volume up past 30%?
  • pr1mal0ne - Monday, December 9, 2013 - link

    I disagree with you testing all phones at maximum volume level
    1) the max volume differs, some companies may reasonably make the choice to let quality suffer while volume improves. at the least volume needs to be reported alongside these quality discussions. Preferably it would be set to a base volume and tested there.
  • Tuxedo - Monday, December 9, 2013 - link

    Amazing article. I have always been impressed with audio quality on iPhones and disappointed with GS2, GS3, Atrix, Lumia 900 and now OG-Pro. Really shows how much attention Apple pays to the products they build.
  • edwh - Monday, December 9, 2013 - link

    what about output impedance?
  • fishjunk - Monday, December 9, 2013 - link

    I don't really use the audio jack on my Nexus 5. Are there any tests done on the phone mic and speakers.

Log in

Don't have an account? Sign up now