Subjective Evaluation: TECK It to the Limit (One More Time!)

Bad puns aside, let me be very clear at this point: the layout and arrangement of the keys on the TECK is very different, more so than you might imagine just by looking at the pictures. Logically and to my eyes, the TECK layout makes a lot of sense, but when you first sit down to use it you’re going to be in for a rude awakening. Truly Ergonomic recommends giving yourself at least a few days, maybe a week or two, or perhaps as long as a month to adapt to the changes in the layout. While there’s a huge difference between a few days and a month, some people adjust more quickly than others and there’s still going to be improvement past the one week mark.

Personally, the first day (and in particular the first hour) using the TECK was a nightmare, with my typing speed going from around 65-70WPM on “normal” keyboards to less than 10 WPM with the TECK. Yeah, it’s that different! I had a friend come by who can type around 80 WPM and told her to just sit down and try a one minute typing speed test (with no warm up) on the TECK. She managed 5 WPM on her first go, but with an average number of errors of 6 WPM, for an adjusted speed of… zero. That’s likely where everyone will start, and you’ll have to dedicate at least an hour or two to the TECK before you become anywhere near proficient. As I mentioned in my First Impressions piece, the initial learning curve can be extremely frustrating, so you should plan for that. If I could have accurately captured my typing speed every few minutes over the course of learning the TECK, I imagine the plot would look something like this:

I can’t say whether the ramp in typing speed will happen in minutes, hours, or days, but it will happen if you stick with it (and preferably don’t swap back and forth between keyboards). After a couple days of typing, I was able to reach about 90-95% of my normal typing speed, and by the time two weeks had passed I was at 100% and perhaps a bit faster. Now, I just took the same typing tests as I used in the initial article, and I’m clearly faster with the TECK than with my previous keyboard. My scores, if you’re interested, are 76WPM on test 1 (0 errors), 78 WPM (1 error = 77 WPM) on test 2, and 70 (1 error = 69 WPM) on test 3. All three scores are up 3-5 WPM compared to my initial results, presumably thanks to the improvement in the ergonomics and the reduced range of motion required for typing. I also recorded the following video, after I was acclimated to the TECK, to see if I could notice a difference in the way I type.

Obviously there are some major differences in the number of mistakes I make on the Rosewill, but more noticeable to me is how my hands just look a lot more natural and don't appear to work as hard on the TECK. I’m by no means an expert typist, but objectively my typing speed is up slightly while subjectively I also feel as though my hands manage better with extended typing than on a regular keyboard. That's enough reason for me to give serious consideration to using the TECK on an extended basis.

While my typing experience is improved in many ways, there are some aspects of the TECK that I still haven’t quite adjusted to, and still other areas where I definitely feel I’m missing something I’d rather like to have. The lack of a dedicated 10-key is one such complaint that I've already touched on; I understand the idea behind making the TECK narrower than a traditional keyboard and bringing your mouse in closer, but I just don’t find it particularly necessary (for me; others might feel differently). The times when I’m using a mouse, I’m often not using the keyboard much—or else I’m playing a game. The placement of the cursor keys and document navigation keys already would reduce the width by a couple inches, and while the 10-key would still add three inches that’s a compromise I’d prefer to make. The reason is simple: I can’t reach normal 10-key speed with the TECK, not even close, and I make far more errors than I’d like. To illustrate, here’s another set of typing results, without any real warm up on either keyboard:

Regular 10-key: 7036 keystrokes per hour with 0 mistakes
TECK 10-key: 2914 keystrokes per hour with 0 mistakes

Now, part of the speed reduction is because I intentionally worked hard to not make any mistakes; there were plenty of errors and I had to go back and correct them. If I were doing dedicated 10-key input looking at a sheet of paper rather than the display, I would have had numerous errors and it would take a significant amount of time to improve. Errors in numeric input tend to be a lot more alarming than errors in text (hello accounting!), so I simply wouldn’t feel comfortable recommending the TECK to someone who does that sort of work without also recommending a separate 10-key—which not only eliminates the space saving benefit of the TECK but actually ends up being worse as you now have a second device cluttering up your desk.

I have a couple of other stories that I also want to relate, one illustrating the potential for problems with a revamped keyboard layout and the second that may be more about how I type (or perhaps my review keyboard). The first comes from my typing up of a review, the Dell XPS 12 Ultrabook if you’re curious. I normally type a significant portion of each laptop review on the laptop, in order to evaluate the keyboard, but since I was in the middle of working on the TECK review I didn’t want to “corrupt” my adjustment and so I was using the TECK (though previously I had done a decent amount of typing on the XPS 12 so I knew I liked it compared to many other Ultrabook keyboards).

During the course of the review, I had written about two thirds of the text (around 3000-4000 words, including the specs table), and for whatever reason I simply hadn’t saved most of that content. One evening I sat down to write some of my thoughts on Windows 8; unfortunately, while typing I pressed the left Control key instead of the Shift key out of habit (remember that the Shift on the TECK is on home row instead of adjacent to the Z). Instead of “Windows”, that became: CTRL+W, “Do you want to save the changes to ‘XPS 12 Review.docx’?” No. I was typing fast, so the “n” in Windows came along right around the same time that the dialog asking if I wanted to save popped up. Poof! The document was gone without being saved, and the scream of agony that escaped my mouth caused my wife and children to jump in alarm. Sadly, despite using several undelete utilities to see if I could find the auto-recovery file I failed and ended up having to rewrite most of that content. Blame me, blame Word 2007 (I’m old school, unlike Vivek), blame the TECK, whatever. The fact is, stuff like this can potentially happen, so you’ve been warned (again). It’s like a game: remember to save your progress regularly.

The second item that’s on my annoyance list might be more from the way I use the TECK than anything, but try as I might I still encounter the problem on occasion. When I first started using the TECK, I didn’t notice this, so either I adapted in some incorrect fashion to the MX Brown keys, or I got a flaky unit—but I’m more inclined to think it’s the former than the latter. With certain keys, I now get a periodic doubling of the character. Initially, this was happening with the “E” key, and at one point it was happening about 25% of the time. That’s a problem when you’re dealing with the “most common letter in the English language”, and I even went so far as to remove the key cap to see if something looked wrong with the switch (it looked perfectly fine, though it did seem to work better afterwards so maybe there was some grit in the switch). One key out of 86 having a bad switch would be possible, but then I started getting the problem with the “I” key as well. In both cases, it’s my middle finger reaching up to hit the respective key, and at this point it probably only occurs about 1-3% of the time (depending on what I’m doing), but it can be irritating and it often comes in spurts. If the problem is actually with the switch, Truly Ergonomic would be happy to replace it, but I'm actually not sure that's the case.

Finally, just to comment on the TECK in general, the keys come with a slightly textured finish. This in itself isn’t particularly noteworthy, but after just one month of typing I’ve found that many of the keys are starting to get a glossy sheen—the right spacebar in particular has a noticeable glossy mark, which you can see in the picture above, and I expect other keys will develop the same wear markings over time. I wouldn’t necessarily want them to change the keys, and I’ve had the same thing happen on pretty much every keyboard I can think of in recent years, but if that sort of thing bothers you it will be a concern with the TECK.

TECK: Rethinking Ergonomics Closing Thoughts: A New Spin on Ergonomics
Comments Locked

126 Comments

View All Comments

  • branney - Saturday, July 6, 2013 - link

    Oh dear.. The curved staggering on the keys is a good idea, so why on earth did they go with this cursor key layout? On a standard inverted T the index finger naturally sits between the up and down cursors. For a standard keyboard user down and up will be used equally so this does not need to be changed. The layout on the TECK favours the UP key, and this layout was only really useful back in the 80s when it suited platform games (up to jump) and racing games (hold up to accelerate). Major fail in this regard..
  • hansmuff - Thursday, March 7, 2013 - link

    I'm so happy to see this keyboard reviewed! Very few sites review stuff like that, and I actually eyed this very keyboard a while ago before it was released. I think I will hold off until I see your review of the Kinesis. That has me similarly tempted, but it is so hard to get a good comparison between that and conventional keyboards; to have the opinion of a TECK user thrown in there as well makes it gold!

    Thank you, this has been helpful.
  • friedpenguin - Sunday, March 24, 2013 - link

    The Kinesis Freestyle is frakkin' awesome to say the least. Get the tilt kit so you can have it at two different heights plus the freedom to angle each half however you want makes for some incredible comfort and the typing experience is great. I've had mine for a couple years and have never had a better keyboard. It's also great for multiple users because you can slip the halves together for a more common keyboard feel for those not used to a 'natural' keyboard. It's also great for gaming since you can push the right half out of the way to bring your mouse in closer.
  • cosmotic - Thursday, March 7, 2013 - link

    The second page of this article points lots of fingers at QWERTY. Might I recommend reading this article: http://reason.com/archives/1996/06/01/typing-error...
  • Klug4Pres - Thursday, March 7, 2013 - link

    What a great article! The myth of Dvorak's superiority comprehensively and stylishly debunked.
  • JarredWalton - Thursday, March 7, 2013 - link

    Interesting read. I have actually never fully committed to trying Dvorak, simply because the change is so massive that without properly labeled keys I don't know that it would be worth the time. There's no question that QWERTY has some odd decisions in the modern typing world (e.g. why are so many popular letters on on home row, like E, S, T, and R?), but proving that something is clearly superior to QWERTY is quite difficult. Personally, unless something can either dramatically improve my typing speed or dramatically reduce fatigue/RSI, it's not worthwhile. Fact is, much of the time when I'm writing I'm actually waiting on my brain to figure out what to say next, not waiting for my fingers to type the sentence. :-)

    On the other hand, that article doesn't seem to prove QWERTY is superior; just that it's not significantly worse than other options. If something were to reduce fatigue and strain by 10% relative to QWERTY, even if I typed at the same speed, that 10% would be worthwhile. Perhaps even 5% would be worthwhile, but that's probably pushing it. They seem set on disproving the QWERTY myth, and they accomplish that, but they don't ever show that QWERTY is best. Which is why the comparison with x86 momentum remains appropriate in my mind; x86 isn't a terrible ISA by any means, particularly today, but we continue mostly to use it because of software compatibility and the fact that Intel is the best fabrication company than for any other reason.
  • piroroadkill - Thursday, March 7, 2013 - link

    Not even close.

    To suggest QWERTY was designed ergonomically for our keyboards is false.
    Dvorak is not the best, but at least he was making an attempt at designing a better keyboard layout.

    It is a worthy pursuit, and far from worthless. QWERTY is an awful design.
    Just look at the position of J, for crying out loud. One of the least used letters, right there under your right index. Worthless.
  • Stuka87 - Thursday, March 7, 2013 - link

    QWERTY was designed to slow typers down to prevent jamming old type writers.

    Unfortunately we will be stuck with it for the long term.
  • uc404s - Thursday, March 7, 2013 - link

    That was an incredibly interesting article. Thanks for sharing.
  • Silma - Thursday, March 7, 2013 - link

    This is a political vindictive us-vs-them article that unfortunately deters even more from research in the field.
    Not defending the dvorak layout but notice how all his studies are based on proficient qwerty typers. It would have been fairer to also include test groups with 0 typing experience as well as test groups with typists having only ever typed in Dvorak and then retraining to qwerty.
    Also the only metric is speed where other aims may be more suitable: least finger traveling, non-rts-promoting typing patterns and so forth.
    In any case r&d should be promoted as we know much more than they did then, have the computing power to do deep simulations and that the production cost would not skyrocket, the same way it isn't that expensive to manufacture other international layouts.

Log in

Don't have an account? Sign up now