ASUS ROG STRIX Z370-G Gaming

The 'Strix Z370-G Gaming' micro-ATX motherboard bridges the gap between the ATX and ITX segments and represents a balance of having key features of its bigger ATX brothers, but whilst having a slightly larger footprint and offering more room for expansion over its ITX siblings.

This board has virtually identical specifications to the smaller Strix Z370-I Gaming board: the Strix Z370-G uses the Realtek ALC1220 audio codec, renamed to the SupremeFX S1220A in accordance with their branding; they also share the same dual antenna 802.11ac MU-MIMO capable Wi-Fi adapter as well as an Intel I219-V Gigabit Ethernet controller.

The Strix Z370-G Gaming has two PCIe 3.0 x16 slots (run in x16 or x8/x8) which both feature SafeSlot with support for both two-way SLI and two-way Crossfire configurations. The only limitation with this is slot spacing as due to PCB sizing limitations, only cards with coolers two slots or below will manage to fit in multi-GPU setups; a good way of beating this is with custom water cooling, but this comes at the requirement of extra space in the chassis as well as cost (we also think that NVIDIA has stopped giving SLI certification to micro-ATX boards with the main slots in the 1/4 configuration). Below each of the full-length PCIe slots are PCI x1 slots for installation of various types of expansion cards or adapters.

There are plenty of options for storage as the Z370-G Gaming features six SATA ports and two M.2 PCIe 3.0 x4 slots. Although not so much of a major concern, and more of a casualty of lack of PCB space, ASUS had to think outside the box to fit dual M.2 slots on this board. One of these M.2 slots can be found just below the second PCIe 3.0 x16 slot, but the implementation of the second one is a little unorthodox. It can be found to the right of the DIMM slots, just below the 24pin ATX motherboard power connector and actually sticks out vertically out into the case. This can be looked two ways: firstly it could potentially allow natural thermodynamics and airflow to keep the drive cool and secondly, a bit of a heretical design, especially for fans of cleaner looking systems.

ASUS seems to have focused a lot on memory compatibility with the launch of Coffee Lake, either that or their R&D team has had some very good yields throughout samples as all of their Z370 boards at launch are rated to have support for at least DDR4-3866. The Z370-G goes above this, following suit with the Strix Z370-E and Z370-F Gaming models, as all three boards feature four DIMM slots capable of supporting up to 64GB but also have compatibility for memory speeds of up to DDR4-4000, CPU memory controller permitting. Scattered around the board are four variable fan headers which allow use for PWM compatible fans in addition to a dedicated pump header for water cooling and a single thermal sensor header.

A common and clear trend with the majority of the Z370 line up from ASUS is the use of the Intel's I219-V Gigabit LAN controller combined with the rebranded SupremeFX S1220A (Realtek’s ALC1220) audio codec. For micro-ATX, the board has plenty of bells and whistles with 2x2 802.11ac MU-MIMO Wi-Fi, two USB 3.1 10Gbps Type-A ports, two USB 3.1 5 Gbps ports, and two USB 2.0 Type-A ports. Unfortunately, there are no Type-C ports whatsoever featured, although a combo PS/2 port is present in its place.  There are available headers for a front panel USB as well as headers for two more USB 3.1 5 Gbps ports and up to four USB 2.0 ports in total. The display output from the CPUs on-board graphics can be utilized via a single HDMI port with a DisplayPort nestled right above it. Finishing off the rear I/O is a selection of 3.5mm audio jacks and a digital S/PDIF output.

ASUS ROG STRIX Z370-E & Z370-F Gaming ASUS ROG STRIX Z370-I Gaming
Comments Locked

83 Comments

View All Comments

  • sor - Friday, October 20, 2017 - link

    Damn. At least key it differently and call it LGA1151v2 or something.

    The changes are so minimal it really does seem like planned obsolescence. Does it really need more power pins to support new chips with the same power envelopes? Really? They couldn’t handle that on the CPU PCB?
  • KaarlisK - Saturday, October 21, 2017 - link

    Actually it is ~1.5 times peak current with the same average power envelope, so yes, they need the change.
    If they had not brought the launch forward and just launched together with the cheap chipsets, there would be far less complaints.
  • sor - Saturday, October 21, 2017 - link

    Where did you find information indicating current has increased 50%? I just spent about ten minutes trying to find a reference backing that up, perhaps something indicating the 8 series operates at a much lower voltage within same TDP, which would translate to higher current but they seem to operate in the same 1.2-1.3v range.

    You’re not just assuming they draw more current because they have two more cores, are you?
  • KaarlisK - Sunday, October 22, 2017 - link

    Notice the difference between average and peak.
    And the information is in publicly available documents. I did not bother to look it up, but others have, for example: https://forum.beyond3d.com/threads/intel-coffee-la...
  • Crono - Saturday, October 21, 2017 - link

    Nice roundup. That's a lot of motherboards to spec and summarize. I especially appreciate the handy chart at the end, it's a good, quick-and-dirty comparison tool.
  • Landcross - Saturday, October 21, 2017 - link

    You guys forgot 2 new Z370 boards from Supermicro :)

    https://motherboarddb.com/motherboards/?chipset=19...
  • Xpl1c1t - Sunday, October 22, 2017 - link

    The mITX board looks incredible.

    + Low ESR Tantalum capacitors! (first time seeing them on VRM duty on a mainboard)
    + HDMI 2.0
    + 2x M.2 Slots
    + USB 3.1 Type C
    + Optical SPDIF

    - RGB.......
  • MadAd - Saturday, October 21, 2017 - link

    Great write up but for me its just another depressing generation of oversized, overpriced ATX form factor offerings on which the vast majority of users wont even plug a second gpu into, with the smaller and more size appropriate FF represented as a minority afterthought.

    With all the progress of PCs since the 90s whod have thought that I could still use the same ATX case today while every single other component (from floppy drives to 2d Mattrox cards) have long gone to the recyclers. I find it so annoying how manufacturers have stuck on this prehistoric gargantuan case size with the other sizes being an afterthought. It feels like like stifled innovation while everything else is moving on.
  • rocky12345 - Saturday, October 21, 2017 - link

    Great article and a lot of work put in to get it out for us to read thank you.

    My only issue is and it is nit your fault is why these companies feel the need to totally blanket the market with basically the same boards just a different model number and basically a few tiny changes and spray paint it a different color and use the word gaming and put something x or x1 or k,k3 etc etc. For crap sakes just release three models not 7-10 models of the same crap it is pretty much just greed I guess.

    The whole market is like this now with anything computer related of and if it has the words GAMING or RGB in it's got to be good for sure. My fav is that gaming mouse pad next it will have RGB lighting in it...lol
  • CitizenZer0 - Wednesday, October 25, 2017 - link

    Agreed

Log in

Don't have an account? Sign up now