Corsair Vengeance C70 Case Review: Going for the Gamers

Assembling the Corsair Vengeance C70

I've gone on record repeatedly as saying the only way Corsair cases could be easier to assemble would be if Corsair included an engineer with them to just do the whole thing for you, so imagine my surprise when assembling the C70 turned out to be a hair more fraught than I'm used to experiencing from them. It's still worlds easier than many competing brands, but there were a couple of hitches.

Maybe it was just my review unit, or maybe it was just my rotten luck, but I found installing the motherboard to be unusually difficult despite the fact that Corsair includes both a mounting post (for the center screw hole of the motherboard) and pre-installed mounts in the tray. The problem is that the mounts used are actually in unbelievably tightly (the top six are permanently affixed to the tray), and the screw holes for them don't seem to have been machined quite wide enough. That, or the green paint used for the finish is abnormally thick, but either way I wound up having such a hard time moving the mounts that I just left the side of the board "dangling." I also had one of the screws I was using actually break inside a mount. I can see all of this being much easier for someone else, and if you use a standard ATX motherboard you won't even have to bother with moving the mounts.

Installing our optical drive in a 5.25" bay was a little different, too. The bay shields are in very securely, and to remove one I wound up having to actually remove the front fascia of the case. Once I did so, though, the optical drive went in with just a bit of force (which is common), and the toolless mechanism (along with general tension of the drive cage) actually holds the drive in very securely without a need for screws.

Everything else went pretty swimmingly after those two, though. The drive trays continue to be very easy to work with, snapping neatly onto 3.5" drives while 2.5" drives screw into the bottoms of the trays. Expansion cards go in just as easily, with thumbscrews holding the expansion bay shields in place. And of course, the power supply went in without a hitch.

Corsair has almost perfectly evolved cable management in the C70. There's a healthy amount of clearance above the motherboard (owing to the space needed for a 240mm radiator and fans) that makes connecting the AUX 12V line a breeze. Meanwhile, routing cables behind the motherboard tray just got even simpler, as the channels in the tray help direct the cables while the included clamps allow you to essentially lock everything down. Cabling was ultimately unbelievably simple, and every other vendor should be taking note here: this is how it's done.

Despite hiccups with the motherboard (and to a much lesser extent the 5.25" bay), Corsair continues to set the standard for ease of assembly and service, and I can't wait to see these advances appear in future designs of theirs.