Enermax Pro82+



The name Pro for the Pro82+ series leaves the impression that it is for professionals. If these units are for the pros, then who is the intended user of the Modu82+ series? Anyway, the Pro82+ series differs from the Modu82+ only in its color and lack of cable management. As with the Modu82+ series, we have the claim of 88% efficiency, which is very high and not easy to reach.





We were lucky enough to get a lower wattage version of this series with 385W and the biggest version with 625W. The smaller version shows 20A on the 3.3V, 5V, and both 12V rails. The combined power of the 3.3V and 5V rail is 110W. Both 12V rails come with 30A combined which is 360W. The bigger brother has 24A on the smaller voltage rails and 25A on the three 12V rails.

Modu82+ Internals Continued Pro82+ Package and Appearance
POST A COMMENT

17 Comments

View All Comments

  • Bremen7000 - Tuesday, March 25, 2008 - link

    Horizontal bar charts for price? Really? I guess when all you have is a hammer... Reply
  • Woodchuck2000 - Thursday, March 27, 2008 - link

    Well put...

    One of the shoddier reviews I've seen on Anandtech for quite some time, including some shocking graph abuse and grammatical errors throughout.

    In the DC Output Stability and Quality section, There are four PSUs in the top three graphs and then only three shown in the analysis below. Which 525W supply is that?

    In the graphs below, I assume the numbers at the lower half of the nonsensical Y-axis are meant to be negative? And is the load percentage on the X-axis a percentage of total rated PSU capacity, or rated line current. And in either case, are other lines loaded and if so how? You'd expect completely different 12v load characteristics depending on which other lines are loaded any how much.

    "In case of ripple and noise, we were surprised to see very little distortion on the rails. The highest amount of ripple on the 12V rail was 16mV for example. The other rails were similar except the 5Vsb rail, which went a little high. That's pretty common, unfortunately."

    Why is that surprising? How did you measure ripple? Is that amplitude or peak above rated? A little high under what circumstances? Why's that common, and if it's only the 5V Standby Rail, why is that necessarily unfortunate? The whole article is full of meaningless generalisations like that one...

    Anandtech has enough quality writers not to need filler like this. All in all, D-
    Reply
  • C'DaleRider - Tuesday, March 25, 2008 - link


    Apart from the upgrade in caps, there seems to be no design improvements. On the contrary, the workmanship looks a bit dodgy. I'd wait to see if these blow up left right and center after a year of use before passing a verdict.


    [quote]To our surprise, there are two main capacitors, which is something we don't see often in Enermax power supplies.[/quote]


    Whaaaaa??? Last I checked the entire FMA lineup had "two capacitors" on the primary side.
    Reply
  • Spacecomber - Tuesday, March 25, 2008 - link

    At the beginning of the section on the Pro82+, you state, "The package is quite different from the Modu82+ series and comes in completely different dimensions". I think that you were just describing the dimensions of the box that the power supplies come in, but the picture at the start of the article, where the power supplies are stacked on each other, gives the impression that the power supplies themselves might be of different dimensions.

    Can you confirm that the external dimensions are the same for all these new models? Are these power supplies of the typical size?

    Thanks.
    Reply
  • Christoph Katzer - Tuesday, March 25, 2008 - link

    Yes, only the package is different. Reply
  • strikeback03 - Tuesday, March 25, 2008 - link

    Your photo of the label for the big Pro82+ shows 625W, but your charts on pages 12 and 14 say Pro82+ 525W. Which was it actually?

    Didn't look elsewhere, but these are on Newegg right now for $10-30 more than you list in the review. The Infiniti 650 is priced the same as the Modu82+ 625W but the Infiniti ships free, and the Infiniti 720W is cheaper than either after a $25 MIR.
    Reply
  • Griswold - Tuesday, March 25, 2008 - link

    Any good reason (like you couldnt get ahold of one) for not including the 425W PSU of this line? Its by far the most reasonable of the three... too bad. Reply

Log in

Don't have an account? Sign up now