Noise

For many enthusiasts upgrading cooling the goal is maximum stable overclock, and they will live with the inconvenience of a louder system. For other users silence is the most important factor, and these users will forgo maximum overclocking if that increases system noise levels. Let's see how the Ultra-X compares with the other coolers we've tested in this area.

There are very few power supplies that do not have a fan. While Zalman and a few others do make expensive fanless power supplies, we have not seen a fanless unit larger than 500W, or one that would be used for seriously overclocking a system. With that in mind the noise level of the system with all fans turned off except the PSU was measured. The power supply used for the cooling test bed is the OCZ PowerStream 520, which is one of the quieter high performance power supplies.

We have also measured the Corsair 620W and Mushkin 650W power supplies which are reported to be quieter than the OCZ. Both the Corsair and Mushkin are indeed quieter at idle or start up speed. However, as soon as load testing begins and the PSU fan speed kicks up the measured noise level is almost exactly the same as the OCZ PowerStream 520W.

We are currently in the process of reevaluating our cooler test bed and planning some updates. The new configuration will include a "quieter" power supply with variable speed and noise levels. We will also update to a P35 chipset motherboard with all passive cooling to the chipset. Changes to the test bed will appear as part of a future roundup with the motherboard, PSU, and CPU all upgraded to more current configurations. We are also investigating a change to a quad-core processor as a further challenge to CPU cooling.

The noise level of the power supply is 38.3 dB from 24" (61cm) and 47 dB from 6" (152mm). The measured noise level of the test room is 36.4 dB, which is a relatively quiet room with a noise floor slightly below that of the OCZ PowerStream 520 PSU.

Noise levels were measured with the Enzotech Ultra-X fan at both low 1200 RPM speed and high 2500 RPM speeds. Both low and high measurements were taken at both the 6" and 24" distances above the cooling fan on an open case side. Results were then compared to the other coolers/fans tested in this category. Measured noise levels in this chart should be considered worst case. Measurements were taken with an open side of a mid tower case 6" and 24" from the HSF. Real world would be a completely closed case with a further reduction in noise. Please look for both low and high speed results in the noise graphs.

Noise Level - 6

Noise Level - 24

The measured noise levels at 6" and 24" do nothing to convince us that Delta fans are now quiet. When turned down to the lowest speed noise levels are below the noise floor, but air output is a fairly mediocre 35.8 CFM. Increasing fan speed to high raises CFM to a very respectable 83.7, but the price is noise levels that are clearly audible and among the poorest we have measured at 51.2 dB(A) at 24". There are other fans available that cool better at lower noise. Fortunately it is pretty easy to switch the stock fan for a quieter fan if that is your goal.

The Delta fan does provide a very wide range of cooling output, but there are better fans that provide higher output at lower noise at both the low and high output ranges. To our ears noise from the Delta fan was audible over much of the specified range. Overall noise results with the Delta fan are disappointing. There are many fans with similar output ranges - or even greater ranges - that are much quieter than the Delta used by Enzotech.

Overclocking Conclusion
Comments Locked

33 Comments

View All Comments

  • Wesley Fink - Thursday, June 28, 2007 - link

    Corrected
  • Barkuti - Wednesday, June 27, 2007 - link

    Too much fuss with all of these new massive coolers. Back in 1995 I purchased a Thermaltake Sonic Tower, which proved to be an incredible performer, best passive cooler IMO. The one being currently available is "rev2", guess it's just a mounting accesories update.

    The cooler comes with a mounting plate for a 12 cm fan, which can be installed on either side. I myself drilled new screwholes on a inner side to be able to install the fan in the center, saving a bit of space. A bit cumbersome to install the fan this way tough. Achieves top performance in this configuration, even with an ultra-low noise fan.
    An Anand's review of this cooler is still missing and I think it's really worth the pain, like a gem lost inside and old chest.

    And with a bit of skill, a little mod and a lot of space you may be able to install three fans on it... Drools about the kind of performance and perf/noise you could get this way, even with just 2 fans...

    Cheers
  • DrMrLordX - Wednesday, June 27, 2007 - link

    Is there a side intake duct or vent that can feed top-down HSFs in your test bed? I'm pretty sure top-downs just don't work well if they can't pull cool air directly in from outside the case (which is why they've done so well in open-air testbeds).
  • vhx - Wednesday, June 27, 2007 - link

    Definitely nice, but there are a lot better alternatives according to the results. Anyways, does anyone know whats up with Anandtech's forums? They've been down for like a week.
  • theprodigalrebel - Wednesday, June 27, 2007 - link

    The forums have been a little iffy of late but they most certainly haven't been down all week. They just had an update of the forum software and there were a few minor outages here and there - Opera users had some problems, so did IE users. Did you try deleting all forums.anandtech.com cookies? It should work.
  • Wesley Fink - Wednesday, June 27, 2007 - link

    The LATEST NEWS at the top of our AT Forums Log-In page:

    "Clear your cookies... - 06/24/2007 01:17 PM
    We recently updated our forum software to fix a number of issues. As a result, some users are having problems using FireFox on the forums.

    The fix for this is to delete your forums.anandtech.com cookies.

    We recommend that all members delete their forum cookies, though we haven't run into any technical issues with this in other browsers.

    Thanks for your patience while we continue to improve the forums."
  • Pirks - Wednesday, June 27, 2007 - link

    I've got myself A cooler master geminII and run it in passive (fanless) mode, and no fan on my passive mobo chipset heatsink as well. finally I've got a silent PC! my wife thinks my computer stopped working now, hehe :) no overclocking of course but who needs it for games anyway. I'm getting high framerates with S.T.A.L.K.E.R. around 30-40 fps and I'm happy. who says you need a mac to get a silent computer? who says gaming PCs are noisy? just ignore those noobs, they know nothing
  • deadseasquirrel - Wednesday, June 27, 2007 - link

    but it seems, at least according to this review, that it is not worth the price for the performance you get. Can anyone else see a better price/performance cooler than the Scythe Mine Rev B? For $38, with fan, and pretty quiet, it seems like a good choice. Oh, and are the forums down or am I having browser problems?
  • kmmatney - Thursday, June 28, 2007 - link

    I have a Scythe mine and am happy with. It's a good combination of price, low noise (its nearly silent) and good cooling. I don't know if I'd recommend it for extreme overclocking, but for stabdard overclocks it is great.
  • Goty - Wednesday, June 27, 2007 - link

    Based on the little knowledge I have about the inner workings of heatpipes, wouldn't the lower heatsink on the X-Ultra lower the efficiency of the heatpipes (where heat transfer to the main heatsink is concerned) and thus the whole cooler?

Log in

Don't have an account? Sign up now