Inside Microsoft's Xbox 360
by Anand Lal Shimpi, Kristopher Kubicki & Tuan Nguyen on November 16, 2005 5:09 AM EST- Posted in
- Systems
Disassembling the Internals of the Xbox 360
To continue further, you will need to first remove the DVD drive. Simply hold the drive and lift up. You will notice that the Xbox 360's DVD drive uses a Serial ATA interface which keeps things very tidy compared to the original Xbox. At this point, remove both the power supply cable and Serial ATA cable from the DVD drive and then from the motherboard.
The fan shroud can now be removed by simply twisting the cover until it pops off. The shroud is held in place by one clamp that attaches to the actual fans. Just be careful at this point not to break the clamp.
Next, remove the RF unit at the front of the Xbox 360 by removing the small black torx screws using a T6 screwdriver. Then you must remove the plastic cover on the front of the RF unit by unlatching the top and bottom of the plastic cover. Once you have done this, you will reveal the third screw holding the RF unit to the chassis. Remove the last screw and pull out the RF unit. Lastly, remove the power connections for the fans. You can now lift the motherboard out of the metal chassis.
As a reminder, the Xbox 360 is a delicate equipment and must be treated with care at all times. Ensure that you frequently ground yourself to discharge any build up static which can severely harm your Xbox 360.
91 Comments
View All Comments
Questar - Wednesday, November 16, 2005 - link
" We roughly estimated the power of the Xbox 360 GPU to be similar to that of a 24-pipeline ATI R420 GPU."What do you base this on?
Snuffles - Wednesday, November 16, 2005 - link
From the article:The reason for this can be found on Bizarre's Forums:
http://www.bizarreonline.net/forum/viewtopic.php?t...">Link
This essentially means that all later games which are built from ground up to include tiling, will feature free AA and a native 720p resolution. PGR3 had to go this route, because of lack of time with the final devkit and time restraints in order to make launch.
Questar - Wednesday, November 16, 2005 - link
" We roughly estimated the power of the Xbox 360 GPU to be similar to that of a 24-pipeline ATI R420 GPU."What do you base this on?
Questar - Wednesday, November 16, 2005 - link
" We roughly estimated the power of the Xbox 360 GPU to be similar to that of a 24-pipeline ATI R420 GPU."What do you base this on?
nourdmrolNMT1 - Wednesday, November 16, 2005 - link
these screws are NOT torx screws. these are Hex Heads.you aint gunna be using a torx driver to remove them. there is a difference, and the T7, T8 are what comfirm this. Torx have 5 points, these have 6, and are deffinately completely different from torx as they are much harder to strip out.
no, its Dice as proven above.
bldckstark - Wednesday, November 16, 2005 - link
From wikipedia.com search for torx -->A hex head is usually referred to as an Allen bolt or the infamous Allen wrench.
And as I posted earlier, from dictionary.com, the definition of dice is as follows --> A small cube marked on each side with from one to six dots, usually used in pairs in gambling and in various other games.
The item referred to in this in plural form is dies.
Ruark - Wednesday, November 16, 2005 - link
"You can now lift up the motherboard out of the metal chassis."Less awkward, "You can now lift the motherboard out of the metal chassis."
"Three star bit screw drivers in the following sizes: T6, T7 and T12"
Is a three star ranked a little lower than a four star? ;) At first glance, I thought this was certainly a secure method of attachment if a screw driver with a three pointed star tip was needed. Torx, torx, torx!
"After two corners have been lifted, the rest of the clamp springs loose and can easily be removed by hand."
As these are not the small cubes used for gaming, the plural should be dies.
Ruark - Wednesday, November 16, 2005 - link
"Using your start bit screw drivers, remove the silver screws. . ."PhoneZ - Thursday, November 17, 2005 - link
"..START bit screwdriver.."? Or is that supposed to be star? Since we feel the need to correct people.Live - Wednesday, November 16, 2005 - link
So how do we overclock it?