SSD

The new Mac Pro does the right thing and abandons internal hard drives in favor of high-speed PCIe based storage. You could argue wanting more internal PCIe storage, but hard drives don’t belong inside this machine - for that there’s Thunderbolt 2.

There’s a single proprietary Apple PCIe SSD connector and module inside the new Mac Pro. The connector looks similar to what’s in the new MacBook Pro but I haven’t verified compatibility. Unlike the new MacBook Pros, the Mac Pro SSDs only ship in a x4 PCIe configuration. The result is faster peak sequential speeds.


Custom SSD behind the GPU board on the left

My review sample had a 512GB Samsung XP941 based drive. I believe this is a 2-bit-per-cell MLC design with a 512MB LPDDR2-1066 DRAM. Samsung’s SSD architectures have evolved pretty well over the years. As long as you’re careful not to completely fill the drive you should be ok from an IO consistency standpoint as well. I continue to recommend keeping around 15 - 20% of the SSD free if you want to keep performance at a relatively high level. Definitely keep this in mind if you’re torn about what capacity drive you should outfit your system with.

Mac Pro (Late 2013) SSD Options
  4-Core Config 6-Core Config
256GB Included Included
512GB +$300 +$300
1TB +$800 +$800

Apple offers three SSD capacities with the new Mac Pro: 256GB, 512GB and 1TB. Both default configurations come with a 256GB drive. Upgrades to 512GB/1TB cost the same regardless of your starting point: $300 and $800, respectively. Chances are you’re going to depend fairly heavily on external storage for media, which leaves you the flexibility of sticking with the base 256GB configuration. Personally I’d use the Mac Pro just as much as a regular PC (including gaming) as I would for photo/video work, so I’d push for the highest capacity SSD possible. Since Apple isn’t using a standard connector or form factor here, you can’t necessarily count on anyone offering a decent aftermarket solutions (although OWC has done so in the past). If OWC or anyone else was brave enough to produce an aftermarket Mac Pro SSD, it might come with fewer tradeoffs compared to what we’ve seen in the portable Mac space. I’m primarily talking about ultra low idle power not being as much of an issue for an SSD in the Mac Pro. Last time I looked, OWC’s aftermarket MacBook Air/Pro SSDs consumed more power at idle compared to the Apple OEM drives. The same issues wouldn’t matter in a Mac Pro.

I ran the 512GB SSD through our standard four-corners Iometer test suite. The numbers were expectedly a bit higher than what I measured on the 15-inch Haswell rMBP and the 21.5-inch Haswell iMac thanks to the drive’s PCIe x4 interface. Random write performance takes a step backwards but all of the results we're showing here are more than enough for single user workstation use. Although Mavericks itself seems to have issues that can cause high latency IO (particularly around quicklook), the SSD in the Mac Pro performed quite well.

Apple SSD Comparison - 128KB Sequential Read (QD1)

Apple SSD Comparison - 128KB Sequential Write (QD1)

Apple SSD Comparison - 4KB Random Read (QD3)

Apple SSD Comparison - 4KB Random Write (8GB LBA Space - QD3)

I’m beyond pleased to see that Apple has moved its Mac lineup virtually top to bottom to PCIe SSDs. This is absolutely the right approach, and one that all other OEMs should follow.

Gigabit Ethernet & WiFi

Broadcom won all of the networking sockets in the new Mac Pro. Each machine ships with two BCM57762 Gigabit Ethernet controllers and a BCM4360 802.11ac controller. Each controller is connected to its own PCIe 2.0 x1 lane, guaranteeing it more than enough bandwidth to operate at full speed. The GigE ports on the back of the Mac Pro are thus independent and can sustain full bandwidth in tandem.

The 802.11ac solution is the same 3-stream BCM4360 you’ll find in the new Haswell MacBook Pros. The Broadcom controller supports 80MHz wide channels and 256 QAM, resulting in a peak theoretical data rate of 433Mbps per stream. With three streams that works out to be a max negotiated PHY rate of 1.3Gbps.

In practice I found the Mac Pro’s WiFi performance in best conditions to be similar to that of the 21.5-inch 2013 iMac, which ships with the same hardware. Over UDP that amounts to just under 900Mbps, and a bit over 600Mbps over TCP. You’re still better off using GigE if you can, but 3-stream 802.11ac is arguably good enough if you can’t get a cable down to your Mac.

WiFi Performance

4K Support & The 4K Experience Thunderbolt 2
Comments Locked

267 Comments

View All Comments

  • instantchip - Monday, October 13, 2014 - link

    It's beautiful and this time the beauty is not at the expense of the performance and engineering. (Unlike with the G4 Cube—Form vs Function: Is the New Mac Pro Another G4 Cube? chipbrown.me/2013/06/14/form-vs-function-is-the-new-mac-another-g4-cube/)

    This is as it should be. Like Porsche does with a perfect 911—The perfect blend of performance, design and engineering.
  • esse_bi - Tuesday, October 28, 2014 - link

    hallo,

    is the mac pro 30 bit or 24bit in windows8 [i.e. with photoshop CC]

    thanks a lot
  • wolfman3k5 - Sunday, March 15, 2015 - link

    Lucky for us classic Mac Pro users, there are more up-to-date video cards available for our systems than for the new Mac Pro (late 2013). Check this out:

    - NVIDIA GeForce GTX 980 4GB Reference Design: https://sqz.io/gtx980-1
    - EVGA GeForce GTX 980 4GB ACX: https://sqz.io/gtx980-2
    - NVIDIA GeForce GTX 970 4GB Reference Design: https://sqz.io/gtx970-1
    - Zotac GeForce GTX 970 4GB AMP! Extreme: https://sqz.io/gtx970-2
    - Zotac GeForce GTX 970 4GB AMP! Omega: https://sqz.io/gtx970-3

    Now, when was the last time you could reliably install the latest and greatest video card in your Mac Pro? Never mind that the factory video cards in the new Mac Pro are obsolete from the factory.
  • stefantoolstoday - Wednesday, April 22, 2015 - link

    wolfman3k5, how do you know the factory video cards in the new Mac Pro are obsolete from the factory?
  • TheinsanegamerN - Thursday, June 4, 2015 - link

    Because the d700 is a r280x, which is a 7970, which came out in 2011. so, as of today, those gpu's are 3.5 years old.
  • rodion15 - Saturday, September 12, 2015 - link

    Could I know which of the 2 graphics boards is artifacting (showing red spots or vertical lines?) while using 2 monitors.
    I'd welcome if you email answer to amsemail9@gmail.com
    Thank you
  • tipoo - Tuesday, April 11, 2017 - link

    " I don't see much room for Apple to move to more powerful GPUs though. "

    Funny reading this now, it's exactly what Apple cited preventing upgrades.

Log in

Don't have an account? Sign up now