Better at the Low End, Mixed Feelings Everywhere Else

Brian came up with the plan to enable the numerical signal strength visualization and executed on it very well in our original iPhone 4 review. Since then there’s been a disturbing amount of debate as to whether or not this actually amounts to a problem with the phone.

Part of the confusion stems from the fact that doing this sort of antenna testing in a real world scenario is time intensive. As Brian mentioned on the previous page, for today’s article both of us were driving around our respective cities, stopping at various locations, measuring signal strength and comparing it to bar mappings in order to produce the charts you saw on the other page.

There’s no denying that Apple has played a significant role in why there continues to be debate about the iPhone 4 antenna. By simply addressing the pre-4.0.1 bars not being a good representation of signal strength and ignoring the fact that the iPhone 4 does lose more signal strength than competing phones depending on how you hold it, Apple manages to convince its faithful that there’s nothing wrong while driving its critics to demand a recall.

My mother always taught me that honesty is the best policy and presumably I’m not the only one in the world who was privy to this information. Had Apple come clean with both of these facts (the bar mapping and the signal attenuation issue) early on we’d be in a far more clear cut world today.

We have consistently argued that the 4’s antenna is a design choice by Apple. As we’ve seen in our testing there are situations where the iPhone 4’s antenna makes things better (e.g. holding onto calls with very low signal strength) and other situations where the design makes them worse (e.g. holding it wrong in situations with low signal strength). I wanted to describe the inconsistency in greater detail so I went out with an iPhone 3GS and 4 and documented my experiences.

In practice I found three things that were true about the iPhone 4’s antenna behavior compared to the 3GS.

Reception in average conditions is sometimes significantly better on the iPhone 4 than on the 3GS. Take a look at the image capture below. In the same exact location we have better reception on the 4 than the 3GS. Granted this could be due to a number of variables outside of the phone’s antenna itself, but it happened enough times that it’s worth reporting. This is the positive to Apple’s external antenna design - you can and do get better reception. Unfortunately the tradeoff is the scenario I just described before this.


iPhone 4 (left) at -81 dBm vs. iPhone 3GS (right) at -94 dBm

Signal strength is sometimes the same as or worse than the iPhone 3GS. This is really where the problem comes into play. In the shot below I have the 4 and 3GS sitting next to one another and they are displaying roughly the same signal strength. We’ve already proven that holding the iPhone 4 attenuates its signal more than the 3GS, which results in the frustration we’ve seen expressed by many at this point. In situations where the 4 has the same signal as the 3GS, holding the phone is going to drop it to levels significantly worse than the 3GS. If you’re in an area with low signal strength to begin with, holding the phone is going to bring you down to dangerously low levels.


iPhone 4 (left) at -103 dBm vs. iPhone 3GS (right) at -104 dBm


iPhone 4 being held tightly (left) at -115 dBm vs. iPhone 3GS being held tightly (right) at -107 dBm


iPhone 4 (left) at -77 dBm vs. iPhone 3GS (right) at -66 dBm

The iPhone 4 is better at holding onto calls and data at very low signal levels. We’ve mentioned this one before but it’s worth reiterating. The new antenna does let me make calls and transmit data at very low signal strength. With the iOS 4.0.1 update I was able to make a call at -115dB on the 3GS, however the call did drop within a minute of starting it. By comparison I was able to have a much longer conversation without dropping the call at -120dB on the 4. By no means is this a scientific comparison, but anecdotally both Brian and I feel that the low signal strength performance of the iPhone 4 is better than the 3GS.


A call at -120 dBm on the iPhone 4

If you’re keeping tabs you’ll note that this is what is traditionally referred to as a trade off. Apple opted for good performance in low signal situations (and style of course) over maintaining consistently better or unchanged radio performance compared to the 3GS. I would personally consider this to be an unnecessarily risky design choice, particularly for a smartphone vendor. Note that it's nearly impossible to separate out the antenna from the rest of the iPhone 4 platform to determine exactly what is responsible for the phone's signal sensitivity in various situations. All we ultimately know is how physically interacting with the antenna impacts reported signal strength.

I can’t stress enough that this issue impacts all users. The variability is in how strong of a signal you have to begin with. That’s the absolute only reason there’s debate in these discussions from phone to phone. At my desk I don’t get great reception on AT&T. With the iPhone 4 I’m usually at -96dBm. If I keep a tight grip on the phone or if I’m holding it to send text messages I can sometimes lose all signal entirely. This is a combination of poor reception at my house and the fact that the 4 loses more of its signal than other phones when held certain ways.

Brian on the other hand has much better reception at his home. To him, the signal strength drops but it does not drop enough for this to be a problem. I consider myself to be on the border. If I’m mindful of how I’m holding the phone it’s not an issue, and even most of the time if I’m not paying attention to it it’s not an issue. However there are definitely times when it does become a problem. I wouldn’t consider it to be the majority of the time or even more than 10% of the time, but it happens enough for me to have to think about it. Ultimately this is why I consider Apple’s design here to be unnecessarily risky. Introducing a change with stylistic and technical benefits where the downside is limited but potentially very noticeable is just ballsy.

Luckily for Apple, there are things that can be done about it.

The Bars Have Changed Mitigating the Problem with Tape/Gloves
Comments Locked

146 Comments

View All Comments

  • stevessvt - Thursday, July 15, 2010 - link

    All I did was post a link to this on apples forums and they took it off. Unbelievable.
  • Snotling - Thursday, July 15, 2010 - link

    unbelievable that they tolerate all the negative nonsense anybody posts anywhere and would prevent serious information from being found by their customers.
  • bplewis24 - Thursday, July 15, 2010 - link

    "I can’t stress enough that this issue impacts all users. The variability is in how strong of a signal you have to begin with. That’s the absolute only reason there’s debate in these discussions from phone to phone. At my desk I don’t get great reception on AT&T. With the iPhone 4 I’m usually at -96dBm. If I keep a tight grip on the phone or if I’m holding it to send text messages I can sometimes lose all signal entirely. This is a combination of poor reception at my house and the fact that the 4 loses more of its signal than other phones when held certain ways."

    Plain and simple, this above paragraph should have been in the 1st article. You and I both knew this back when the first article broke, but it was skirted around intentionally and every single person who denied that a problem existed referenced the Anandtech initial review. They will ignore this update/redux unless Apple comes out tomorrow and confesses to the design flaw.

    Brandon
  • pr0nstar69 - Thursday, July 15, 2010 - link

    You keep talking about the antenna as being the determining factor in terms of reception and holding a connection under poor signal conditions. I was wondering how you determined that this is really the case.

    The iPhone 4 also changed baseband hardware providers, from (IIRC) Infineon on the 3GS to Skyworks on the 4. I would imagine that they also play a role in the quality of signal maintained.
  • VahnTitrio - Thursday, July 15, 2010 - link

    Working at 3M we have plenty of tape for all applications. 3M calls it's Kapton tape "Polyimide" and it does come as thin as 1/4". The number on the roll is 5413, and will probably run you about $20. It has tons of uses, we use it most often to secure thermocouples to electrical components.
  • espiritiv - Monday, July 19, 2010 - link

    http://www.thetapedepot.com/cart/index.php?option=...

    $7 bucks!
  • stevessvt - Thursday, July 15, 2010 - link

    From iTunes now...
  • Bare - Thursday, July 15, 2010 - link

    Hey Brian and Anand,

    I just registered so that I could thank you for both your initial iPhone 4 review where you first detailed the antenna issue better than anyone else has to date, and also for this follow-up that discussed both the new signal bars in 4.1 and further discussed fixes for the real antenna issue. Your reviews are what sold me on this being an issue on all new iPhone 4 devices, and I couldn't agree more with your statements about how much impact this actually has on each iPhone 4 owner depends solely on the initial signal strength from AT&T. You have totally cleared away any of my confusion regarding this issue -- if only more people would read your blog!

    Thanks,
    Bare
  • boden - Thursday, July 15, 2010 - link

    I suspect Y'all are going to have to run these tests again this weekend.
  • slickr - Thursday, July 15, 2010 - link

    Can you stop being so PRO Apple and so PRO Iphone 4.
    Its more than obvious that Iphone 4 is crap, its got broken antenna, broken USB port, broken Bluetooth and its costs 4x times that the amount it costs to develop it.

    In simple words, its totally broken and overly expensive. So please stop defending Apple and truing to make them look good.

    You Anandtech have a reputation to keep and this is the easiest way to loose it.

    I've been following this website for more than 8 years and I hate it when I see hidden favoritism and/or hidden advertisement for companies.

    You have banner space and that's where ads should start and END.

Log in

Don't have an account? Sign up now