A few weeks ago a very smart friend of mine sent me an email asking why we haven’t seen more PCIe SSDs by now. While you can make the argument for keeping SATA around as an interface with traditional hard drives, it ends up being a bottleneck when it comes to SSDs. The move to 6Gbps SATA should alleviate that bottleneck for a short period, but it is easy enough to put NAND in parallel that you could quickly saturate it as well. So why not a higher bandwidth interface like PCIe?

The primary reason appears to be cost. While PCIe can offer much more bandwidth than SATA, the amount of NAND you’d need to get there and the controllers necessary would be cost prohibitive. The unfortunate reality is that good SSDs launched at the worst possible time. The market would’ve been ripe in 2006 - 2007, but in the post recession period getting companies to spend even more money on PCs wasn’t very easy. A slower than expected SSD ramp put the brakes on a lot of development on exotic PCIe SSDs.

We have seen a turnaround however. At last year’s IDF Intel showed off a proof of concept PCIe SSD that could push 1 million IOPS. And with the consumer SSD market dominated by a few companies, the smaller players turned to building their own PCIe SSDs to go after the higher margin enterprise market. Enterprise customers had the budget and the desire to push even more bandwidth. Throw a handful of Indilinx controllers on a PCB, give it a good warranty and you had something you could sell to customers for over a thousand dollars.

OCZ was one of the most eager in this space. We first met their Z-Drive last year:

The PCIe x8 card was made up of four Indilinx barefoot controllers configured in RAID-0, delivering up to four times the performance of a single Indilinx SSD but on a single card. That single card would set you back anywhere between $900 - $3500 depending on capacity and configuration.

With the SSD controllers behind a LSI Logic RAID controller there was no way to get TRIM commands to the data. OCZ instead relied on idle garbage collection to keep Z-Drive owners happy. Even today the company is still working on bringing a TRIM driver to Z-Drive owners.

The Z-Drive apparently sold reasonably well. Well enough for OCZ to create a follow on drive: the Z-Drive R2. This card uses custom NAND cards that would allow users to upgrade their drive capacity down the line. The cards are SO-DIMMs populated with NAND, available only through OCZ. The new Z-Drive still carries the hefty price tag of the original.

Ryan Petersen, OCZ’s CEO, hopes to change that with a new PCIe SSD: the OCZ RevoDrive. Announced at Computex 2010, the RevoDrive uses SandForce controllers instead of the Indilinx controllers of the Z-Drives. The first incarnation uses two SandForce controllers in RAID-0 on a PCIe x4 card. As far as attacking price: how does $369 for 120GB sound? And it is of course bootable.

OCZ sent us the more expensive $699.99 240GB version but the sort of performance scaling we'll show here today should apply to the smaller, more affordable card as well. Below is a shot of our RevoDrive sample:

The genius isn’t in the product, but in how OCZ made it affordable. Looking at the RevoDrive you’ll see the two SandForce SF-1200 controllers that drive the NAND, but you’ll also see a Silicon Image RAID controller and a Pericom PI7C9X130 bridge chip.

The Silicon Image chip is a SiI3124 PCI-X to 4 port 3Gbps SATA controller. The controller supports up to four SATA devices, which means OCZ could make an even faster version of the RevoDrive with four SF-1200 controllers in RAID.

Astute readers will note that I said the Sil3124 chip is a PCI-X to SATA controller. The Pericom bridge converts PCI-X to a PCIe x4 interface which is what you see at the bottom of the card.



The Pericom PCI-X to PCIe Bridge

Why go from SATA to PCI-X then to PCIe? Cost. These Silicon Image PCI-X controllers are dirt cheap compared to native PCIe SATA controllers, and the Pericom bridge chip doesn’t add much either. Bottom line? OCZ is able to offer a single card at very little premium compared to a standalone drive. A standard OCZ Vertex 2 E 120GB (13% spare area instead of 22%) will set you back $349.99. A 120GB RevoDrive will sell for $369.99 ($389.99 MSRP), but deliver much higher performance thanks to you having two SF-1200 controllers in RAID on the card.

You’ll also notice that at $369.99 a 120GB RevoDrive is barely any more expensive than a single SF-1200 SSD, and it’s actually cheaper than two smaller capacity drives in RAID. If OCZ is actually able to deliver the RevoDrive at these prices then the market is going to have a brand new force to reckon with. Do you get a standard SATA SSD or pay a little more for a much faster PCIe SSD? I suspect that many will choose the latter, especially because unlike the Z-Drive the RevoDrive is stupidly fast in desktop workloads.

If you’re wondering how this is any different than a pair of SF-1200 based SSDs in RAID-0 using your motherboard’s RAID controller, it’s not. The OCZ RevoDrive will offer lower CPU utilization than an on-board software based RAID solution thanks to its Silicon Image RAID controller, but the advantage isn’t huge. The only reason you’d opt for this over a standard RAID setup is cost and to a lesser extent, simplicity.

What’s that Connector?

When I first published photos of the Revo a number of readers wondered what the little connector next to the Silicon Image RAID controller was. Those who guessed it was for expansion were right: it is.

Unfortunately that connector won’t be present on the final RevoDrive shipped for mass production. At some point we may see another version of the Revo with that connector. The idea is to be able to add a daughterboard with another pair of SF-1200 controllers and NAND to increase capacity and performance of the Revo down the line. Remember that Silicon Image controller has four native SATA ports stemming off of it, only two are currently in use.

Installation and Early Issues
POST A COMMENT

62 Comments

View All Comments

  • GullLars - Friday, June 25, 2010 - link

    Seconded.
    The stripe size can have a dramatic impact on performance.

    I'd also love to see 4KB random read @ QD 32, but maybe i'll have to wait for some other enthusiast to download CDM 3.0 and post a screenshot...

    The sequential read scaling found was horrible, 290MB/s from 2R0 120GB SandForce drives is low. How about an ATTO comparison to show a broader spectrum of sequentials?
    Reply
  • Qapa - Friday, June 25, 2010 - link

    They should make the 240GB version with 4 "drives" in RAID 0, that could make it more interesting... and I guess no one would mind paying twice the value of the 120GB, $740 for a drive that can, at times be almost 4x faster than a Vertex 2. Reply
  • mapesdhs - Friday, June 25, 2010 - link


    Since these are PCIe devices, did you guys try striping more than one of them by any chance?

    Heh, looking forward to when we get RamSan-620 speed & capacity on a single card. :D

    Ian.
    Reply
  • Zstream - Friday, June 25, 2010 - link

    So how are these supposed to stack against other enterprise hardware companies? With no trim support, this would definitely kill the thought to purchase these.

    http://www.violin-memory.com/
    Reply
  • kurt2000 - Friday, June 25, 2010 - link

    if it is raided, does it support trim on the raid ctrl ? Reply
  • ggathagan - Friday, June 25, 2010 - link

    Which part of "No TRIM, No Garbage Collection" confused you? Reply
  • RaistlinZ - Friday, June 25, 2010 - link

    No TRIM is expected.

    But no garbage collection? Bleh. I'll wait until it at least supports GC. OCZ's reliability on their SSD's has been shoddy lately, which makes me want to hold off even more.
    Reply
  • seapeople - Friday, June 25, 2010 - link

    Oh goodie, I can't wait until we have a drive that's 10 times faster than the Intel x25-m and only costs 10 times as much! Maybe after that, we'll get something even faster, for even more money!!

    Seriously, the problem with SSD's is not that they're too slow, it's that they're too expensive. Drives like this aren't exactly helping in that regard.
    Reply
  • MC-Sammer - Friday, June 25, 2010 - link

    I wonder if there would be any kind of noticeable im[improvement in sped if you put it on an ASUS p6t V2 and overclock the PCIe bus (any board with this function really)

    Very cool article *thumbs up*
    Reply
  • bumble12 - Friday, June 25, 2010 - link

    $369 for 120GB
    £316 for 120GB

    http://www.scan.co.uk/Search.aspx?q=OCZ+Revo

    :(
    Reply

Log in

Don't have an account? Sign up now