Overclocking and Performance Scaling

With outstanding performance at stock speed, we pushed the Arctic Cooling HSFs in our performance scaling tests to see if these air-coolers deliver similarly impressive performance when overclocking. As cooling solutions do a better job of keeping the CPU at a lower temperature, it is reasonable to expect the overclocking capabilities of the CPU will increase as cooler performance increases. In each test of a cooler, we measure the highest stable overclock of a standard X6800 processor under the following conditions:

CPU Multiplier: 11x (Stock 11x)
CPU Strap: 266 (stock) or 333 (overclocked)
CPU voltage: 1.5875V at Max overclock
NB Voltage: 1.70V
FSB Voltage: 1.40V
SB Voltage: 1.20V

Memory is set to Auto timings on the P35. This removes memory as any kind of impediment to the maximum stable overclock. As FSB is raised the linked memory speed increases in proportion. For this reason, we maintain memory speed as close as possible to CPU strap settings to prevent memory becoming an issue in CPU testing. This means 3.33GHz uses a 333 strap and runs 10x333, 3.73 uses a 333 strap and runs 11x339, and 3.90 GHz is a 333 strap and 354x11. The stock speed test is a 266 strap and 11x266. We may move in the future to a 3.0GHz stock speed with a 333 strap and 9x333 settings for complete consistency, but since we are not measuring raw computer performance in our cooling benchmarking this becomes a moot point. We use the same processor in all cooling tests to ensure comparable results.


Highest
Stable Overclock (MHz)

The Alpine 7 is rated at 90 watts heat dissipation, which means it should overclock a little better than the stock Intel cooler. That is exactly what we found in the overclocking tests, with a top overclock of 3.78GHz compared to the Intel top overclock of 3.73GHz.

The Freezer 7 Pro is rated at 130 watts dissipation and it lives up to that level of performance, topping out at 3.85GHz. This does not challenge our top coolers, which can dissipate more than 150W - or even 165W in the case of the Thermalright Ultra 120 eXtreme. Nonetheless, it is very competent performance for a cooler selling for less than $25. Many other coolers we have tested that sell for much more than these two coolers do not perform as well in overclocking.

Those who expected the Alpine 7 family or Freezer 7 Pro might give our top performing coolers a run for the top will likely be disappointed. However, they shouldn't be disappointed with either cooler's overclocking performance. It is very clear Arctic Cooling knows how to design and rate their coolers for performance. Both the Alpine 7 and the Freezer 7 Pro are fairly rated and outstanding performers in their respective price classes.

Performance Scaling

Performance scaling charts for the Arctic Cooling pair use a scale with zero on the bottom and 75C on the top. Keep in mind that the lower line is the best performance in this presentation of the data - lower temperatures represent better performance.


The Alpine 7 performance scaling at idle is impressive. It significantly outperforms the Intel retail cooler, which would be the closest competitor. Surprisingly it also outperforms most of the mid-range coolers we have tested to the point where it tops out at 3.78GHz. The Freezer 7 Pro is even better, with scaling close to the top guns to its max speed of 3.85GHz.

Comparing cooling efficiency of the Arctic Coolers under load conditions to the retail HSF and other recently retested CPU coolers doesn't change the picture much. Load testing can be very revealing of a cooler's efficiency. A basically flat line, particularly form 3.73GHz upward, indicates the cooler is still in its best cooling range. A rapidly rising line indicates a cooler is nearing the end of its ability to cool efficiently. Lines that parallel the best coolers over a range of values show the coolers provide similar cooling performance.


Under load test conditions, the limited performance of both these coolers is more noticeable. Top coolers we have tested exhibit a shallower slope, where the Alpine 7 and Freezer 7 Pro both have very steep curves in load performance scaling. Results at 2.93GHz and 3.33GHz are among the best test results so far, but the Alpine 7 drops rapidly into the entry/mid performance levels at 3.73GHz and its top of 3.78GHz. Keep in mind that this is a very low-priced cooler and you can get more excited about load scaling, because performance is still significantly better than the stock cooler.

The Freezer 7 Pro fares better under load, as might be expected of a small heatpipe tower. Load performance matches the top tier until around 3.5Ghz. Load scaling then drops into the mid-range area from 3.73GHz to the top for this cooler of 3.85GHz. This is still excellent performance for a cooler in this price range.

Noise Levels Final Words
Comments Locked

48 Comments

View All Comments

  • spidey81 - Tuesday, January 29, 2008 - link

    I was looking into the Freezer 64 Pro for an AM2/AM2+ build and was wondering if anyone knew if the performance for the AMD version performed similarly. I noticed the specs seem to be slightly different as the 64 Pro fan maxes out at only 2200 rpm pushing 40 cfm where the 7 Pro maxes out at 2500 rpm pushing 45 cfm. They appear to be of the same design varied only by the mounting hardware. Any input would be greatly appreciated.
  • Martimus - Tuesday, January 29, 2008 - link

    I have a Freezer 64 Pro. It dropped the temps on my CPU by 10C instantly from a Zalman 7000. It now runs 20C cooler after the Thermal compound cured. It is definitely a nice heatsink, although it is difficult to attach unless you remove the MB from the case.
  • mixim - Tuesday, January 29, 2008 - link

    The design is exactly the same, only the fan circuits differ to reduce the max fan rpm, this because AMD has put out low-watt CPU's for a couple of years now , when the Intel version should still be able to cope with Pentium 5/D's and so on...

    The lower maximum RPM will help with the fans longevity, but actually in my C2D system it has never went up to full speed anyway...
  • dlock13 - Tuesday, January 29, 2008 - link

    I cannot find the Freezer 7 anywhere under $25. I can't find it anywhere under $30. I checked Newegg and their price is $32.

    I am really in need of a new heatsink, and this is just perfect.
  • Spanki - Wednesday, January 30, 2008 - link

    It's $24.99 here: http://www.svc.com/acfzp7.html">http://www.svc.com/acfzp7.html

    or.. you can save some bucks and get the Cooler Master Hyper Tx 2 (same or better performance than the Freezer Pro 7 - slightly larger, quieter, slower spinning fan) for $9.99 at the same place: http://www.svc.com/rr-pch-s9u1-gp.html">http://www.svc.com/rr-pch-s9u1-gp.html

  • BladeVenom - Tuesday, January 29, 2008 - link

    Newegg has it on sale for $21.99 quite often. It can also usually be found for $21.86 on sale at eWiz.
  • 75below0 - Tuesday, January 29, 2008 - link

    I understand there's a new test bed and temp utility, but +7C for the Ultima 90 w/SFLex under load compared to last review seems inordinately steep...
    Anyone have any comparisons of CoreTemp vs. NVIDIA Monitor and/or Intel TAT (Thermal Analysis Tool) ?
  • whatthehey - Tuesday, January 29, 2008 - link

    The motherboard and BIOS change among other things so the fan speeds may not ramp up as soon but when they ramp up they might do so to a larger amount. Look at the Intel stock cooler which drops from 56C to 50C with the new testbed. They covered a lot of the changes here:

    http://www.anandtech.com/casecoolingpsus/showdoc.a...">http://www.anandtech.com/casecoolingpsus/showdoc.a...

    If you look at the results you'll see that TAT and CoreTemp both register higher than the old EVGA board by several C. Meanwhile the Ultra 120 X goes from 36C to 42C idle and 47C to 59C load. Obviously there are lots of variables. I'm not sure what margin of error is with CoreTemp and such either but it may be several C.

    The important thing IMO is to look at noise levels and max OC along with temps. Nothing exists in a vaccuum so don't focus on one metric.
  • phaxmohdem - Tuesday, January 29, 2008 - link

    I just ordered the Freezer 7 yesterday night... before this article came out. I feel WAY better now about my decision... though it is going onto a Pentium-D which may insult it :P
  • RamarC - Tuesday, January 29, 2008 - link

    freezer 7 pros are great for pentium Ds. i've got a 3.4ghz pd945 that it keeps in the mid 50s. warm? yes, but quiet since the mobo only asks the freezer to spin at 500rpm.

    i can't believe it took anandtech this long to review the freezer pro 7 considering mine is pushing 2 years old now.

Log in

Don't have an account? Sign up now