Overclocking and Performance Scaling

With outstanding performance at stock speed, we pushed the ZEROtherm Nirvana in our performance scaling tests to see if this air cooler delivers similarly impressive performance when pushed hard in overclocking. As cooling solutions do a better job of keeping the CPU at a lower temperature, it is reasonable to expect the overclocking capabilities of the CPU will increase as cooler performance increases. In each test of a cooler, we measure the highest stable overclock of a standard X6800 processor under the following conditions:

CPU Multiplier: 11x (Stock 11x)
CPU Strap: 266 (stock) or 333 (overclocked)
CPU voltage: 1.5875V at Max overclock
NB Voltage: 1.70V
FSB Voltage: 1.40V
SB Voltage: 1.20V

Memory is set to Auto timings on the P35. This removes memory as any kind of impediment to the maximum stable overclock. As FSB is raised the linked memory speed increases in proportion. For this reason, we maintain memory speed as close as possible to CPU strap settings to prevent memory becoming an issue in CPU testing. This means 3.33GHz uses a 333 strap and runs 10x333, 3.73 uses a 333 strap and runs 11x339, and 3.90 GHz is a 333 strap and 354x11. The stock speed test is a 266 strap and 11x266. We may move in the future to a 3.0GHz stock speed with a 333 strap and 9x333 settings for complete consistency, but since we are not measuring raw computer performance in our cooling benchmarking this becomes a moot point. The same processor is used in all cooling tests to ensure comparable results.


Highest
Stable Overclock (MHz)

The Nirvana lives up to its name in overclocking, reaching 3900 MHz with its single dedicated fan. This matches the top tier of cooler performance and is the match of other top coolers like the Thermalright Ultra-120 and the Tuniq Tower 120. However, the Nirvana was not stable above 3.9Ghz and it really did not challenge the Thermalright Ultra-120 eXtreme as the best performing air cooler tested so far at AnandTech. Still, this superb performance places the Nirvana among the very best air coolers you can buy for your system.

As stated many times, the overclocking abilities of CPUs will vary at the top, depending on the CPU. This particular CPU does higher FSB speeds than any X6800 we have tested, but the 3.9GHz top speed with the Thermalright Ultima-90 with 120mm fan is pretty average among the X6800 processors we have tested with top air cooling. A few of the other processors tested with the best air coolers reach just over 4 GHz, but the range has been 3.8 to 4.0GHz. Stock cooling generally tops out 200 to 400 MHz lower, depending on the CPU, on the processors tested in our lab.

Performance Scaling

Performance scaling charts for the ZEROtherm Nirvana use a scale with zero on the bottom and 75C on the top. Keep in mind that the lower line is the best performance in this presentation of the data - lower temperatures represent better performance.


The Nirvana at idle is arguably the best performing cooler we have tested. Performance is better than or equal to the top Thermalright Ultra-120 eXtreme until the top speed of 3.90GHz is reached. The Thermalright is slightly better at 3.9Ghz and continues on to the highest overclock on air at 2.94GHz. This performance places the Nirvana solidly in the top cooler performance group with the Tuniq Tower, Scythe Infinity push-pull, Thermalright Ultra-120, and Thermalright Ultima-90 with 120mm fan.

Comparing cooling efficiency of the NV120 under load conditions to the retail HSF and other recently retested CPU coolers doesn't change the picture much. Load testing can be very revealing of a cooler's efficiency. A basically flat line, particularly form 3.73GHz upward, indicates the cooler is still in its best cooling range. A rapidly rising line indicates a cooler is nearing the end of its ability to cool efficiently. Lines that parallel the best coolers over a range of values show the coolers provide similar cooling performance.


Under stress test conditions, the performance of the ZEROtherm Nirvana places it solidly in the top-performing cooler category. It is still outperformed by the leading Thermalright Ultra-120 eXtreme, but the Nirvana is definitely a performance match for any other top performing cooler we have tested.

There is no doubt, based on the test results, that the Nirvana is capable of dissipating 150W and possibly a bit more. This is outstanding performance for any cooler. However, based on the performance scaling it is clear that the Nirvana has reached its limit compared to other test results around 3.9GHz. It has no reserve to reach even higher as the Thermalright Ultra-120 eXtreme does. The reason for this may be as simple as the additional heat pipes of the Ultra-120 eXtreme.

Nirvana is clearly one of the best air coolers we have tested, and it deserves a slot as another choice among top-performing air coolers. At a selling price of around $45, the Nirvana competes very well for value in this top category. The Nirvana also comes standard with a fan controller at the $45 selling price, which will tip the scales toward this cooler for many users.

Noise Levels Conclusion
Comments Locked

38 Comments

View All Comments

  • Iketh - Wednesday, January 16, 2008 - link

    umm that last graph clearly shows u the temp at max stable
  • PolymerTim - Thursday, January 17, 2008 - link

    Ahh, yeah, that would be it. So just disregard my last sentence. :)
  • GhandiInstinct - Wednesday, January 16, 2008 - link

    These cooler reviews provided a list of motherboards this thing can fit on. My # 1 problem is finding out if my motherboard or a new motherboard can support a cooler I want to mount.

    The manufacturer is very weak in providing this information.
  • Wesley Fink - Thursday, January 17, 2008 - link

    Most of the top motherboard makers are very aware these days of the size and fit of the major coolers. There usually is no real problem with those top boards. Where we usually see fit issues is with the cheaper or lower line boards where board real estate is often a premium.

    Our problem is that it's not really possible to report a cooler fit on every board out there. We have tried in the past to comment on the major board fit but that is becoming a moot point since there are very few cooler fit issues at the top any more.

    Our motherboard reviewers do a pretty good job of pointing out potential cooler fit problems in their reviews. The best source of the information you want might be to go back to the motherboard review for the board in question. We will also try to do a better job of pointing out any fit issues we ran into in our cooler reviews.
  • ussfletcher - Wednesday, January 16, 2008 - link

    My friend bought one of these and when he installed it there were 2 metal edges poking out quite far from the bottom and caused his processor to overheat in seconds, I'm quite sure that it was installed correctly.. i was there.
  • Wesley Fink - Thursday, January 17, 2008 - link

    I've looked at the Nirvana closely and I can't figure out where the two metal protrusions might have been on your friend's cooler. The one I tested was very nicely finished, but defective ones can always slip through.. Can you please describe the manufacturing defect in more detail as I just can't get a mental picture of what was wrong.
  • shabby - Wednesday, January 16, 2008 - link

    What were the idle/load temps using the low fan setting?
  • Wesley Fink - Wednesday, January 16, 2008 - link

    I will add the Low speed results to the graph. Idle was 2C warmer than High and load was 3C warmer.

Log in

Don't have an account? Sign up now