Inside Microsoft's Xbox 360
by Anand Lal Shimpi, Kristopher Kubicki & Tuan Nguyen on November 16, 2005 5:09 AM EST- Posted in
- Systems
Removing the Heatsinks from the Motherboard
Removing the heatsinks from the GPU and the CPU will require a great deal of patience as to avoid damaging the motherboard. Flip over the Xbox 360's motherboard. You will see two X clamps grasping the ends of the screws that hold the heatsinks into place. Without removing the X clamps, you cannot remove the heatsinks. Microsoft has done a clever job in terms of securing the unit from prying eyes and removing the heatsinks from the Xbox 360 can be a trick for a lot of people.
Take a pair of small pliers and gently pry off each corner of the clamps. After two corners have been lifted, the rest of the clamp springs loose and can easily be removed by hand. Once both X plates have been removed, you can turn the motherboard over and simply pull the heatsinks off to reveal the GPUs (two dice on the chip) and CPUs (single die, 3 cores on the chip).
You now have a fully disassembled Xbox 360.
Facebook
Twitter
RSS
91 Comments
View All Comments
ghxost - Wednesday, January 28, 2015 - link
Just signed up to say this fixed my 360. Had the RROD with 3 lights one day and nothing worked at all although the power brick and its lights seemed fine.After tearing in I found all the thermal grease was not on the chips for the cooling but all around them all over the surrounding board, nice job (it was a refurb from Gamestop...) and it still had the original x-clamp so I'm not sure if the bad grease job was from Microsoft or Gamestop, either should have used less though...
Anywho, once cleaned and properly secured, works like a champ :)