ASUS Prime B550-Plus

The Prime line of motherboards now sits as ASUS’ budget line, as an entry point into the market. The focus of Prime is on a simple polished aesthetic, which is why we’re going to see a good amount of polished metal designs, and in the case of the ASUS Prime B550-Plus, the white lines on the motherboard this time go from top right to bottom left.

It’s good to see we still have multiple power delivery heatsinks here, even if they’re not connected by a heatpipe, but the design across the PCB carries over across the heatsink in order to keep the continuity. The CPU is powered by a single 8-pin to the top left, and the socket has access to four 4-pin headers within easy reach.

The memory slots are again single sided latch designs, despite the main PCIe slot being further way than usual. On the right hand side of the board is a 24-pin ATX power connector, a USB 3.0 header, and six SATA ports.

For the PCIe layout, at the top is the PCIe 4.0 x4 M.2 slot, without a heatsink cover. Next is the PCIe 4.0 x16 full-length slot, with additional reinforcement. The board also has a full-length PCIe 3.0 x4 slot from the chipset, and below the chipset heatsink is a PCIe 3.0 x4 M.2 slot, also without a heatsink.

ASUS’ Prime boards use ALC887 audio codecs rather than the S1200A custom ones, but here we get some PCB separation in built in LEDs as well. Along the bottom of the board there is a Thunderbolt header, a COM header, RGB LED headers, a Clear CMOS header, a thermocouple header, two additional 4-pin fan headers, and two USB 2.0 headers.

On the rear panel there is a USB 3.2 Gen 2 Type-A port, a USB 3.2 Gen 2 Type-C port, a gigabit Ethernet port (Realtek RTL8111H), four USB 3.2 Gen 1 ports, a DisplayPort, a HDMI video output, two USB 2.0 ports, and the audio jacks.

ASUS TUF Gaming B550M-Plus + Wi-Fi ASUS Prime B550M-A + Wi-Fi
Comments Locked

101 Comments

View All Comments

  • kpb321 - Tuesday, June 16, 2020 - link

    I'm kinda disappointed they ended up missing the opportunity to go PCI-E 4 for the CPU to GPU link. With 2 10gbs USB ports, 2 5gbs USB ports, 10 flexible PCI-E lanes that can be NVME/ Sata ports or add on controllers on the chipset there's plenty of bandwidth there to be bottlenecked by a 4x PCI-E 3 link to the CPU. Going PCI-E 4 would make this somewhat less of a bottleneck and could support for example 2 NVME PCI-E 3.0 4X drives at full speed. The B350 more balanced in this way but sadly it was because the PCI-E off the chipset was only PCI-E 2. Hanging 16x lanes worth of things off a 4x link isn't great when they could have doubled that link bandwidth pretty easily.
  • kpb321 - Tuesday, June 16, 2020 - link

    Edit 'm kinda disappointed they ended up missing the opportunity to go PCI-E 4 for the CPU to chipset link
  • Irata - Tuesday, June 16, 2020 - link

    That‘s X570. If you need the additional storage bandwidth, this is what you should go for.

    Alternatively there is the Aorus board that offers the 8x CPU plus 2x 4x PCIe 4 lanes for nVMe drives plus the PCIe 3 lanes from the chipset. That could be an alternative and eight PCIe 4 lanes for the GPU should be fine with the next gen GPU, except perhaps for the top of the line models.

    On the plus side, with Ryzen you have four dedicated PCIe lanes from the CPU for nVMe (16+4+4 vs. 16+4 on Intel).
  • kpb321 - Tuesday, June 16, 2020 - link

    The X570 goes whole hog on PCI-E 4 with PCI-4 hanging off the chipset too and it supports more PCI-E and SATA and USB devices hanging off the chipset so while the CPU to Chipset bandwidth is higher it's actually even more imbalanced between the combine possible bandwidth of devices possible off the chipset and the CPU to Chipset bandwidth.

    Going PCI-E 4 for just the CPU to Chipset on the B550 would have given the option to decrease that imbalance and one PCI-E 4x link shouldn't have driven the power up too high.
  • romrunning - Tuesday, June 16, 2020 - link

    Then most people wouldn't buy X570 and get B550 instead as there wouldn't be much of a difference. That, and having less PCIe 4.0 stuff lowers the power requirements a bit.

    I personally held off on X570 because I knew I basically only needed the GPU and NVMe drive to be PCIe 4.0 for the most future-proof setup. I figure I'll buy new again when the new AM5 socket is released with Zen 4. Plus, some of the B550 boards have a Type-C front connector, which will go with the new ITX case I'm getting that has one on the front.
  • PixyMisa - Wednesday, June 17, 2020 - link

    Yes, but then you need to add a separate PCIe controller on the chipset to handle just those 4 lanes. The market probably isn't big enough to make it worthwhile.
  • Irata - Tuesday, June 16, 2020 - link

    The CPU to GPU link is 16x PCIe 4.0 - that has nothing to do with the chipset.

    Or did you mean something else?
  • a5cent - Friday, June 19, 2020 - link

    True, but would that not have brought back the requirement for an actively cooled chipset? That definitely contributes to cost, so it makes sense to cut that from the package.

    Personally, I'm happy that we've finally left PCIe 2.0 behind. Such chipsets still being sold in 2020 is horrific.
  • Lucky Stripes 99 - Tuesday, June 16, 2020 - link

    I was hoping to build several B550 APU mITX systems this week, but the lack of a compatible APU has stopped those plans. AMD's decision regarding to use a prior generation micro-architecture for its APUs in addition to their decision regarding AM4 firmware size limits are really colliding to create a missed opportunity here. If the iGPU in the Comet Lake processors was better, I'd be picking up H460 or Q470 boards right now instead.
  • DigitalFreak - Tuesday, June 16, 2020 - link

    My understanding is that the firmware size limit wasn't created by AMD. The motherboard makers could always use firmware chips with a larger capacity. Intel doesn't have this problem since they only support one or two CPU generations per motherboard :-)

Log in

Don't have an account? Sign up now