Random Read Performance

Our first test of random read performance uses very short bursts of operations issued one at a time with no queuing. The drives are given enough idle time between bursts to yield an overall duty cycle of 20%, so thermal throttling is impossible. Each burst consists of a total of 32MB of 4kB random reads, from a 16GB span of the disk. The total data read is 1GB.

Burst 4kB Random Read (Queue Depth 1)

The burst random read speed of the Phison E12 is very good, but the HP EX920 still stands out as the leading flash-based SSD on this test.

Our sustained random read performance is similar to the random read test from our 2015 test suite: queue depths from 1 to 32 are tested, and the average performance and power efficiency across QD1, QD2 and QD4 are reported as the primary scores. Each queue depth is tested for one minute or 32GB of data transferred, whichever is shorter. After each queue depth is tested, the drive is given up to one minute to cool off so that the higher queue depths are unlikely to be affected by accumulated heat build-up. The individual read operations are again 4kB, and cover a 64GB span of the drive.

Sustained 4kB Random Read

On the longer random read test where some higher queue depths come into play, the Phison E12's performance is a bit below par as several other TLC-based SSDs are a bit faster, even those using the same BiCS3 3D TLC.

Sustained 4kB Random Read (Power Efficiency)
Power Efficiency in MB/s/W Average Power in W

The power efficiency of the Phison E12 during the sustained random read test is decent, and the overall power consumption is only a bit higher than the Phison E8-based Kingston A1000. The only TLC SSD that's both faster and more efficient than the Phison E12 is the WD Black, which just barely faster.

The random read speed of the Phison E12 scales up nicely as queue depths increase, and the power consumption doesn't get out of hand. By QD32 a few TLC drives are a bit ahead of the Phison E12, but the only big performance gaps are relative to the MLC SSDs and the Intel Optane SSD.

Random Write Performance

Our test of random write burst performance is structured similarly to the random read burst test, but each burst is only 4MB and the total test length is 128MB. The 4kB random write operations are distributed over a 16GB span of the drive, and the operations are issued one at a time with no queuing.

Burst 4kB Random Write (Queue Depth 1)

The Phison E12 sets a new record for burst random write performance, improving slightly over the WD Black that formerly held a wide lead.

As with the sustained random read test, our sustained 4kB random write test runs for up to one minute or 32GB per queue depth, covering a 64GB span of the drive and giving the drive up to 1 minute of idle time between queue depths to allow for write caches to be flushed and for the drive to cool down.

Sustained 4kB Random Write

On the longer random write test, the Phison E12 is in a multi-way tie for second place, slightly behind the WD Black.

Sustained 4kB Random Write (Power Efficiency)
Power Efficiency in MB/s/W Average Power in W

The Phison E12 matches the Samsung 970 EVO for power efficiency on the sustained random write test. The WD Black and Toshiba XG5 both have significantly better power efficiency with the same NAND. The WD Black is faster while drawing a bit less power, while the XG5 is significantly slower but also much less power-hungry.

Even though quite a few drives turned in very similar performance scores for the average of QD1-QD4, the actual performance scaling curves vary quite a bit. The Phison E12's random write performance is very good at QD1 and QD2, but at higher queue depths many drives overtake it and saturate at a much higher speed.

AnandTech Storage Bench - Light Sequential Performance
Comments Locked

28 Comments

View All Comments

  • Tastydirt - Sunday, August 5, 2018 - link

    Not necessarily, depending on workload. A drive like this will read/write 4-8x faster than a SATA drive, allowing it to drop back into idle state much faster. This would probably result in lower total power consumption per byte read.
  • DanNeely - Wednesday, July 18, 2018 - link

    looks like a solid design to me, no bad results anywhere and optimizing for low latency over peak throughput in consumer scenarios is probably the better choice.
  • takeshi7 - Wednesday, July 18, 2018 - link

    I wish they kept the flip chip BGA design of the E7. It just looks cooler with the exposed die.
  • imaheadcase - Wednesday, July 18, 2018 - link

    Plan on admiring it inside case huh?
  • FATCamaro - Wednesday, July 18, 2018 - link

    He’s going to watch all those bits moving around the chip.
  • Alistair - Wednesday, July 18, 2018 - link

    A nice new possibility, but like the HP drive surprised me when I opened it, the Phison is double-sided unfortunately. I'd rather not buy Samsung, but Samsung being single-sided is a big plus.
  • imaheadcase - Wednesday, July 18, 2018 - link

    A big plus for what?
  • DanNeely - Wednesday, July 18, 2018 - link

    compatibility with laptops that don't have enough Z height for a 2 sided m.2 card.
  • romrunning - Thursday, July 19, 2018 - link

    It can also help with the cooling, if the controller is being impacted by higher thermals. The board-facing side may not have enough space to add even a small heatsink. Single-sided M.2 drives can benefit from placing the heatsink on the top side, along with whatever better airflow there may be the top side as well.
  • siuol11 - Wednesday, July 18, 2018 - link

    I really wish someone besides Samsung would make a "performance" drive with MLC, I'm not interested in using a TLC drive for a windows install. AFAIK there are no direct competitors to Samsung's Pro drives, and the prices have consequently continued to stay high.

Log in

Don't have an account? Sign up now