AnandTech Storage Bench - Heavy

Our Heavy storage benchmark is proportionally more write-heavy than The Destroyer, but much shorter overall. The total writes in the Heavy test aren't enough to fill the drive, so performance never drops down to steady state. This test is far more representative of a power user's day to day usage, and is heavily influenced by the drive's peak performance. The Heavy workload test details can be found here. This test is run twice, once on a freshly erased drive and once after filling the drive with sequential writes.

ATSB - Heavy (Data Rate)

Our initial runs of the Heavy test on the Samsung 970 EVO produced results similar to the Samsung PM981, with the 1TB model showing worse performance on an empty drive than a full drive. This seems to be related to the secure erase process used to wipe the drive before the test. Like many drives, the 970 EVO seems to lie about when it has actually finished cleaning up. Adding an extra 10 minutes of idle time before launching the Heavy test produced the results seen here, and in the future all drives will be tested with longer pauses after erasing (all other drives were given at least two minutes of idle time after each erase).

With the odd behavior eliminated, the Samsung 970 EVO comes close to setting a new record on the Heavy test. The empty drive performance of the 1TB model is up in Optane territory, though the full drive average data rate is not much higher than other TLC-based drives. The 500GB model is far slower, and its full-drive performance doesn't even keep pace with the Intel SSD 760p.

ATSB - Heavy (Average Latency)ATSB - Heavy (99th Percentile Latency)

The average and 99th percentile latency scores from the Samsung 970 EVO are about normal and in line with its closest competitors, except for the particularly good empty-drive score from the 1TB 970 EVO.

ATSB - Heavy (Average Read Latency)ATSB - Heavy (Average Write Latency)

The average write latency of the 970 EVO is fairly typical for a high-end NVMe SSD, but the average read latency of the 1TB 970 EVO in the best case is surprisingly quick. Both capacities show a larger than normal gap between empty and full drive performance, even after accounting for the fact that they are using TLC to compete against the best MLC drives.

ATSB - Heavy (99th Percentile Read Latency)ATSB - Heavy (99th Percentile Write Latency)

The 99th percentile read latency scores from both tested capacities of the 970 EVO show a big difference between full drive and empty drive performance. The 500GB drive's read QoS doesn't seem up to par, but the 1TB model's scores would look pretty good if the WD Black hadn't recently shown up with an MLC-like minimal performance loss when full. The 99th percentile write latency scores of the 970 EVO are good but not substantially better than the competition, and the 500GB model is clearly worse at keeping latency under control than the 1TB model or MLC drives of similar capacity.

ATSB - Heavy (Power)

The 500GB 970 EVO continues the trend of relatively poor power efficiency from the Samsung Phoenix controller, but the 1TB model in its best case of running the test on an empty drive is fast enough that its overall energy usage is comparable to good SATA drives.

AnandTech Storage Bench - The Destroyer AnandTech Storage Bench - Light
Comments Locked

68 Comments

View All Comments

  • jkresh - Tuesday, April 24, 2018 - link

    is a review of the HP EX920 coming?
  • Billy Tallis - Tuesday, April 24, 2018 - link

    Yep, I have a sample of that on hand. I haven't tested it yet so it'll be a few weeks while I run it and several other drives through the post-Meltdown/Spectre patched testbed.
  • Luckz - Tuesday, April 24, 2018 - link

    You write that you use Windows drivers instead of manufacturer ones, but elsewhere I hear complaints that the PM981 isn't a very useful buy because it requires drivers that aren't even available to the public, only to OEMs. Wouldn't it make sense to also try these with Samsung drivers especially if they're being compared to the PM981 all the time?
  • Billy Tallis - Tuesday, April 24, 2018 - link

    The PM981 doesn't require any special drivers. It's just another standard NVMe SSD.
  • HStewart - Tuesday, April 24, 2018 - link

    I am curious what kind of performance would I see replacing the Hyrix 512G in my Dell XPS 15 2in1 with a 1G or possible 2G in a year.
  • Drazick - Tuesday, April 24, 2018 - link

    Why do we need M.2 in desktop computer?
    Why should we live with this thermal compromise?

    We want SATA Express / U2 drives.
  • Cooe - Tuesday, April 24, 2018 - link

    Yuck and yuck. SATA Express is 1/2 the speed, and a completely stillborn interface, and the cable dependant huge waste of space 2.5" U2 makes next to no sense outside the data center. The M.2 form factor has countless innate
    advantages over both those and any of it's potential thermal issues are easy & cheap to solve if you're particular setup happens to be vulnerable to their occurrence.

    Not only have Samsung's copper heatsink labels reduced the problem significantly w/o any user action, but most good current motherboards have included M.2 heatsinks and even for those that don't, they can be purchased online for ridiculously cheap.

    Now find me something braindead simple to install & use for just a couple $ that can make SATA Express twice as fast and actually used in drives, or make U.2 cableless and a fraction of a standard 2.5" drive's size. There isn't any.
  • medoogalaxy - Wednesday, April 25, 2018 - link

    superpower ssd
  • shatteredx - Wednesday, April 25, 2018 - link

    Which is more important for “snappiness,” 4K random qd1 read or write?
  • sjprg2 - Wednesday, April 25, 2018 - link

    Just because I hate the sata cables I now have all M.2 Samsungs installed either in the M.2 slots or on the PCIE plugin adapters. This also allows all of the trays to be removed from the chassis letting the front panel fans blow straight onto the motherboard and plugins.

Log in

Don't have an account? Sign up now