Overclocking

Finally, let’s spend a bit of time looking at the overclocking prospects for the GTX 780 Ti. Although GTX 780 Ti is now the fastest GK110 part, based on what we've seen with GTX 780 and GTX Titan there should still be some headroom to play with. Meanwhile there will also be the matter of memory overclocking, as 7GHz GDDR5 on a 384-bit bus presents us with a new baseline that we haven't seen before.

GeForce GTX 780 Ti Overclocking
  Stock Overclocked
Core Clock 876MHz 1026MHz
Boost Clock 928MHz 1078MHz
Max Boost Clock 1020MHz 1169MHz
Memory Clock 7GHz 7.6GHz
Max Voltage 1.187v 1.187v

Overall our overclock for the GTX 780 Ti is a bit on the low side compared to the other GTX 780 cards we’ve seen in the past, but not immensely so. With a GPU overclock of 150MHz, we’re able to push the base clock and maximum boost clocks ahead by 17% and 14% respectively, which should further extend NVIDIA’s performance lead by a similar amount.

Meanwhile the inability to unlock a higher boost bin through overvolting is somewhat disappointing, as this is the first time we’ve seen this happen. To be clear here GTX 780 Ti does support overvolting – our card offers up to another 75mV of voltage – however on closer examination our card doesn’t have a higher bin within reach; 75mV isn’t enough to reach the next validated bin. Apparently this is something that can happen with the way NVIDIA bins their chips and implements overvolting, though this the first time we’ve seen a card actually suffer from this. The end result is that it limits our ability to boost at the highest bins, as we’d normally have a bin or two unlocked to further increase the maximum boost clock.

As for memory overclocking, we were able to squeeze out a bit more out of our 7GHz GDDR5, pushing our memory clock 600MHz (9%) higher to 7.6GHz. Memory overclocking is always something of a roll of the dice, so it’s not clear here whether this is average or not for a GK110 setup with 7GHz GDDR5. Given the general drawbacks of a wider memory bus we wouldn’t be surprised if this was average, but at the same time in practice GK110 cards haven’t shown themselves to be as memory bandwidth limited as GK104 cards. So 9%, though a smaller gain than what we’ve seen on other cards, should still provide GTX 780 Ti with enough to keep the overclocked GPU well fed.

Starting as always with power, temperatures, and noise, we can see that overclocking GTX 780 Ti further increases its power consumption, and to roughly the same degree as what we’ve seen with GTX 780 and GTX Titan in the past. With a maximum TDP of just 106% (265W) the change isn’t so much that the card’s power limit has been significantly lifted – as indicated by FurMark – but rather raising the temperature limit virtually eliminates temperature throttling and as such allows the card to more frequently stay at its highest, most power hungry boost bins.

Despite the 95C temperature target we use for overclocking, the GTX 780 Ti finds its new equilibrium point at 85C. The fan will ramp up long before it allows us to get into the 90s.

Given the power jump we saw with Crysis 3 the noise ramp up is surprisingly decent. A 3dB rise in noise is going to be noticeable, but even in these overclocked conditions it will avoid being an ear splitting change. To that end overclocking means we’re getting off of GK110’s standard noise efficiency curve just as it does for power, so the cost will almost always outpace the payoff on a relative basis.

Finally, looking at gaming performance the the overall performance gains for overclocking are generally consistent. Between our 6 games we see a 10-14% performance increase, all in excess of the memory overclock and closely tracking the GPU overclock. GTX 780 Ti is already the fastest single-GPU card, so this only further improves its performance lead. But it does so while cutting into whatever is above it, be it the games where the stock 290X has a lead, or multi-GPU setups such as the 7990.

Power, Temperature, & Noise Final Words
Comments Locked

302 Comments

View All Comments

  • IUU - Friday, April 18, 2014 - link

    Can someone explain to me the logic of setting the game at 4x antialiasing while playing at 2560x1440?
    Because I can't find any.
  • naseruddin - Tuesday, July 29, 2014 - link

    Looks like Anand is more Fan of a AMD rather than Nvidia i can understand that, but check the game bench markings on 780Ti after market cards it kills AMD 290x, i dont understand one thing if game bench marking is all about then i have GTX550ti 1 GB DDR5 runs ultra settings for Sniper Elite 3, Far Cry 3, AC3, AC4 , Sky Rim, the reason is simple and obvious that Nividia has & AMD dosent -- PhysX Software with the Chip on the card it self, i know many of you might be thinking hey even AMD cards utlize PhyX but remember not with right hardware. AMD is Good a CPUs not GPUs. one more interesting point in every 6 out of 10 games splash screen as "Nvidia the way it meant to be played" i have hardly seen any game that says AMD Radeon the way its meant to be played lol. Something to think about, in conclusion Nvidia is for a premium segment the pricing speaks, why else would you pay more price, because Nvidia is confident on their quality, on the other hand competitors go for desperate selling, which puts doubts in you brain.

Log in

Don't have an account? Sign up now