Platter density has been the crutch of hard drive makers in recent history. Increasing spindle speeds can reduce random access latency, but at the expense of cost and thermals. Improvements in random access performance via increasing spindle speed pale in comparison to what is possible with solid state storage, not to mention that driving motors at speeds beyond 10,000 RPM becomes quite difficult. The focus on increasing platter density is also difficult, but higher density platters can actually lead to reductions in power consumption rather than the opposite (through a reduction in the number of platters per drive). There's also the fact that if you can cram more data on a single platter there's a direct impact on sequential accesses.

Yesterday Seagate announced its transition to 1TB platters with its new 7200RPM-only Barracuda line. The move marked a significant change for Seagate as it is phasing out the Barracuda Green brand, and shifting the focus of the high-performance Barracuda XT. The Barracuda Green was a rebrand of Seagate's Barracuda LP, designed to convey the lower power consumption enabled by its 5900RPM spindle speed.

Seagate decided that the performance loss of moving to 5900RPM wasn't justified by the power savings. It believed that by introducing a more power efficient 7200RPM drive it could deliver the best of both worlds, negating the purpose of the Green line. For most desktops, Seagate has a point. The couple of watts you save by slowing down the motor aren't really realized in a system that idles at 60W and can consume over 100W under load. On the other hand, the performance drop is definitely noticeable. Hard drives have pretty bad random access performance to begin with, and slowing spindle speed isn't going to help:

Impact of Rotational Speed on Random Access Performance - Barracuda vs Green
  7200RPM 5900RPM
4KB Random Write Performance (8GB LBA) 1.20 MB/s 0.90 MB/s

Random write performance goes up by almost 20% when you compare the Barracuda XT to the Barracuda Green. Performance in this test is mostly governed by spindle speed (and firmware), so it makes Seagate's case perfectly.

There is a segment that Seagate isn't considering as it decides to axe the Green line: the home server market. If you're doing mass archival to some external storage, random performance is likely not a big concern. Instead, all you want is cheap, low-power storage.

Come February 2012, if you want a Green drive, you'll have to shop with Western Digital.

At the other end of the spectrum, the Barracuda XT has been Seagate's performance flagship. This brand isn't going away. Instead Seagate will introduce a solid state hybrid drive under the Barracuda XT banner at some point in the future.

Everything else now falls under the bare Barracuda label. High capacity drives should become more power efficient thanks to a reduction in the number of platters, and performance should go up thanks to increased platter density.

The new 1TB platter drives all carry the M001 suffix to their model numbers:

Seagate's 1TB-per-platter Barracuda Lineup
Model Number Capacity MSRP
ST3000DM001 3TB $179.99
ST2000DM001 2TB $105.99
ST1500DM001 1.5TB $83.99
ST1000DM003 1TB $71.99

Seagate sent along a new 3TB Barracuda for us to put through the paces.

The Performance

With lower power consumption in mind, Seagate is now using a 40nm dual-core LSI controller on the 1TB-platter Barracudas. The chip is physically a lot smaller than what was used in the original 3TB Barracuda XT:

Seagate continues to use 64MB of DDR2-800 as the Barracuda's DRAM cache.

The big news is obviously the platter count with the new 3TB Barracuda. While the previous drive used five platters, the new 3TB drive only uses three. It's this reduction that Seagate hopes will give it the performance and power advantages necessary to not only move the family forward, but render the outgoing Green redundant.

To find out, we threw some of our storage suite at the drive and compared it to the old Barracuda XT and Green drives. I also ripped the drive out of Seagate's 4TB GoFlex Desk enclosure, a 5-platter Barracuda XT, and included it in the comparisons.

Iometer - 4KB Random Write (QD=3, 8GB LBA)

Random write performance actually dropped a bit compared to the older Barracuda XT. It's still higher than the Green drive, but it looks like Seagate has tweaked the drive's firmware a bit resulting in lower random write performance.

Iometer - 128KB Sequential Read

Iometer - 128KB Sequential Write

Sequential performance is up a bit over the original 3TB Barracuda XT, but about in-line with what we'd expect from a modern day high-capacity drive. Even compared to the latest 4TB Barracuda XT, we see a slight increase in performance.

Despite the sequential performance advantage, PCMark 7 showed the new Barracuda on-par with the Barracuda XT:

PCMark 7 - Secondary Storage Benchmark

I ran the drives through our light and heavy 2011 workloads from our SSD reviews (which takes absolutely forever to run on mechanical drives) and saw some interesting data:

AnandTech Storage Bench 2011 - Light Workload

AnandTech Storage Bench 2011 - Heavy Workload

The Barracuda XT was consistently faster than the new 3TB Barracuda in our trace based benchmarks. Keep in mind that both of these tests were created on and for SSDs. Both tests involve a much heavier usage pattern and demand ultra quick response time, likely giving these hard drives an extremely strenuous workout. While the new Barracuda is faster than the outgoing Green, it seems as if the firmware isn't quite as tuned for performance as the XT. The difference does make sense, particularly if it translates into lower power usage given the new mainstream focused Barracuda lineup.

Drive Power Consumption - Idle

Drive Power Consumption - Sequential Write

Power consumption is obviously lower than the old Barracuda XT, but still not quite as low as a 5400RPM Barracuda Green or WD Caviar Green. If you were expecting the new Barracuda to completely replace the outgoing Barracuda Green you will be disappointed. It looks like if you need a high capacity, low power 3.5" drive going forward it won't be from Seagate.

Final Words

The new 3TB Barracuda is a bit faster in sequential performance than the old Barracuda XT, at lower power consumption. In typical desktop workloads I think it's fairly safe to say that you wouldn't notice the difference between the Barracuda and Barracuda XT.

As our SSD tests showed us however, when really pushed the new Barracuda performs somewhere in between the old Green and the XT. Seagate appears to have optimized the drive's behavior for lower power rather than peak performance. If you want the absolute best performance out of a 3.5" drive, stick with the XT or wait for the new hybrid version.

Given the tremendous advantage SSDs offer over even the fastest 3.5" drives, I'm personally ok with the performance tradeoff under very heavy load so long as you've got an SSD somewhere in your system as well. I'm not sure I particularly agree with Seagate's decision to abandon the 5900RPM drive market, but thankfully there are other options available if you want a high capacity, lower power drive.

POST A COMMENT

75 Comments

View All Comments

  • sduguid - Tuesday, November 08, 2011 - link

    There's really not much point in going back and forth on this any further. I have a large number of drives in active service and I do not see the issues you are referring to.

    The 7200.11 family was largely skipped over and I am perfectly willing to agree that it may have been problematic. As I said earlier, there is likely a reason they replaced that family so quickly. I used few of them. 7200.12 I have found to be rock solid.

    Everyone has their preferences and we're not going to convince each other to change so I think we can agree to disagree.

    By the way, it is possible that I will start to see abnormal issues or failures with the 7200.12 series but I'm simply saying that I have not to this point.
    Reply
  • JHBoricua - Thursday, November 10, 2011 - link

    You can buy the 2TB drive for a cool $289.00

    http://www.newegg.com/Product/Product.aspx?Item=N8...
    Reply
  • mikbe - Sunday, May 20, 2012 - link

    I wonder if the target audience is people that use an SSD as their primary drive but want a moderately fast second data drive. Something they can use for: storing infrequently used files, a scratch disk, Internet browser temp files, Microsoft's virtual memory, and other activities that write a lot of tiny temporary files that will decrease the life of an SSD.

    They want a middle of the road drive that will be reliable and fast but they don't need a 10,000RPM drive that will die in a year and uses as much energy as a small hamlet or a 5,400RPM Eco drive that takes forever to transfer data back and forth.
    Reply
  • UltraTech79 - Sunday, April 21, 2013 - link

    Hmm no dB measurements? C'mon.. Reply
  • n13L5 - Saturday, June 29, 2013 - link

    One would really wish Anandtech and everybody else would vastly reduce the role of speed benchmarks in their tests for hard drives...

    Instead, give some room to figure out likely reliability and at least quote MTBF, if its rated for 24/7 operation or 8 hours/5days a week etc...

    Reliability, heat and noise far outweigh any speed considerations since we have SSDs.

    Its a huge drag to slog through review after review, being presented with the same benchmark charts that are very close to irrelevant now. They should at most occupy 1/4 of a review.
    Reply

Log in

Don't have an account? Sign up now