Antec Noise Levels and Efficiency

Sound Pressure Level
Load dB(A)
10% 18
20% 18
50% 20
80% 23
100% 27
110% 32

At high loads, Antec is louder than OCZ, but they are very similar overall. When you play games (one of the few times you would be likely to come anywhere near the 550W output), the noise isn't that important anyway, as the GPU/CPU fans are also more audible. The silence at low loads is crucial, and both the OCZ and Antec units do well.

Efficiency and PFC

230VAC, 50Hz
Load Efficiency PFC
10% 78% 0.852
20% 84% 0.907
50% 88% 0.933
80% 87% 0.948
100% 86% 0.956
110% 85% 0.958

 

115VAC, 60Hz
Load Efficiency PFC
10% 78% 0.957
20% 84% 0.973
50% 86% 0.988
80% 84% 0.989
100% 83% 0.995
110% 82% 0.993

As expected, the Antec is more efficient than OCZ, and the Techsolo is well behind the pace set by 80 Plus. The efficiency and power factor could still be better at low load (for example, Seasonic achieved more than 80% at 10% load), but both are good enough for 80 Plus Bronze and there's not much to complain about.

Antec Voltage Regulation and Quality You Get what You Pay for!
POST A COMMENT

82 Comments

View All Comments

  • Phaedrus2129 - Friday, October 29, 2010 - link

    Except guess what, PC Power & Cooling was bought by OCZ in 2007, and in 2010 they discontinued the Silencer and Turbocool lines permanently, and replaced them with the "Silencer Mk. II" line. It's the same thing as OCZ's "Z-Series Gold", only cost-down with some last minute jerry-rigged fixes that belie the half-arsed engineering involved, sold for half again as much as the superior OCZ counterparts.

    Proof that relying on a brand remaining consistently good for all time is a bad idea.
    Reply
  • tomoyo - Friday, October 29, 2010 - link

    Not sure where you've been, but pc power has been THE posers for a long time now. They got bought out as phaedrus just mentioned by OCZ years back and haven't made a great psu in many years. Reply
  • Beenthere - Friday, October 29, 2010 - link

    You need to know which PC Power and Cooling PSUs to purchase and they aren't the pseudo OCZ models. Reply
  • tomoyo - Friday, October 29, 2010 - link

    Uh what, an old ass turbocool 860 or 1200 that's massively overpriced, very loud, and overhyped...and also old as hell?
    I would never recommend PC Power to any modern computer user right now. Any high end Seasonic would blow it out of the water 15 different ways.
    Reply
  • Beenthere - Friday, October 29, 2010 - link

    Knowledge is power...

    http://www.hardwaresecrets.com/article/PC-Power-an...
    Reply
  • tomoyo - Friday, October 29, 2010 - link

    Uh that is exactly a pseudo ocz model. Reply
  • tomoyo - Friday, October 29, 2010 - link

    Also see the following review conclusion for why the silencer Mk II disappoints - http://www.hardocp.com/article/2010/08/10/pc_power... Reply
  • mattll - Wednesday, November 03, 2010 - link

    This review highlights what I think is the weakness of these PSU reviews.

    First, there's the issue of silly ripple testing. There is a spec for ripple. If you are inside the spec, that is good enough. There is nothing superior about having less ripple, it is a design choice. Sure, you can measure it on your o-scope, but show me ANY affect on system performance as long as the PSU is inside the spec. There is none. All the rest is an assumption, unsupported by any data, that designing to a smaller ripple somehow indicates better performance. Prove it, in the system outside the PSU. In the absence of such proof, I think such tests are simply means by which reviewers can assign bogus performance metrics to parts which are simply good enough, to satisfy perfectionists who want proof that their choice is superior.

    Second, there's the disassembly of the unit and the smug remarks on build quality, with copious amounts of electrical engineering jargon. That jargon exists only to convince the reader the reviewer is knowledgeable.

    That's good to know, but it doesn't make the reviewer or the review correct. All the snarky comments about how some unit doesn't meet the reviewers exalted standards for solder quality or cap ESR is puerile, useless crap. Look: can you _measure_ something wrong? If so, comment on that instead. Is the reviewer assuming his exalted standards will play out in the reliability or performance of the product? Prove it!

    The measures of output noise, efficiency, ability to carry full load, withstand hot conditions: those are valuable pieces of information. Cost is of course important. Even ripple measurements are fine, as long as you understand that inside the standard there's no difference. Build quality, though, is a subjective measurement very poorly linked to any data on reliability. If reviewers can't be bothered to find anything more substantive on reliability, they should at least have the humility to recognize the limitations of build quality observations and not be too dogmatic about it.

    With regard to this PCPC review, the reviewer seemed to fixate on a production mod capacitor jumpered rather than designed into the circuit board. Boohoo, cry me a river. Did it make any performance difference? If the reviewer hadn't opened the case, was there any actual functional difference? Is there any data, any data at all to indicate such a jumpered capacitor would be any less reliable? Chances are, many customers would actually get the next rev circuit board with the cap in place. At any rate, the generous warranty meant the manufacturer was putting its money behind it. Likely each jumpered unit was subjected to more rigorous testing because of the custom work.

    In short, the whole review obsessed on silly, subjective details while acknowledging the performance was fine. If they thought the unit was overpriced relative to performance, that would be fine, but that wasn't their complaint. The reviewer was probably biased because of his previous experiences with PCPC, but that's the danger of subjective metrics.

    Disclaimer: I don't work in the PSU industry, although I have a degree in that area. I don't own or have any vested interest in any of those products.
    Reply
  • Calin - Friday, October 29, 2010 - link

    Bought an 350W, 12 cm fan Seasonic power supply for some $100, in the times when the Athlon 4600+ (dual cores) were the mainstream from AMD - maybe three years ago, maybe more.
    Very happy I've been with it
    Reply
  • sprockkets - Friday, October 29, 2010 - link

    No mention of the weight of the power supplies? That's usually a dead giveaway. Reply

Log in

Don't have an account? Sign up now