The Pentium 4 has come a long way since its introduction in the Fall of 2000. It went from being a laughable performer, to a CPU embraced by the community. Today Intel is extending the Pentium 4 family with the third major revision of the chip – codenamed Prescott.

Back when Prescott was nothing more than a curious block on Intel’s roadmap, we assumed that history would repeat itself: Intel would move to a smaller, 90nm process, double the cache and increase clock speeds. Intel has always historically behaved this way, they did so with the Pentium III and its iterations, and they did so with the first revisions of the Pentium 4. What we got with Prescott was much more than we bargained for.

Intel did move to a 90nm process, but at the same time didn’t produce a vastly cooler chip. Intel did double the cache, but also increased access latencies – a side effect we did not have with Northwood. Intel also moved to Prescott in order to increase clock speeds, however none of those speeds are available at launch (we’re still no faster than Northwood at 3.2GHz) and Intel did so at the expense of lengthening the pipeline; the Prescott’s basic Integer pipeline is now 31 stages long, up from the already lengthy 20 stages of Northwood. With Prescott, many more changes were made under the hood, including new instructions, some technology borrowed from the Pentium M and a number of algorithmic changes that affect how the CPU works internally.

If you thought that Prescott was just going to be smaller, faster, better – well, you were wrong. But at the same time, if you view it as longer, slower, worse – you’re not exactly on target either. Intel has deposited a nice mixed bag of technology on our doorsteps today, and it’s going to take a lot to figure out which side is up.

Let’s get to it.

Pipelining: 101
POST A COMMENT

103 Comments

View All Comments

  • TrogdorJW - Tuesday, February 03, 2004 - link

    Technically, it depends on how you cound pipelines. The P4 has several "simple" pipelines that deal with the easy instructions, and then "complex" pipelines that deal with the more difficult instructions.

    For example, they have two Integer units running at twice the core clock speed, but those only do simple integer instructions. Then they have a complex Integer unit running at core speed that can do the remaining integer instructions. So that's 3 INT units, technically, and two of those are double-pumped, so you could even call it five INT units if you want to be generous.

    The FP/SSE is somewhat similar, I believe. The end result is that it's not an apples-to-apples comparison between Intel and AMD pipelines. You could really say both of them have nine different execution units (pipelines), but Intel's pipelines aren't as powerful as AMD's when compared directly. See: http://www.tomshardware.com/cpu/20040201/prescott-... - there is an image of the pipelines in the Prescott, which is mostly unchanged from the Northwood.

    The thing with the number of stages in a pipeline still holds true. So you have 60 million transistors in 7 pipelines, each with 31 stages. (Actually, the FP pipelines probably have more stages.) That still gives you a rough guess of 275000 transistors in each pipeline stage. In the P4, it was 30 million transistors in 20 stages and still 7 pipelines, giving a guess of 215000 transistors per stage.

    I'm really, REALLY curious as to what Intel is doing. For some reason, the core of the P4 in the Prescott is at least twice as big (in transistor count) as the core of the Northwood. The L2 cache is also twice as big. So we went from 29+26 million transistors in Northwood (core+L2 cache) to apparently something like 75+50 in the Prescott.

    If indeed there are 75 million transistors in the Prescott core, they *had* to increase the length of the pipelines to 30 or so stages to have any chance of running fast. However, you can't argue that the increase in transistors was necessitated by the increase in the number of pipeline stages! Why? Apparently, the Prescott has more transistors per stage, so in theory a Northwood would have actually scaled to *higher* clockspeeds than a Prescott!

    Intel is definitely not showing all of their cards on the table right now. I'm betting that they're trying to protect Itanium as long as they can. I guess we'll know sometime in the next year or so.
    Reply
  • KristopherKubicki - Tuesday, February 03, 2004 - link

    Check out Anand's Blog on x86-64 for Intel

    http://www.anandtech.com/weblog/index.html?bid=46

    Kristopher
    Reply
  • Pumpkinierre - Tuesday, February 03, 2004 - link

    Errata for #87 2nd paragraph: 'According to Ace's'- not Ace's but X-bit:

    http://www.xbitlabs.com/articles/cpu/display/presc...

    Thank you #89 although I didnt think the P4 had as many pipelines as you quote.
    Reply
  • INTC - Tuesday, February 03, 2004 - link

    http://69.56.255.194/?article=13959

    Hmmm - wouldn't that be exciting? P4 Prescott 3.2E GHz with XDR Rambus at 3.2 GHz PCI Express and 64-bit extensions at IDF - I wonder when Nventiv will have that in their new Cold Fusion systems?
    Reply
  • DerekBaker - Tuesday, February 03, 2004 - link

    On the most common way of counting the Athlon has 9 pipelines, the P4 7.


    Derek
    Reply
  • Pumpkinierre - Tuesday, February 03, 2004 - link

    Add "So to compensate the slower speed of shorter pipelines, they make them more numerous in a cpu eg 6-8 in Athlons cf. 3 in P4 (I believe)" to the middle of 1st paragraph Reply
  • Pumpkinierre - Tuesday, February 03, 2004 - link

    #82 There is more than one pipeline in a processor so you have to take that into account in your stage/No. of transistor calculations plus registers, buffers, stacks, MMX, SSE etc.. I also am not totally happy with the AT explanation of pipelines. Pipelines are just a way of guessing the correct answer so that idle cpu time can be put to good use. I thought the stages in a pipeline be it 10 or 20 were of the same complexity. Its just that the outcome of a longer pipeline had a lower probability of being correct due to the increased likelihood of more branch statements being present in a longer pipeline. But work in checking the correct outcome is less in a longer pipeline. Work is heat so smaller pipelines make more heat which lessens speed headroom while longer pipelines can run at higher speed but correct outcomes are less probable. So to compensate they use more pipelines. Paradoxically with Prescott they've increased the pipeline lenght but they have more heat so as far as I am concerned speed headroom is limited and I doubt they will get past 4Gig with the present cpu. The o'clocks so far bear this out, with stable bests at ~3.8GHz. This is as result of some physical problem with the 90 nm process. What they should have done is applied the tweaks to the Northwood 130nm core and they would have been heaps better off. Its doubtful whether the tweaks would have increased temperature but they would be getting 30 to 50% better calculating power from the cpu at the same core speed. Would'nt need to PR rate it, just call it a different name. Then they would have had more time to sort out the 90nm problem while keeping the consumer happy. As it is they are going to cop a lot of flak over this overbaked failure.

    I'm also not happy about this loss of latency in the caches. Even though i've abused large caches in the past, that was on the grounds of gaming software where i expected alot of cache misses by the cpu because of the unpredictable nature of operator driven gaming. But here they are saying the latency has increased (and tests measure this) no matter the application and the reason given by sites is the doubling in size of the cache. But when the P4 went from 256K L2 to 512k L2 and the A-XP(256K) to Barton(512K) or even A64 3000+(512K) and 3200+(1024K) no major increase in cache latency was reported- in fact often the opposite. According to Ace's the latency of the Prescott 16K data L1 cache is now close to that of the a64 L1 (64K data) 4 times its size and double the latency of the Northwood 9even though Intel says it is the same- but no figures)! Something weird's going on with this 90nm stuff.

    Reply
  • PrinceGaz - Tuesday, February 03, 2004 - link

    Hmmm... where to begin :)

    Okay, first of all I must say that was an excellent review overall and the background material covering all the architectural changes was nothing short of superb. I'll definitely re-read chunks of that whenever I need a refresher on various aspects of its design.

    Your overclocking results were very good, far better than those achieved by most other sites. However I think it was a bad idea for AnandTech to suggest a Prescott is a great overclocker based on the sample(s) they received from Intel. It would be better to wait until you've got some retail CPUs from other sources before making recommendations about buying it for overclocking as readers may not be so lucky as you were.

    Right, onto the tests... overall as I see it the Prescott is really pretty much on a par with the Northwood performance-wise for a given clock-speed. Its faster at some tasks by a small margin thats not significant, and slower at as many others by a similar small margin I wouldn't worry about. As such it won't matter to an average user whether they get a P4 3.4C or a P4 3.4E processor. Therefore everything that has been said comparing the Northwood to the A64 is still valid when comparing the Prescott to the A64 (at least at clock-speeds over 3GHz).

    As many others have commented, the omission of any mention at all of the thermal issues was nothing short of staggering. *Every* other major review I read at least said something about it and most of them had quite a lot to say about it. I did notice the occassional error in what they said such as at [H]ard where their Prescott was running at 1.5V which therefore invalidated their temperature readings but even on those sites where it was running at the correct voltage, heat was still an issue.

    Its quite possible the current version of the Prescott is a bit like AMD's first 130nm chip the Thoroughbred 'A' which also ran rather hot. Of course this is already supposed to be the third revision of the Prescott so whether they can make any further tweaks that will seriously reduce power requirements is debatable. If they can't then ramping up the speed up to 4GHz and beyond that in 2005 will be a major problem. The most conservative estimate based on current figures would be for a 4GHz chip to have a TDP of 130W though in reality thats likely to be closer to 150W. Even if improved cooling solutions are able to get rid of that much heat from the chip *and* the case, electricity isn't free so the cost of running it must be considered to.

    Finally about 64-bit support in the Prescott. It wouldn't surprise me if Prescott does have 64-bit support built into it which is currently disabled in much the same way Hyper-Threading was disabled in some Northwood cores. The only people who know for sure either work for Intel and arent saying, or are under NDA. It would be a blow to IA64 (and also in a way be seen as saying AMD was right) if Intel did suddenly enable x86-64 support so I doubt they'll do so unless the case becomes compelling. Theres no sign of that happening in the immediate future.
    Reply
  • KristopherKubicki - Tuesday, February 03, 2004 - link

    They put 30M extra transistors on there to confuse people. :(

    Kristopher
    Reply
  • TrogdorJW - Tuesday, February 03, 2004 - link

    Actually, Icewind, if they don't *have* to activate the 64-bit capability, then they're okay. I mean, activating 64-bit in x86 is basically the death toll for Itanium and IA-64. That would make some (*all*?) of the companies that have purchased and worked on IA-64 rather pissed, right?

    If Prescott does have 64-bit, it was just Intel hedging their bets. They would have started design on the new core 2 years ago, around the time when the full specifications of AMD64 were released. Intel couldn't know for sure what the final result of K8 would be, so they may have decided to start early, just in case.

    Like I said before, it's pure speculation at this point, but I figure adding 64-bit registers and instructions to x86 could be done with 10 to 15 million transistors "easily". I've basically figured out (as others have, apparently) that there are close to 30 million transistors that aren't accounted for in the Prescott. That's the size of the entire Northwood core (minus cache)! If you have a better idea of where these transistors were used, feel free to share it. :)
    Reply

Log in

Don't have an account? Sign up now